Whirlpool Awz 510 E Programme Chart Manual

							AWZ 510 E-AWZ 510/SE-AWZ 512 E-AWZ 512/SE-AWZ 475/S
 PROGRAMME CHART
5019 301 20200
Whirlpool is a registered trademark of Whirlpool USA
: optional / Yes : dosing required1)
For improved garment care, spin speed is restricted in these programmes.
The “wool” programme of this washing machine has been approved by The Woolmark Company for the washing of garments labelled as “machine washable”. Follow the instructions given on the label sewn on the garment and the instructions supplied by the washing-machine manufacturer. (Cert. no. M0402-M0403-M0404-M0405).
Programme
Tempe-rature
CareLabels
Max.Loadkg
Type of wash/Notes
- For temperature selection, respect the manufacturer’s recommendations on the care label
Detergents and additives
Special functions
Max.spinspeedrpm
Pre-wash
Mainwash
Softener
Startdelay
Dryingtime
Pre-wash
Intensiverinse
Rinsehold
EasyIroning
Variablespin
White CottonAntibacterial
75 - 90 °C
5.0
Normally to heavily soiled bed linen, table linen and underwear, towels, shirts etc. made of cotton and linen.At a temperature of 80°C or more, this programme eliminates bacteria, ensuring sanitization of your laundry. The bacteria removal efficiency has been tested following a similar methodology to the NF EN 13697 standard of Nov. 2001.

Ye s
 
—

Max.
Cotton
60 °C
5.0
30 - 40 °C
5.0
Synthetics
30 - 60 °C
2.5
Normally soiled blouses, shirts, overalls etc. made of polyester (Diolen, Trevira), polyamide (Perlon, Nylon) or blends with cotton.

Ye s
  
800
1)
Delicates
30 - 40 °C
2.5 Curtains and delicate clothing, skirts, shirts and blouses.

Ye s

—

—

500
1)
Wool
30 - 40 °C
1.0
Only woollens labelled with the Woolmark and identified as machine washable.This programme (40°C) is tested and approved by The Woolmark Company for handwashable wool.
—
Ye s

—— — — —

800
1)
Lingerie
——
2.5
Curtains and delicate clothing in wool or silk only washable in cold water.
—
Ye s

—— — — —

800
1)
Quickwash
35 °C
2.5
Outer clothing worn for short periods and made of cotton, polyester, polyamide and cotton blends.
—
Ye s

—— ——

Max.
Dailywash
40 °C
3.5 Slightly to normally soiled garments made of cotton and/or synthetics.

Ye s
 
—

Max.
Cold wash
——
5.0
Slightly soiled garments in cotton and/or synthetics washable only in cold water.
—
Ye s

—

—

—

Max.
Drying
30 °C
3.0
Drying can be carried out using the “Cotton“ programme (with dry laundry load of 3 kg) or the “Synthetics” programme (with dry laundry load of 1.5 kg).
———

—— ————
Rinse
——
5.0
Same as the last rinse and the final spin in the “Cotton” programme.
——

—

——

Max.
Drain/Spin
——
5.0
In this programme spinning is intensive. Same as the spin cycle in the “Cotton” programme.
———

—— —

Max.
This washerdryer is equipped with automatic safety functions which detect faults at an early stage and react appropriately, e.g.:A. “Service” indicatorB. “Clean Pump” indicatorC. “Water Tap Closed” indicatorD. “Door open” indicator
E. Programme selectorF. “Start” buttonG. “Variable spin” buttonT. “Drying time” buttonH. The programme sequence indicator 
/ Start delay time indicator
I. Optional function buttonsJ. “Start delay” button
H
BC
DA
EF G

I
JT
 
						

							5019 301 20200
Whirlpool is a registered trademark of Whirlpool USA
Add detergent as indicated on the front page and as 
described in the chapter “Detergent and Additives” 
in the Instructions for Use.
1. Turn the 
programme selector to the desired 
programme.
2. The indicator of the predefined 
spin speed
lights up; in case you want to set another spin 
speed, press the “Variable spin” button.
Press the button(s) of any required option(s) - the 
respective indicator lights up.
When the combination of programme and 
additional option(s) is not possible,
the indicators switch off automatically. Unsuitable 
combinations of options are deselected automatically.
“Prewash” button
• Only for heavily soiled loads (e.g. sand, granular dirt). 
Increases the cycle time by approx. 15 minutes.
• Do not use liquid detergent for the main wash 
when activating the prewash option.
“Easy ironing” button
• Can be used together with “Cotton”, 
“Synthetics” and “Dailywash” programmes to 
make ironing easier.
• Increases the water quantity and the clothes are 
spun very gently.
“Intensive rinse” button
• More water is added and the rinse cycle is 
prolonged.• This option is particularly suitable for areas with 
very soft water, washing baby linen, and helps 
people with allergies.
“Rinse hold” button
• The laundry remains in the last rinse water 
without the final spin cycle, to avoid creasing and 
prevent colours from changing.
• This option is particularly recommended for the 
“Synthetics”, “Dailywash” or “Delicates” 
programmes.
• It is particularly useful if you want to postpone 
spinning to a later time, or if you want to drain only.
• If you select “Rinse hold”, do not leave the 
laundry to soak for too long.
Note: The programme stops to “Rinse hold” at 
the time the “Rinse Hold” light in the programme 
sequence indicator is on. The indicator next to 
the
“Start”button flashes.
To terminate the “Rinse hold” option:
• Press the 
“Start” button; the programme will 
terminate automatically with the final spin cycle 
for the preset wash programme.
“ Variable spin” button
• Every programme has a predefined maximum 
spin speed.
• Press the button to set another spin speed.
• If spin speed “0” is selected, the final spin is 
cancelled but intermediate spin peaks remain 
during rinse. The water is drained out only.CONSUMPTION DATA
Programme
Temperature
(°C)
Load
(kg)
Wa t e r
(l)
Energy
(kWh)
Approx. programme duration
(hours : minutes)
*
White Cotton / Antibacterial 90 5.0 52
**1.70 2:10
Cotton 75 5.0 52 1.33 2:05
Cotton with “Eco”
***60 5.0 49 0.95 2:15
Cotton 40 5.0 62 0.51 2:00
Synthetics 60 2.5 46
**0.80 1:40
Synthetics 40 2.5 46 0.46 1:35
Dailywash 40 3.5 52 0.30 1:25
Quickwash 35 2.5 30 0.40 0:40
Delicates 30 2.5 54 0.24 0:45
Wool 40 1.0 56 0.44 0:54
Consumption values were measured in normalized conditions in compliance with standard IEC/EN 60 456. In domestic use, consumption data 
may vary with respect to the values in the table in relation to the water supply pressure and temperature, the load and the type of wash.
*The time indicated on the display (if present) can deviate from the values in the table, because it takes into account the household
conditions applicable at that time.
**To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the water out.
***Reference programme for energy label.ADD DETERGENTS, CLOSE THE DOOR 
AND SELECT THE PROGRAMMESELECT ANY DESIRED OPTION
Press the button to select the drying time, in 
automatic mode (at end of wash cycle) or in manual 
mode, selecting the “Drying” programme (with 
hand-washed laundry). In the latter case it is 
necessary to spin at a speed of at least 800 rpm. The 
set time is that indicated by the light on; when they 
are all off drying is not carried out.
The “Start Delay” option allows you to programme 
machine activation at a later stage, for example at 
night when electricity is cheaper. Do not use liquid 
detergent when activating the “Start delay”.
• Select the programme and options.
• Press the “Start Delay ” button to select 
programme start a delay time of 1 to 12 hours;
• Press the 
“Start” button. 
The indicator next to the 
“Start Delay ” button 
lights up, whereas the selection indicator flashes 
to signal the countdown of the remaining time.
• At the end of the delay time the machine starts 
the set programme. The LED indicating the 
wash stage in progress lights up.
• After pressing the 
“Start”, the number of hours 
preselected can be reduced by pressing and 
holding the “Start Delay ” button.
To cancel the “Start Delay ”:
Press the 
“Start Delay ” button until all the indicator 
lights are off. The selected programme will then start.
Open the tap and press the 
“Start”. The indicator 
next to the 
“Start” button lights up. The 
programme sequence indicator shows the current 
programme stage, running from left to right through 
Prewash/Wash, Rinse, Spin/Drain, End.
At the end of a programme, the 
“End” indicator 
lights up signalling that the door can be opened. As 
long as a wash programme is running, the door 
remains locked and must not be forced open. In 
case you have an urgent need to open it during a 
running programme, refer to “Cancel (Reset) a 
running programme before the end”.“Service” indicator
Lighting up of the “Service” indicator can be caused by 
a fault in an electrical component. Refer to the 
“Troubleshooting Guide” in the Instructions for Use; If 
the fault persists, contact our After-Sales Service.
“Clean pump” indicator
The water is not pumped out. Check whether the 
drain hose is kinked or the filter must be cleaned; in 
the latter case refer to the Instructions for Use 
(“Removing the filter”).
“Water tap closed” indicator
Machine water supply insufficient or lacking. Open 
the water tap; Turn the programme selector to 
“Off/0” and reset the programme. If the indicator 
remains on, refer to the “Troubleshooting Guide” in 
the Instructions for Use.
“Door open” indicator
Lighting up of the indicator could be caused by the 
door not being properly closed. Try closing it again. 
Turn the programme selector to “Off/0” and reset the 
programme. If the indicator remains on, refer to the 
“Troubleshooting Guide” in the Instructions for Use.
• Lighting up of the lamp on the wash sequence 
indicator means that the programme has ended 
and the door is unlocked.
1. Turn the programme selector to the “Off/O” 
position.
2. Close the water tap.
3. Open the door and unload the machine.
4. Leave the door ajar to allow the drum to dry.
1. Turn the programme selector to “Off/O”.
2. Select the new programme, any options and 
another spin speed if you want.
3. Press the
 “Start” button again. The new 
programme resumes the wash programme from 
where the previous one was interrupted. Do not 
add detergent for this programme.
• Reset by turning the programme selector to 
“Off/0” and select the “Drain Spin” programme 
to remove the water remaining in the bowl 
before the door can be opened.DRYING TIMESTART DELAYPROGRAMME START“DOOR OPEN” INDICATOR
RED INDICATORSPROGRAMME ENDCHANGING PROGRAMME AND/OR 
OPTIONS AFTER PROGRAMME STARTCANCEL (RESET) A RUNNING 
PROGRAMME BEFORE THE END
SM2426/02    Stampa TLF 21/09/2007       
461307266