Whirlpool Adp 4736 Ix Quick User Guide

							WH/II/B/GB
How to use the appliance
Further indications are given in the single chapters and in the user instructions.
Press the 
ON / OFF button.
(The first time you use the appliance 
and when using a different type of 
detergent)
1. Select the third programme from the 
top in the relative table.
2. Press the Start button for about 7 
seconds until the display changes.
3. Select the required detergent with 
the Start button (OFF = powder 
detergent, 2 in 1, 3 in 1, 4 in 1) (shown on the display).
4. Switch the appliance off and then switch it on again. The selected 
detergent type will be shown on the display for approximately 3 
seconds after switching on.
For dosage of powder detergent in compartment 
A and 
B refer to the 
programmes table.
Mechanical indicator lamp 
C.
Electric indicator on control panel (if provided).
On models with water softener 
system only.
Mechanical indicator lamp 
D. Electric 
indicator on control panel (if provided).
Refer to the dishwasher loading instructions.
The last programme selected will light up.
Select the desired programme (using the specific button or knob). 
The corresponding indicator lamp lights up.
If necessary (and if provided).
The corresponding indicator lamp lights up.
The selected programme is 
then memorised (even in the 
event of power failure).
- Only open the dishwasher if necessary 
(Warning: beware of hot steam).
- If the appliance is switched off during a 
wash cycle, when switched on again it 
will resume the cycle from where it was 
interrupted.
Only after the START button has switched off: Press the ON / 
OFF button. 
All the indicator lamps switch off.
Warning: When the door is opened steam comes out! 
Unload the appliance, starting from the lower rack.
Switch on the appliance
Select, save, and 
supply the detergent
ABC
Check the rinse aid level
Check the 
regeneration salt level
Load the racks
Close the dishwasher door, 
turn on the water tap
Select a programme
Select additional options
Press the Start button
“Change programme in progress”
Press the START button for 2 sec. until the 
Start indicator lamp switches off.
Select another programme and press the 
START button again.
Wash cycle
Switch off the appliance
Turn off the water tap,
unload the racks
 
						

							WH/III/GB
Dishwasher loading instructions and racks provided
Upper rack:depending on the model
Multi-purpose support (A): 1)
Depending on the position, for long-
handles utensils, cups and glasses. May 
be used in three different positions.
Crockery holders (B):
Depending on the position, for example 
plates, cups and long-stemmed glasses.
Revolving glass support (C): 
2)
Depending on the position, for example 
small or long-stemmed glasses.
Long-handled utensils (e.g. 
carving forks, knives) must be 
arranged with the sharp end 
facing in towards the appliance
.
Half Load:Load the upper rack (see description 
of Options).
Place the cutlery basket (D) in the 
upper rack.
Rack height adjustment 
(also when loaded):
•Lower adjustment: pull out the 
two rack handles outwards (E) 
and lower the rack.
Upper adjustment: pull the two 
handles (E) upwards until the rack 
clicks into place (Factory setting).
The rack must be level on both 
sides.
Removing the top rack to provide 
clearance for large items of 
crockery in the bottom rack:
Open the rack guide retainers (F) on 
the right and left and remove the top 
rack.
When the upper rack is in place the 
retainers must always be closed.
Lower rack:
Depending on the model with fixed or 
tilting plate holders (G).
Half Load:Load the lower rack (see description 
of Options).
Greater washing power, particularly 
for plates and saucepans.
Cutlery basket (J) or (H):Some models are provided with a grid 
(I) that can be fitted onto the cutlery 
basket to keep items separated. 
Cutlery basket (D), if provided, for 
appliances with half load only.
Sharp knives and forks that might 
cause injury must be placed in the 
cutlery basket with the sharp end 
facing downwards.
Only use dishwasher-proof crockery and dishes. Do not use the appliance for items not suitable for washing in a 
dishwasher, for example wooden items, aluminium, plastic utensils, tin, hand-decorated crockery (unglazed), silver cutlery.
Spare parts which are sold separately:
1) Multi-purpose support (A) - N. AMH 369 series.2) Revolving glass support (C) - N. WGH 1000 series.
FF
Retainer
closedRetainer
open
 
						

							WH/IV/GB
What to do if...
If a fault occurs, before contacting our After-Sales Service, make the following checks to try and remedy the problem (* see 
also the corresponding chapter in the user instructions).
ProblemCauseRemedy
The appliance is not 
working No water supply. Open the tap.
 The appliance does not load sufficient 
water. Clean the water supply tap filter.
 Ensure there are no kinks in the water hose.
 There is a power failure. Insert the plug into the mains socket.
 Press the Start button.
 Close the door.
 Check the safety circuit breaker.
 Starting the selected programme. The programme can be set to “0” to start.
If crockery is not 
perfectly dry Insufficient rinse aid.Increase dosage *.
 Residual water in cavities. Load crockery at an angle.
If crockery is not 
perfectly clean The water jet does not reach the 
crockery. Arrange crockery so that items do not touch each 
other. Load crockery upside down.
 Insufficient detergent. Follow recommended detergent dosage.
 Unsuitable programme. Select a more intense wash cycle.
 Spray arms blocked. The spray arms must be able to turn freely.
 Spray arm nozzles clogged. Remove any impurities obstructing the water flow *.
 Incorrect detergent/detergent too old. Use a good quality detergent.
Sandy or grainy 
residues Clogged filters. Check filters regularly/if necessary clean *.
 Filters incorrectly assembled. Insert the filter correctly *.
Colour of plastic parts 
faded Tomato/carrot juice, ... Depending on the material, if necessary use a 
detergent with a greater whitening power.
Deposits on crockery
Removable Streaks on the crockery/glasses. Increase the rinse aid dosage *.
 Streaks on glasses. Reduce the rinse aid dosage *.
 Layer of salt on crockery/glasses. Close the salt container lid properly *.
 Not removable Insufficient water softening, calcium 
deposits. Change water hardness setting, if necessary add salt *.
Opaque glasses/ glasses 
not sparkling Cannot be washed in the dishwasher. Use suitable glasses.
Rust on cutlery Not made of stainless steel.Use suitable cutlery.
Identifying appliance 
faults The START indicator lamp flashes.
 Indicator F... (if provided). Ensure the filter assembly is not clogged and that 
there is no interruption to the water supply 
(if necessary, clean the filters *). Start the programme 
again. Press the START button for 2 seconds, until the 
START indicator lamp switches off. Select a new 
programme and press the Start button again.
If after carrying out the above checks the malfunction persists or appears again, turn the appliance off and turn off the water 
supply tap, then call our After-Sales Service (see guarantee).
Before contacting our After-Sales Service, take note of the following:
 The nature of the fault
 The appliance type and model
 The service code (the number indicated on the adhesive rating plate) 
inside the door on the right-hand side.
 
						

							Whirlpool is a registered trademark of Whirlpool USA5019 396 98152
GB
ADP 4736Quick Reference Guide
Before using the dishwasher, read the user instructions!
WH/I/B/GB
(We reserve the right to make technical modifications)
Add regeneration saltOnly add regeneration salt immediately 
before starting a wash programme.
Add rinse aidTime and failure display
Indicates in hours the time remaining until the start 
of the wash cycle. Switches off when the 
programme starts and indicates the time remaining 
in hours and minutes. 
“F....” Identification of faults for service technician
“Delayed start” buttonThe wash cycle can be programmed to start after 1 - 
24 hours. With each successive touch of the button, 
the delayed start indicator increases by 1 hour, and 
after 24 returns to 00. Then press the Start button. 
The dishwasher will start at the set time.
“Half Load” buttonPossibility of only half loading the top and bottom 
racks. Select the required programme then press 
the “Half Load” button. The light comes on and 
goes off at the end of the programme. 
The “Half Load” function can be used with 
programmes marked with an 
*.
Antibacterial rinse4) 5)
This function adds an antibacterial rinse at the end of 
the wash cycle, thereby guaranteeing a perfectly 
clean and sanitized load. The lamp will light up when 
the function is activated. If the temperature is not 
maintained during the antibacterial cycle (e.g. if the 
door is opened and remains open for a long time), 
the lamp will start blinking to indicate that sanitation 
is not guaranteed.
1) Reference programme for energy label in compliance with 
EN 50242 regulations;
2) Refer to “User instructions“;
3) The data relevant to programmes are values obtained in the 
laboratory in conformity with Standard EN 50242. In practical 
use there may be time variations or leaps depending on 
different loads, function options, water temperatures or 
hardness and different power supply voltages.4) The bacteria removal efficiency has been tested by the 
Institut Pasteur de Lille (France), based on the NF EN 
13697 standard of November 2001.
5) These programmes can be used with the Antibacterial 
rinse option.
Programme selector knob
ON / OFF button
Start button
Switches “on” when the dishwasher is 
operating. Flashes when a fault occurs. Switches 
off at the end of the programme.
Indicators
Options3)
Programme chartDetergent2)Consumption3)
ProgrammesLoading instructionsABLitreskWhMinutes
Pre-RinsecoldCrockery to be washed later.--5.00.0210
Party Glass40°CLight soiling, for example glasses and cups.X-13.00.9097
Quickwash40°CLightly soiled crockery with no dried-on food.X-13.00.7030
Bio/Eco5) *)50°CNormally soiled crockery.X-13.01.3590
Eco1) 5) *)50°CNormally soiled crockery.XX16.01.05170
Daily5) *)60°CNormally or heavily soiled crockery.XX16.01.35120
Intensive5)70°CRecommended programme for heavily soiled 
crockery, especially suitable for pans and 
saucepans.XX17.01.65145
Important information for Test Laboratories:
For detailed information on the EN comparison test and other tests, contact the following address: “[email protected]”.