Whirlpool Adg 658 Ix Instructions For Use

13
INSTRUCTIONS FOR USE
BEFORE USING THE DISHWASHER/
CONNECTIONS
ELECTRICAL CONNECTION
PRECAUTIONS AND GENERAL 
RECOMMENDATIONS
HOW TO FILL THE SALT CONTAINER
HOW TO FILL THE RINSE AID DISPENSER
HOW TO FILL THE DETERGENT DISPENSER
CARE AND MAINTENANCE
39694623GB.fm  Page 13  Thursday, March 3, 2005  2:12 PM
Black process 45.0° 100.0 LPI 
 

14
BEFORE USING THE DISHWASHER/
CONNECTIONS
1. Removing the packaging and controls: 
After unpacking, make sure that the dishwasher is 
undamaged and that the door closes correctly. 
If in doubt, contact a qualified technician or your 
local retailer.
•Keep the packaging materials (plastic bags, 
polystyrene parts, etc.) out of reach of children, as 
they are potentially dangerous.
This dishwasher has been factory tested to ensure 
it functions correctly. 
Such testing may leave slight water marks that...

15
ELECTRICAL CONNECTION
1) For Great Britain only
Warning - this appliance must be earthed
Fuse replacement
If the mains lead of this appliance is fitted with a BS 1363A 13amp 
fused plug, to change a fuse in this type of plug use an A.S.T.A. 
approved fuse to BS 1362 type and proceed as follows:
1.Remove the fuse cover (
A) and fuse (
B).
2.Fit replacement 13A fuse into fuse cover.
3.Refit both into plug.
Important:
The fuse cover must be refitted when changing a fuse and if the fuse 
cover is lost the...

16
PRECAUTIONS AND GENERAL 
RECOMMENDATIONS
1. Packing 
The packing box may be fully recycled as 
confirmed by the recycling symbol .
2. Energy and water saving tips:
Do not rinse crockery under running water.
Always fully load the dishwasher before switching 
on.
If ecological energy sources are available, 
such as solar panel heating, heat pumps or 
centralised heating systems, the appliance may be 
connected to the hot water mains up to a maximum 
temperature of 60°C. Make sure the water inlet...

17
HOW TO FILL THE SALT CONTAINER
From a water hardness category of 1–2 (medium), before using the 
dishwasher, fill the salt container with regeneration salt (to find out the 
hardness level of water in your area, contact your local Water Board or 
check the last bill you received).
If the water hardness level does not correspond to position 3 on the 
selector (setting on delivery) or if the water hardness level changes:
Setting the correct water hardness level:
Set the water hardness by turning the...

18
HOW TO FILL THE RINSE AID DISPENSER
The rinse aid facilitates drying and prevents the formation of unsightly 
spots and streaks on crockery. Before using the dishwasher for the 
first time, fill the rinse aid dispenser. Only use rinse aids recommended 
for use in domestic dishwashers.
1.Unscrew the cap 
A by turning it counter-clockwise (see drawing).
2.Fill the dispenser with rinse aid up to the dotted line 
“max” 
(approx. 140 cc). 
Immediately wipe away any rinse aid spilt accidentally!
 This...

19
HOW TO FILL THE DETERGENT DISPENSER
Only use detergents recommended for use in domestic dishwashers.
Only fill the detergent dispenser prior to starting a wash
 
programme
 (see the Quick Reference Guide).
1.Press button 
C to open the cover.
2. How to fill the detergent dispenser.
Programmes with pre-rinse:
-Powder and/or liquid detergent: 
pour two thirds of the recommended dosage into the 
compartment (
A);
pour one third into the 
compartment (
B).
-Tablets: 
place a tablet in the 
compartment (...

20
CARE AND MAINTENANCE
Before cleaning or carrying out maintenance, switch off the appliance, 
disconnect the mains plug and turn off the water tap.
Cleaning the outside of the appliance:
To clean the outside of the appliance, use a neutral detergent and a 
damp cloth. 
Clean the control panel with a damp cloth only.
Do not use abrasive detergents.
Cleaning the inside of the dishwasher:
Regularly wipe the door seal and inside of the door with a damp cloth 
to remove any food residue.
Upper spray arm:...

21
CARE AND MAINTENANCE
Cleaning the filters:
1.Rotate the microfilter counter-clockwise (
E) and extract it (
F).
2.Push the central filter from below to extract it from the microfilter 
(
G).
3.Separate the filters (
I) and (
H), lightly squeezing the filter (
I) at the 
reference arrows on the part and extract the filter (
H).
4.Extract the central steel filter (
J).
5.Clean all the filters under running water
. 
Check that no impurities are left inside the dishwasher!
6.Reassemble the microfilter (...