Westinghouse Television VR-3215 User Manual

-1-
Contents
Safety and warnings.......................................................................................2-3
Introduction..................................................................................................4
Stand installation guide..................................................................................5
Installation....................................................................................................6-9
Remote...

-2-
SAFETY AND WARNINGS
IMPORTANT SAFETY INSTRUCTION
TO REDUCE THE RISK OF ELECTRIC SHOCK, DO
NOT REMOVE COVER (OR BACK).NO USER
SERVICEABLE PARTS INSIDE. REFER SERVICING
TO QUALIFIED SERVICE PERSONNEL.
RISK OF ELECTRIC SHOCK
DO NOT OPEN!CAUTION
CAUTION
The symbol indicates that dangerous
voltages  constituting a risk of electric shock
are present within this unit.
The symbol indicates that there  are
important operating and maintenance
instructions in the literaturaccompanying this
unit.
To reduce the...

-3-
High voltages are used in the operation of this television
receiver. Do not the cabinet.
Refer servicing to qualified service personnel.open
SAFETY AND WARNINGS
To prevent fire or electrical shock hazard, do not expose
the television receiver to rain or moisture.
Do not drop or push objects into the television cabinet
slots or openings. Never spill any kind of liquid on the
television receiver.
Do not block the ventilation holes on the back cover .
Adequate ventilation is essential to prevent failure...

x2 Resolution:
TV System:
Video Signal System:
Receiving Channel:
Horizontal definition (TV line)
16:9
NTSC
Cable :1-135/ Air: 2-69 (ATV&DTV)
x1 High-Definition Multimedia Interface (HDMI) Input
Audio Input x 3
Composite Video Input >=350x1
YCb(Pb)Cr(Pr) >=400 Video Input >=400x2
Input Power Voltage:
AC 100V-240V 50/60Hz
ATSC Digital system and NTSC Analog system
Headphone Outputx1
x1
Coaxial Output
x1
USB Input Aspect Ratio: Viewing Picture Size (diagonal)
Power consumption:
Audio Output Power (THD...

-5-
This STAND INSTALLATION GUIDE is provided to help you easily install the stand. Please carefully follow
Step 1 through Step 3.STAND INSTALLATION GUIDE
Open the box and find the parts
Open the box and find the following parts.
-   S tand x1 pc
-   S crew s x 4 p csPacking
Stand
Packing TVScrews
Stand
Place the Stand on the TV
1. Place the TV with the display side down
on a table or desk (flat, totally clean surface).2. P lace the Stand on the TV as s how n below.
Stand
Secure the Stand to the TV...

-6-
INSTALLATION
Front panel
REAR AV INPUT/OUTPUT
1:    Remote control sensor.
2:    Indicator LED :  GREEN       P O WER O N .
RED             STANDBY.
3:Side panel keys
1. SOURCE:
2. MENU:
3. CH+/CH-:
4. VOL+/VOL-:
5. STANDBY:Display the input source menu.
Display main MENU.
In TV mode, press "CH+" or "CH-" to
change the channel up and down. In MENU mode, press
"CH+" or "CH-" to select items in standby mode, press
"CH+" or "CH-" to turn on the TV.
Adjust...

-7-
INSTALLATION
STEPS:
PC
Be sure both the TV and computer are powered off.
1. Connect a VGA and audio cable.
2. Connect the power cord.
3. switch  to VGA mode.
4.Turn on the TV and
Turn on the PC.
PRESET MODE
1
2
3
4
5
6
7
8
9
10720*400
640*480
640*480
800*600
800*600
1024*768
1024*768
1024*768
1280*1024
1280*102470
60
75
60
75
60
70
75
60
7531.47
31.47
37.50
37.88
46.88
48.36
56.48
60.02
63.98
80.00
RESOLUTIONV.Freq.(Hz) H.Freq.(KHz)
HDMI 1AC INPUT
100-240V~50/60HzLRAV 1Pr
Y PbHEADPHONEPC AUDIO...

ANTENNA
Note:
Aerial connections:IEC(female).
Input impendance:75    unbalanced.
INSTALLATION
-8- 

-9-
INSTALLATION
AV EQUIPMENT
There are two HDMI ports located on the back of your TV. You can connect a Blu-ray player, DVD player, or other video
equipment through these ports.
There is one component (Y, Pb, Pr) and two composite (AV) video input located on the back of your TV. You can connect
a VCR, cable box, or other video equipment to these jacks.
Please see the diagram below. You may also need to refer to the owner's manual of the device that you are trying to connect.
To audio outputs
VIDEO...