Vivitek Projector D5380U User Manual

DLP Projector—User’s Manual 
Views of Projector Parts  
Front-right View 
2345678101119 
ITEM LABEL DESCRIPTION SEE PAGE: 
1.  Screw 
For ensure the lens position 
2.  Vertical lens shift Adjusts the image position vertically 18 
3.  Lens release button  Press the release button before removing the 
lens 11 
4.  Horizontal lens shift 
Adjusts the image position horizontally 20 
5.  IR receiver Receives IR signal from remote control 7 
6.  Lens Projection  Lens 
7.  Focus ring Focuses the projected image...

D
D
D L
L
L P
P
P  
 
  P
P
P r
r
r o
o
o j
j
j e
e
e c
c
c t
t
t o
o
o r
r
r —
—
— U
U
U s
s
s e
e
e r
r
r ’
’
’ s
s
s  
 
  M
M
M a
a
a n
n
n u
u
u a
a
a l
l
l  
 
 
 
Top view—On-screen Displa y (OSD) buttons and LEDs 
 
ITEM LABEL DESCRIPTION SEE 
PAGE: 
1.  MENU Opens and exits OSD menus 
2.   Navigates and changes settings in the OSD 
Quick Menu – For Keystone 
3.  ENTER 
Enter or confirm highlighted OSD menu item 
24 
4.  BLANK  Displays a blank screen and mutes audio 
5.   Navigates and changes...

DLP Projector—User’s Manual 
Rear view 
1234
56789 10 1112
1314
1516
17
18
19
20
21
22
2
324
252627
28
293031 
ITEM LABEL DESCRIPTION SEE PAGE: 
1.  VGA1  Connect a RGB cable from a computer or a video enabled device. 
2.  AUDIO IN 1 Connect the AUDIO cable from an input device. 
3.  VGA2  Connect a RGB cable from a computer or a video enabled device. 
4.  AUDIO IN 2  Connect the AUDIO cable from an input device. 
Note: Share with DVI & BNC audio input. 
5.  POWER Turns the projector on or off (main...

D
D
D L
L
L P
P
P  
 
  P
P
P r
r
r o
o
o j
j
j e
e
e c
c
c t
t
t o
o
o r
r
r —
—
— U
U
U s
s
s e
e
e r
r
r ’
’
’ s
s
s  
 
  M
M
M a
a
a n
n
n u
u
u a
a
a l
l
l  
 
 
–  5 –  
ITEM LABEL DESCRIPTION SEE PAGE: 
15.  VGA OUT  Connect the RGB cable to a display. 
 (Pass through by VGA1 only) 
16.  AUDIO OUT 
Connect an AUDIO cable for audio loop through. 
17.  BNC Connect a BNC cable from a computer. 
18.  IR receiver Receive IR signal from remote control. 7 
19.  SERVICE  For service use. 
20.  RS-232...

DLP Projector—User’s Manual 
Bottom view 
 
ITEM LABEL DESCRIPTION SEE PAGE: 
1.  Tilt adjustor  Rotate adjuster lever to adjust angle position.  17 
2.  Ceiling support holes  Contact your dealer for information on mounting the projector on a 
ceiling 
 
Note: 
When installing, ensure that you us
e only UL Listed ceiling mounts. 
For ceiling installations, use approved mounti ng hardware and M4 screws with a maximum 
screw depth of 6 mm (0.23 inch).  
The construction of the ceiling mount must be of a...

D
D
D L
L
L P
P
P  
 
  P
P
P r
r
r o
o
o j
j
j e
e
e c
c
c t
t
t o
o
o r
r
r —
—
— U
U
U s
s
s e
e
e r
r
r ’
’
’ s
s
s  
 
  M
M
M a
a
a n
n
n u
u
u a
a
a l
l
l  
 
 
Remote Control Parts 
 
 
Important: 
1.  Avoid using the projector with bright fluore scent lighting turned on. Certain high-frequency 
fluorescent lights can disrupt remote control operation. 
 
2. Be sure nothing obstructs the path between the  remote control and the projector. If the path 
between the remote control and the projector...

DLP Projector—User’s Manual 
— 8 — 
 
ITEM LABEL DESCRIPTION SEE PAGE: 
1.  Power OFF  Turns the projector off 13 
2.  DVI  Displays the DVI source selection 
3.  VGA Displays the VGA source selection 
4.  DP Displays the DisplayPort source selection 
5.  Up cursor /  
Keystone+ Navigates and changes settings in the OSD 
Quick Menu – For Keystone 
6.  ENTER 
Enters and confirms settings in the OSD 
7.  Right cursor  Navigates and changes settings in the OSD 
8.  Down cursor /  
Keystone- Navigates and...

D
D
D L
L
L P
P
P  
 
  P
P
P r
r
r o
o
o j
j
j e
e
e c
c
c t
t
t o
o
o r
r
r —
—
— U
U
U s
s
s e
e
e r
r
r ’
’
’ s
s
s  
 
  M
M
M a
a
a n
n
n u
u
u a
a
a l
l
l  
 
 
–  9 –  
Remote Control Operating Range 
The remote control uses infrared transmission to c ontrol the projector. It is not necessary to point 
the remote directly at the projector. Provided  you are not holding the remote perpendicular to the 
sides or the rear of the projecto r, the remote will function well with in a radius of about 7...

DLP Projector—User’s Manual 
— 10 — 
SETUP AND OPERATION 
Inserting the Remote  Control Batteries  
1.  Remove the battery compartment 
cover by sliding the cover in the 
direction of the arrow. 
 
2.  Insert the battery with the positive 
side facing up. 
 
3.  Replace the cover. 
 
 
Caution: 
1. Only use AA batteries (Alkali ne batteries are recommended). 
 
2. Dispose of used batteries accordi ng to local ordinance regulations.  
 
3. Remove the batteries when not usi ng the projector for prolonged...

D
D
D L
L
L P
P
P  
 
  P
P
P r
r
r o
o
o j
j
j e
e
e c
c
c t
t
t o
o
o r
r
r —
—
— U
U
U s
s
s e
e
e r
r
r ’
’
’ s
s
s  
 
  M
M
M a
a
a n
n
n u
u
u a
a
a l
l
l  
 
 
Installing or Removing  the Optional Lens 
Caution: 
y Do not shake or place excessive pressure  on the projector or the lens components as the 
projector and lens component s contain precision parts. 
y Before removing or installing the lens, be sure to  turn off the projector, wait until the cooling 
fans stop, and turn off the main...