Vivitek D860 User Manual

DLP Projector—User’s Manual 
— ii — 
Important Safety Information 
Important: 
It is strongly recommended that you read this sect ion carefully before using the projector. These 
safety and usage instructions will ensure that you enj oy many years of safe use of the projector. 
Keep this manual for future reference. 
Symbols Used 
Warning symbols are used on the unit and in this ma nual to alert you of hazardous situations.  
The following styles are used in this manual to alert you to important...

 
 
  Preface 
Projector Installation Notice 

  Place the projector in a horizontal position 
The tilt angle of the projector should not exceed 15  degrees, nor should the projector be installed in 
any way other than the desktop and ceiling mount, otherwise lamp life could decrease dramatically. 
     
   Allow at least 50 cm clearance around the exhaust vent. 
  
 
  
 
 
   Ensure that the intake vents do not recycle hot air from the exhaust vent. 
   When operating the projector in an enclosed...

DLP Projector—User’s Manual 
Power Safety 
  Only use the supplied power cord. 
   Do not place anything on the powe r cord. Place the power cord where it will not be in the way of 
foot traffic. 
   Remove the batteries from the remote control when storing or not in use for a prolonged period. 
Replacing the Lamp 
Replacing the lamp can be hazardous if done incorrectly. See  Replacing the Projection Lamp on page 39 
for cle
ar and safe instructions for this procedure. Before replacing the lamp: 
...

 
 
  Preface 
–
 v  – 
Main Features 
  Lightweight unit, easy to pack away and transport. 
   Compatible with all major video standards including NTSC, PAL, and SECAM. 
   A high brightness rating allows for presentations in daylight or in lit rooms. 
   Supports resolutions up to UXGA at 16.7 million colors to deliver crisp, clear images. 
   Flexible setup allows for front, rear projections. 
   Line-of-vision projections remain square, with advanced keystone correction for angled 
projections....

DLP Projector—User’s Manual 
— vi — 
Table of Contents 
GETTING STARTED ........................................................................\
.................................................................................. 1 
PACKING CHECKLIST........................................................................\
................................................................................... 1 
VIEWS OF PROJECTOR PARTS........................................................................\...

 
 
  Preface 
–
 vii  – 
COMMON PROBLEMS AND SOLUTIONS........................................................................\
....................................................... 45 
TIPS FOR TROUBLESHOOTING........................................................................\
.................................................................... 45 
LED ERROR MESSAGES........................................................................\...

DLP Projector – User’s Manual 
– 1 –  
GETTING STARTED 
Packing Checklist 
Carefully unpack the projector and che ck that the following items are included:   
 
DLP PROJECTOR WITH LENS CAP 
    
 
   
 
R
EMOTE CONTROL (*1) 
(
WITH ONE 3V CR2025 
BATTERY
)  R
EMOTE CONTROL (*2) 
(
WITH TWO AAA BATTERIES)  RGB
 CABLE POWER CORD 
 
 
   
C
ARRYING CASE 
(O
PTIONAL)  CD-ROM
  
(T
HIS USER’S MANUAL)  Q
UICK START GUIDE WARRANTY CARD 
 
Contact your dealer immediately if any items are mi
ssing, appear...

DLP Projector—User’s Manual 
Views of Projector Parts  
Front-right View 
 
ITEM LABEL DESCRIPTION SEE PAGE: 
1.  IR receiver Receive IR signal from remote control 7 
2.  Lens Projection  Lens 
3.  Focus ring Focuses the projected image 
4.  Zoom ring  Enlarges the projected image 
20 
5.   (POWER) 
See Top view—Power buttons and LEDs. 3 
Important: 
Ventilation openings on the projector 
allow for good air circulation, which keeps the projector lamp 
cool. Do not obstruct any of the ventilation...

DLP Projector – User’s Manual 
Top view—Power buttons and LEDs 
 
ITEM LABEL DESCRIPTION SEE 
PAGE: 
1.   (POWER) 
Turns the projector On or Off  15 
On Lamp 
Error. 2.  LAMP LED 
Off Normal State 
Blue  Power On  
Off  Power Off (AC Off) 3.  POWER LED 
Flashing System Initialized / Cooling / Error code 
 
– 3 –