ViewSonic Pj853 Projector User Manual

							User Guide
Guide de l’utilisateur
Bedienungsanleitung
(International Spanish)
(Italian)
(Brazilian Portuguese)
(Swedish)
(Russian)
(Polish)
(Japanese)
(Traditional Chinese)
(Simplified Chinese)
(Korean)
(Arabic)
Image Size 30” – 300”
Super Bright SVGA LCD Projector
LITEBIRDTM
PJ853-.book Page 1 Wednesday, August 16, 2000 11:41 AM 
						

							1ViewSonic PJ853
E
N
G
L
I
S
H
Copyright © ViewSonic Corporation, 2000. All right reserved.
Macintosh, Mac and Power Macintosh are registered trademarks of Apple Computer, Inc.
Microsoft, Windows, Windows NT, and the Windows logo are registered trademarks of Microsoft
Corporation in the United States and other countries.
ViewSonic, the three birds logo and OnView are registered trademarks of ViewSonic Corporation.
VESA is a registered trademark of the Video Electronics Standards Association. DPMS and DDC
are trademarks of VESA.
E
NERGYSTAR®is a registered trademark of the U.S. Environmental Protection Agency (EPA).
As an E
NERGYSTAR®partner, ViewSonic Corporation has determined that this product meets the
E
NERGYSTAR®guidelines for energy efficiency.
Disclaimer: ViewSonic Corporation shall not be liable for technical or editorial errors or omissions
contained herein; nor for incidental or consequential damages resulting from furnishing this material,
or the performance or use this product.
In the interest of continuing product improvement, ViewSonic Corporation reserves the right to
change product specifications without notice. Information in this document may change without
notice.
No part of this document may be copied, reproduced, or transmitted by any means, for any purpose
without prior written permission from ViewSonic Corporation.
ElectronicWarrantyRegistration
To meet your future needs, and to receive any additional product
information as it becomes available, please register your projectors
warranty on the Internet at:
http://www.viewsonic.com
ForYour Records
ProductName:
ModelNumber:
DocumentNumber
SerialNumber:
PurchaseDate:ViewSonic PJ853
VPROJ21732
PJ853_UG_59
_______________
_______________
PJ853-.book Page 1 Wednesday, August 16, 2000 11:41 AM 
						

							3ViewSonic PJ853
E
N
G
L
I
S
H
Connect Input andOutputDevices
The figure below shows the ports and configurations for connecting external devices to the
ViewSonic PJ853. See “Installation Steps” on page 4.
Figure2: ViewSonic PJ853Projector
Figure3:Connections and Projector Control Buttons
M
E
N
US
T
A
N
D
B
Y
/
O
NI
N
P
U
TM
U
T
ER
E
S
E
TL
A
M
P
T
E
M
P
P
O
W
E
R
Powe r S w it c h
AC Inlet
(to the power cord)
Air Vent
(Intake)Foot AdjusterLensRemote Control Sensor
Projector control
panel
ViewSonicPJ853
Video IN port Audio IN port S-video IN port
RGB IN port
Control portRemote control sensor
Standby/ONInputMuteReset Lamp indicator
Temperature indicator
Power indicator
Menu button
Air vent
(exhaust)
Speaker
Power Outlet
Power
ON/OFF
Power Cord
MENUS
T
A
N
D
B
Y
/
O
NI
N
P
U
TM
U
T
ER
E
S
E
TL
A
M
P
T
E
M
P
P
O
W
E
R
PJ853-.book Page 3 Wednesday, August 16, 2000 11:41 AM 
						

							ViewSonic PJ8536
E
N
G
L
I
S
H
Using The Projector
The control buttons display menus that are explained in detail in the section: “OnView Indicators” on
page 8.
Control Buttons
Press a control button to display a menu then use the arrow buttons to adjust the control. The buttons
on the projector control pad and on the remote control are explained below:
Figure7:Projector and Remote Controls
Standby/on Button
Press the STANDBY/ON button to begin the warm-up period. The ON indicator
blinks green during warm-up and stays green when the projector is ready to use.
NOTE:The projector cannot be restarted within 60 seconds after it is turned off because
the projector enters a cool-down mode. This is a safety feature.
Input Button (Video and RGB Buttons)
The INPUT button shown is on the projector only. Use the Video and RGB buttons on
the remote control to select the input source.
Press the Input button on the projector to toggle between input sources, computer
(RGB), Composite or S-Video. The remote control has both a Video and an RGB
button.
-Press RGB to select a computer as the input source.
-Press Video to toggle between Composite and S-Video.
Projector control pad
Remote control
PJ853-.book Page 6 Wednesday, August 16, 2000 11:41 AM