ViewSonic Pj755d Projector User Manual

                                                                                                                          ViewSonic PJ755D 9
Remote Control with Mouse Function & Laser Pointer
1 .  IR LEDS
2 . Power
3 . Sync
4 . Keystone Correction
5 . Display Format
6 . Laser Button
7 . Laser Pointer
8 . Laser Indicator LED
9 . A/V Mute
10 . Freeze
11 . Display Mode
12 . Mouse
13 . Mouse Right Click14 . Mouse Left Click
15 . Page Up / Page Down
16 . Page Scrolling
17 . Zoom In/Zoom Out
18 . Four...

                                                                                                                          ViewSonic PJ755D 10
Installation
Connecting the Projector
1 .  Power Cord
2 . VGA Cable
3 . Composite Video Cable
4 . DVI to D-Sub Cable
5 . S-Video Cable
6 . RCA Component Cable for YPbPr
7 . D-Sub to RCA Cable for HDTV/Component (Optional Accessory)
8 . DVI to DVI Cable (Optional Accessory)
9 . RS232 Cable (Optional Accessory)
*    To ensure the projector works well with your...

                                                                                                                          ViewSonic PJ755D 11
Powering On/Off the Projector
Powering On the Projector
1 .  Remove the lens cap.
2 . Ensure that the power cord and signal cable are securely connected. The Power LED will turn  red.
3 . Turn on the lamp by pressing “Power/Standby“ button on  the control panel.
The start up screen will displa y for 30 seconds and the Power  LED will flash green.
When the startup...

                                                                                                                          ViewSonic PJ755D 12
Powering off the projector
1 .  Press the “Power/Standby” button to turn off the projector lamp, you will see a message  “Wait 2
minutes before you can switch on again”  on the on-screen display. 
2 . Press the “Power/Standby” button again to confirm. 
3 . Otherwise the message will disappear after  10 seconds. 
4 . The cooling fans continue to operate for about...

                                                                                                                          ViewSonic PJ755D 13
Adjusting the Projected Image
Adjusting the Projector Image Height
The projector is equipped with an elevator foot for adjusting the image height.
To raise the image:
1 .  Press the elevator button  .
2 . Raise the image to the desired height angle  , then release the button to lock the elevator foot
into position.
3 . Use   to fine-tune the display angle. 
To...

                                                                                                                          ViewSonic PJ755D 14
Adjusting the Projector Zoom / Focus
You may turn the zoom ring to zoom in or out. To focus the image, rotate the focus ring until the image
is clear. The projector will focus at distances from 3.9 to 32.8 feet (1.2 to 10.0 meters).
Adjusting Projection Image Size
 Zoom Ring
 Focus Ring
61.5
(156.3cm)
102.5
(260.4cm)
143.5
(364.6cm)
164.0
(416.7cm)
205.1
(520.8cm)...

                                                                                                                          ViewSonic PJ755D 15
User Controls
Control Panel & Remote Control
There are two ways for you to control the functions: Remote Control and Control Panel.
Using the Control Panel
Power/Standby 
 *   Refer to the “Power On/Off the Projector” section on pages 11-12.
Source 
 *   Press “Source” to choose RGB, Component- p, Component-i, S-Video, Composite Video and HDTV
sources.
Menu  
 *...

                                                                                                                          ViewSonic PJ755D 16
Using the Remote Control
Power 
 *   Refer to the “Power On/Off th
e Projector” section on pages11-12.
Sync 
 *   Automatically synchronizes the projector to the input source.
Keystone
 *   Adjusts image distortion caused by  the tilting of the projector (±16 degrees).
Display Format
 *   Display the “Display Format” section of the onscreen display menu to select...

                                                                                                                          ViewSonic PJ755D 17
On Screen Display Menus
The Projector has multilingual On Screen Display menus that allow you to make image adjustments and change a
variety of settings. The projector will automatically detect the source.
How to operate
1 .  To open the OSD menu, press “Menu ” on the Remote Control or Control Panel.
2 . When OSD is displayed, use keys to select any
item in the...

                                                                                                                          ViewSonic PJ755D 18 Sharpness
Adjusts the sharpness of the image.
 *   Press the to decrease the sharpness.
 *   Press the to increase the sharpness.
Zoom
 *   Press the to magnify an image up to a factor of 16 times on the
projection screen.
 *   Press the to diminish the zoom in image.
Image-I (Video Mode)
Brightness
Adjust the brightness of the image.
 *   Press the to darken...