ViewSonic Pj551 Projector User Manual

							ViewSonic  PJ500/PJ550/PJ501/PJ55128
Appendix
Power Cord Safety Guidelines
Caution: 
Use a power cable that is properly grounded. Always use an AC power cord that meets your country’s safety 
standard.
AC PLUG CORD PRECAUTIONS FOR THE UNITED KINGDOM
FOR YOUR SAFETY PLEASE READ THE FOLLOWING TEXT CAREFULLY.
IF THE FITTED MOULDED PLUG IS UNSUITABLE FOR THE SOCKET OUTLET THEN THE PLUG 
SHOULD BE CUT OFF AND DISPOSED OF SAFELY.
THERE IS A DANGER OF SEVERE ELECTRICAL SHOCK IF THE CUT OFF PLUG IS INSERTED INTO AN 
APPROPRIATE SOCKET.
If a new plug is to be fitted, please observe the wiring code as shown below.
If in any doubt, please consult a qualified electrician.
WARNING:
 THIS APPLIANCE MUST BE EARTHED.
IMPORTANT:
 The wires in this mains lead are coloured in accordance with the following code: 
Green-and-Yellow: Earth
Blue: Neutral
Brown: Live
If the coloured wires of the mains lead of this appliance do not correspond with the coloured markings 
identifying the terminals in your plug, proceed as follows:
The wire which is coloured GREEN-AND-YELLOW must be connected to the terminal in the plug which is 
marked by the letter E or by the Earth symbol or coloured GREEN or GREEN-AND-YELLOW.
The wire which is coloured BLUE must be connected to the terminal in the plug which is marked with the letter 
N or coloured BLACK. The wire which is coloured BROWN must be connected to the terminal in the plug 
which is marked with the letter L or coloured RED.
IMPORTANT NOTICE CONCERNING POWER CORD SELECTION
The power cord set for this unit has been enclosed and has been selected according to the country of 
destination and must be used to prevent electric shock. Use the following guidelines if it is necessary to 
replace the original cord set, or if the cord set is not enclosed. 
The female receptacle of the cord set must meet CEE-22 requirements and may look like (Figure A1 below):
For the United States and Canada
In the United States and Canada the male plug is a NEMA5-15 style (Figure A2), UL Listed, and CSA 
Labeled. For units which are mounted on a desk or table, type SVT or SJT cord sets may be used. For units 
which sit on the floor, only SJT type cord sets may be used. The cord set must be selected according to the 
current rating for your unit. Please consult the table below for the selection criteria for power cords used in the 
United States and Canada.
For European Countries
In Europe you must use a cord set which is appropriate for the receptacles in your country. The cord set is 
HAR-Certified, and a special mark that will appear on the outer sheath, or on the insulation of one of the inner 
conductors.
If you have any questions concerning which proper power cord to use, please consult with the dealer from 
whom you have purchased the product.USA .............................. UL
Canada ......................... CSA
Germany....................... VDESwitzerland ................... SEV
Britain ............................ BASE/BS
Japan ............................ Electric Appliance Control Act
Cord Type Size of Conductors in Cord Maximum Current Rating of Unit
SJT 18 AWG
16 AWG
14 AWG10 Amps
12 Amps
12 Amps
SVT 18 AWG
17 AWG10 Amps
12 Amps
Figure 1
Figure 2 
						

							29ViewSonic  PJ500/PJ550/PJ501/PJ551
Compliance Information for U.S.A.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to 
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful 
interference in a residential installation. This equipment generates, uses, and can radiate radio frequency 
energy, and if not installed and used in accordance with the instructions, may cause harmful interference to 
radio communications. However, there is no guarantee that interference will not occur in a particular 
installation. If this equipment does cause harmful interference to radio or television reception, which can be 
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by 
one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
FCC Warning
To assure continued FCC compliance, the user must use grounded power supply cord and the provided 
shielded video interface cable with bonded ferrite cores. If a BNC cable is going to be used, use only a 
shielded BNC(5) cable. Also, any unauthorized changes or modifications not expressly approved by the party 
responsible for compliance could void the users authority to operate this device.
Instructions to Users
This equipment complies with the requirements of FCC (Federal Communication Commission) equipment provided that 
the following condition is met. Use the cables which are included with the projector or specified.
Compliance Information for Canada
Notice: 
This class B digital apparatus complies with Canadian ICES-003.
AV I S :  
Cet appeil numerique de la Classe B conforme a la norme NMB-003 du Canada.
Compliance Information for European Countries
CE Conformity
The device complies with the requirements of the EEC directive 89/336/EEC as amended by 92/
31/EEC and 93/68/EEC Art.5 with regard to “Electromagnetic compatibility,” and 73/23/EEC as 
amended by 93/68/EEC Art.13 with regard to “Safety.”
User Information for all Countries
NOTICE: Use the cables which are included with the projector or specified.