Uniden SportCat Vhf Scanner Owners Manual
Have a look at the manual Uniden SportCat Vhf Scanner Owners Manual online for free. It’s possible to download the document as PDF or print. UserManuals.tech offer 50 Uniden manuals and user’s guides for free. Share the user manual or guide on Facebook, Twitter or Google+.
a. Place the point of a ball point pen into the small hole of the Memo Pad plastic cover, and lift it off. (Don’t use a pencil - the lead may break off.) b. Write the names or other identifying remarks in each channel block on the Memo Pad. For example, for an Auto Race you may want to write the drivers’ names, the timer, the control point or safety check, etc. For a Golf Tournament, you may want the 1st Tee, the 18th Tee, the Clubhouse, the Leader Board. etc. Extra Memo Pad sheets have been included with your SportCat so you can cover a number of events. c. Replace the plastic Memo Pad cover. 4. When you attend the sporting event, make sure you are in DIRECT SCAN Mode. If not, press B. Then press Sto begin scanning. Or press one of the number keys to go directly to that channel. 21 C:...sc150om.vp Wed Dec 17 10:34:00 1997 Color profile: Disabled Composite Default screen
Weather Channel Scanning The SportCat is designed to search for your local NOAA weather channel(s) from 7 preprogrammed NOAA channels.. 1. Press Wto begin Weather Search.WXappears at the right side of the display and the word SCANmoves across the display. 2. When the Weather Search finds an active channel in your area, the scanner stops at that frequency. 3. To stay at that frequency, press H. To resume Weather Search, press Hagain, orW. It is possible that you may be able to hear more than one Weather broadcast in your area. If the broadcast sounds weak and distant, press Wagain to look for a closer station. Or, press uordto move to another station. 4. To exit Weather Mode, press SorN. Note:All weather channels transmit continuous broadcasts. Once the Weather scan stops on a transmission, it will remain on that channel. Weather scan will not resume automatically. You must press Wagain to reactivate scanning. In some parts of the country, you may not be able to monitor weather broadcasts, such as in low-lying areas. Normally a higher location will improve the reception. 22 C:...sc150om.vp Wed Dec 17 10:35:23 1997 Color profile: Disabled Composite Default screen
Searching The SportCat has 12 Preprogrammed Search Bands. You can search any of these Bands to find desired frequencies if you do not have a Frequency Directory handy, or if new stations have been added since the Directory was published. 1. Press Nto enter theSEARCHMode. (SRCH appears on the bottom of the display.) 2. Press Nrepeatedly to cycle through the 12 Bands until you reach the one you want. (The cycle goes in only one direction.) 3. Wait for about 2 seconds and the SportCat will begin searching that Band. Or, press uto search forward, or dto search backward. 4. During a Search, press Pto activateTURBO SEARCH . This increases the Search Speed to 300 steps per second in those bands that have 5 kHz steps. (See the table on page for the Band Chart.) When you activate TURBO SEARCH, theSRCH indicator flashes. PressPagain to deactivate TURBO SEARCH. 5. Press Hat any time to stop the search on a frequency. Press Hagain to resume searching. 6. When Search is stopped, you can press uordto move up or down 1 frequency step. (See the table on page for the step size for each Band.) Using DATA Skip. A scanner will normally stop on any transmission it receives. This means the SportCat will stop on Data signals and unmodulated transmissions. You can skip these frequencies during Search. Press Ato activate the DATA Skip feature. The indicator appears on the display. To deactivate DATA Skip, press A. Theindicator disappears from the display. The scanner may pause momentarily at an unwanted signal, but will resume searching in 2 or 3 seconds. Note:DATA Skip does not function on the AIR Band. The indicator will not appear on the display even if this feature is activated. 23 C:...sc150om.vp Wed Dec 17 10:35:24 1997 Color profile: Disabled Composite Default screen
Search Frequency Skip. The scanner may stop at certain frequencies during Search that you do not want to hear. You can program up to 100 Skip Frequencies into the SportCat. When the scanner stops at one of these frequencies during Search, press O. That frequency is now “memorized” and will be skipped during any Search. The scanner will then search to find other active frequencies. Sporting Event Search. Some sporting events do not have specific frequencies assigned to individuals or to specific stations. You can use the SEARCHMode to find the active frequencies to program into the DIRECT ACCESS Channels. Your SportCat Frequency Guide lists the groups of frequencies for certain organizations or events. For example, there are over 25 frequencies listed for the USGA. Look for the organization or event you want to monitor. Then use Search to find the active frequencies, and program them into Channels 1 through 10. List the keys on the Memo Pad. 24 C:...sc150om.vp Wed Dec 17 10:39:40 1997 Color profile: Disabled Composite Default screen
Care and Maintenance Replacing the Battery Pack 1. Turn the On-Off/Volume Control OFF. 2. Turn the scanner over so you are looking at the back. If the Belt clip is attached, remove it by taking out the two screws. 3. Press in on the ribbed area and slide the Battery Cover down and off. 4. Carefully unplug the Battery Back and lift it out of the case You may need to exert a slight pressure toward the top of the scanner as you slide the Battery Pack out of the case. 5. Carefully plug in the new Battery Pack, observing the proper polarity. (The RED wire should be on the right as you plug it in.) Although the plug is keyed to reduce the chance of inserting it in wrong., make sure the wires are in the correct position before pushing it in all the way. DO NOT FORCE THE PLUG IN. 25 C:...sc150om.vp Wed Dec 17 10:39:41 1997 Color profile: Disabled Composite Default screen
6. Insert the Battery Pack by placing the bottom in the case first. Make sure it is seated within the case before replacing the Battery Cover. 7. Replace the Battery Cover by putting the two tabs in the corresponding opening and sliding it upward until it locks in place. LocationnIf strong interference or electrical noise is received, relocate the scanner or its antenna away from the source of the noise. A higher elevation, if possible, may provide better reception. nDo not use the scanner in high-moisture environments such as the kitchen or bathroom. nAvoid placing the unit in direct sunlight or near heating elements or vents. nDo not plug the scanner into an outlet controlled by a wall switch as prolonged periods without power will cause scanner memory loss. CleaningnDisconnect the power to the unit before cleaning.nClean the outside of the scanner with a mild detergent.nTo prevent scratches, do not use abrasive cleaners or solvents. Be careful not to rub the LCD window. nDo not use excessive amounts of water. Repairs Do not attempt any repair. The scanner contains no serviceable parts. Contact the Uniden Customer Service Center or take it to a qualified repair technician. 26 C:...sc150om.vp Wed Dec 17 10:40:28 1997 Color profile: Disabled Composite Default screen
Birdies All scanners are subject to receiving undesired signals or birdies. If your scanner stops during SEARCH Mode and no sound is heard, it may be receiving a birdie. Birdies are internally generated signals inherent in the electronics of the scanner. Use the Search Skip feature to skip the unwanted frequencies. Proper Care of Your Scanner Use only the AC Adapter/Charger that came with your scanner. Do not leave the AC Adapter/Charger plugged in for long periods. Avoid placing the scanner in direct sunlight or near heating elements or vents. Also, do not subject the scanner to continuous sub-zero temperatures. If the scanner is exposed to temperatures below -5°F or above 140°F, the liquid crystal display may temporarily cease to function properly, or can become permanently damaged. 27 C:...sc150om.vp Wed Dec 17 10:40:28 1997 Color profile: Disabled Composite Default screen
Optional Accessories and Replacement Parts The following optional accessories and replacement parts for your SportCat are available from your local Uniden Dealer or through the Uniden Customer Service Center by calling: (317) 842-2483, 8:00 AM to 5:00 PM EST, Monday through Friday. ITEM PART NO. Spare Battery Pack BP-180 Replacement Rubber Antenna AT-218 Earphone EP-009 AC Adapter/Charger AD-70U Black Leather Carrying Case LC-150B Yellow Leather Carrying Case LC-150Y Straight Cigarette Lighter Power Cord (fused) UA-502 Coiled Cigarette Lighter Power Cord (fused) UA-502A Belt Clip with 2 screws BCK-150 Pack of Direct Channel Memo Pads with Plastic CoverMPK-150 SportCat Sports Frequency Guide FB-150 SportCat Operating Guide OMSC150 28 C:...sc150om.vp Wed Dec 17 10:41:52 1997 Color profile: Disabled Composite Default screen
Troubleshooting If your SportCat is not performing properly, try the steps listed below. PROBLEM SOLUTION Scanner won’t work. Check the power connections. Check the volume and squelch. Make sure the power switch is turned on. Improper reception. Check the antenna connection. You may be in a fringe area. Reposition the scanner. Scan won’t stop. Adjust the Squelch Control. Check the antenna connection. It is possible that none of the programmed frequencies are active at the time. Try Band Search. Scan won’t start. Make sure there are some programmed channels. Adjust the Squelch Control. Search won’t start. Adjust the Squelch Control. Keypad won’t work. Check the Keypad Lock. If you still cannot get satisfactory results and want additional information, or to return the unit for service, please call or write the Uniden Parts and Service Division. The address and phone number are listed in the Warranty (at the end of this manual). 29 C:...sc150om.vp Wed Dec 17 10:41:52 1997 Color profile: Disabled Composite Default screen
Technical Specifications Receiver Type:Triple Conversion Superheterodyne Channels:100 Banks:Total 10 Banks 10 Channels each WX:7 Programmed Channels (All NOAA Weather Service) Search Bands:12 Preprogrammed Search bands (NFM or AM) Frequency Range Steps Mode 29.0-29.7 Mhz 5 kHz NFM 29.7-50.0 Mhz 5 kHz NFM 50.0-54.0 Mhz 5 kHz NFM 108-137 Mhz 12.5 kHz AM 137-144 Mhz 5 kHz NFM 144-148 Mhz 5 kHz NFM 148-174 Mhz 5 kHz NFM 406-420 Mhz 12.5 kHz NFM 420-450 Mhz 12.5 kHz NFM 450-470 Mhz 12.5 kHz NFM 470-512 Mhz 12.5 kHz NFM 806-956 Mhz 12.5 kHz NFM Scan Rate:100 channels per sec. (Turbo SCAN Mode) Search Rate:100 steps per sec. (Normal SEARCH Mode) 300 steps per sec. (TURBO SEARCH Mode) Scan Delay:2 seconds Audio Output:180 mW nominal into 8 Winternal speaker 38 mW nominal into 32Wstereo headphones 9 mW nominal into 64Wsupplied earphone Antenna:Rubber antenna included Operating Temperature:- 20°C (- 4°F) to + 60°C (+ 140°F) Size:2-1/2 (W) x 1-3/4 (H) x 12-1/4 (H) (with antenna attached) Weight:0.77 lb. Power Requirements:4.8V DC (internal battery or AC Adapter/Charger) Certified in accordance with FCC Rules and Regulations Part 15 Subpart C as of date of manufacture. Features, specifications, and availability of optional accessories are all subject to change without notice. 30 C:...sc150om.vp Wed Dec 17 10:42:37 1997 Color profile: Disabled Composite Default screen