Uniden Bc60xlt 1 Vhf Uhf Scanner Owners Manual

4. TurnSQUELCHfully clockwise until you hear a hiss.
This lowers the “Squelch Gate” so that everything
gets through—noise, weak signals, and strong
signals.
5. Turn
SQUELCHback counter-clockwise just until the
hiss stops. Now the “Squelch Gate” allows only
strong signals through.
Strong Signals
Medium Signals
Weak Signals
Noise
PHONESQUELCHVOLUME
Strong Signals
Medium Signals
Weak Signals
Noise
PHONESQUELCHVOLUME
11 

Keylock
Key Lock prevents accidental key entries during scanning.
1. To lock the keypad,
press and hold
K
until the key symbol
appears.
2. To unlock the keypad,
press and hold
K
until the key symbol
disappears.
12 

Pro g ra m min g
13 

4. Enter the frequency.
a. Enter the frequency
number.
b. Then press
E.
Note:To clear a mistake while entering the frequency,
press
Btwice, and start over.
If the frequency entered is outside the Frequency Range of
the scanner, a distinctive beep sounds. (See the Table on
page 3 or the Band List on the back of the scanner).
Press
and go
back to Step 4.
Duplicate Frequency Alert
If you enter a
frequency stored in
another channel, you
hear a beep and the
other channel
appears in the display.
Press
to...

Programming Tips
Do not program a weather frequency into one of
the channels, since weather channels transmit
continuously. Use
for weather information.
Group similar frequencies into adjacent channels.
For example, program police frequencies in
channels 1 through 10 and fire/emergency into
channels 11 through 20, and so on.
Put the frequency that you listen to the most or the
most important frequency into a Priority channel.
To quickly program a series of channels, start with
the lowest number channel....

Scanning
.
.
1 3 4 5 9  102 6 7  8CHANNELS
SCAN
16 

Channel Lockout
You can lockout any channel so it is not reviewed during
normal scanning. You can restore the channel to scanning
whenever you wish.
Lockout in Manual Mode
1.
Press.
2. Select a channel.
a. Enter the channel
number.
b. Then press
again.
3.
Press
to lockout
the channel.
17 

Locking a Channel While Scanning
If the scanner keeps stopping on a particular channel due
to noise or too frequent transmissions, you may want to
keep that channel from scanning.
1. Wait until the scanner
stops at the channel.
2.
Then press
.
3. The scanner
immediately resumes
scanning because the
locked out channel is
no longer in the
scanning sequence.
Lockout Tips
To quickly lockout a series of channels, start with
the lowest number channel.
For example, if you are locking out channels 4, 7,
8, 12,...

Restore a Locked Out Channel
1.
Press.
2. Select a locked out
channel.
a. Enter the channel
number.
b. Then press
again.
3.
Press
to unlock
the channel.
19 

Restore All Locked-out Channels
1.
Press.
Note: You must be in
Manual Mode before
restoring all
locked-out channels.
2.
Press and hold
for about two seconds.
You will hear two
beeps when all the
channels have been
restored.
20