Toshiba Satellite 1900 Maintenance Manual

							FIELD REPLACEABLE UNIT DOCUMENTATION1900 Series
TOSHIBA
Tough Enough for Today’s WorldSPEAKERS REMOVAL1. Remove two M2.5x4 black screws securing the left and 
    right speakers.2. Peel off the tape securing  the left and right speaker
    cable.
3. Lift out the left and right speaker cable and remove    both speakers.  SatelliteTMLeft and Right speaker cableLeft and Right speakersM2.5x4 black screwsLeft/Right speaker Tape 
						

							FL INVERTER AND 15” LCD REMOVALFIELD REPLACEABLE UNIT DOCUMENTATION  SatelliteTM1900 Series
TOSHIBA
Tough Enough for Today’s World15” DISPLAY MASK REMOVAL1. Slide the LCD/FL harness cover to the left and lift it out.
2. Remove two mask seals at the bottom corners of the
    display assembly using a pair of fine-tipped tweezers.2. Remove two M2.5x7 flat head black screws securing
    the display mask.
3. There are 23 latches securing the display mask.
    Carefully insert your fingers between the mask and the    LCD panel and pry open the latches starting from the    bottom six latches, to the five latches on the right  
    and left sides, ending with the six top latches.1. Remove two M2x5 silver screw securing the 
    FL inverter board.2. Carefully lift up the FL inverter board and 
    disconnect the LCD/FL cable from CN1 and the
    FL cable from CN2.
3. Remove four M2X3 black screws securing the 
    LCD module.5. Carefully rotate out the top of the LCD module
    enough to access the display cable6. Peel off the tape securing the LCD/FL cable and    disconnect the cable.6. Remove eight M2x3 black screws securing the left 
    and right LCD brackets and separate the brackets.Mask sealsLatchDisplay
maskLCDLCD/FL
harnesscoverLCD moduleM2x5 silver screwFL inverter boardM2x3
blackscrewsM2x3 
blackscrewsLCD/FL cableFL cable