Toshiba Projector Tdp P3 Us User Manual

i
TABLE OF CONTENTS
Safety Instructions  iii
Introduction 1
Image Resolution  1
Compatibility 1
Unpacking the Projector  1
Usage Guidelines  3
If You Need Assistance  4
Warranty 4
Setting up the Projector  5
Connecting a Computer  7
Connecting a Video Player  9
Powering up the Projector and Adjusting the Image  11
Turning Off the Projector  12
Using the Projector  13
Basic Image Adjustment  13
Using the Remote Control  13
Adjusting the Projector  15
Using the Keypad and Remote Buttons  16
Using the...

ii
Ta b l e  o f  C o n t e n t s
Appendix 37
Specifications 37
Accessories 38
Portable Computer Activation Chart  40
Using Video Mirroring with a PowerBook Computer  45
Projected Image Size  46
Index 47 

iii
SAFETY INSTRUCTIONS
Please read and follow all safety instructions provided BEFORE
 
using your new projector. Failure to comply with safety instruc-
tions may result in fire, electrical shock, or personal injury and 
may damage or impair protection provided by equipment. Please 
save all safety instructions.
Safety Definitions:

Wa r n i n g : Statements identify conditions or practices that 
could result in personal injury.
Caution: Statements identify conditions or practices that could 
result...

iv
Safety Instructions

Caution: Don’t set liquids on the projector. Spilled liquids may 
damage your projector.
Caution: Don’t place the projector on a hot surface or in direct 
sunlight.
Caution: Do not drop the projector. Transport the projector in a 
vendor-approved case; refer to your Toshiba dealer or 
projectors.toshiba.com for more information.
Important Operating Considerations
Do not place the projector on a tablecloth or other soft covering 
that may block the vents. In the unlikely event...

1
INTRODUCTION
The Toshiba TDP-P3 is specifically designed for the mobile pre-
senter. It packs XGA 1024x768 graphics with 16.7 million colors 
into a small, 4.8 pound package. It generates crisp, clear images 
using Digital Light Processing™ (DLP) technology, and features 
an M1-DA connector for easy, built-in digital/analog and USB 
connectivity. The TDP-P3 is easy to connect, easy to use, easy to 
transport, and easy to maintain.
NOTE: The TDP-P3 automatically 
expands 640x480 and 800x600 
images to...

2
Introduction
NOTE: The contents of your
shipping box may vary depending
on the projector configuration
you’ve ordered.
F
IGURE 1
Shipping box contents
1. TDP-P3 projector + lens cap 6. M1-DA analog computer cable
2. Soft carry case 7. Macintosh adaptor
3. User’s Guide and quick start 
card8. Audio cable
4. Power cord 9. Composite video cable
5. Remote control  10. S-video cable
11. Audio cable adapter
12
3
4
5
67
89
10
11 

3
FIGURE 2
Side view of projector
Usage Guidelines
 Do not look directly into the projection lens when the lamp is 
turned on. The bright light may harm your eyes.
 Do not block the grills on the projector. Restricting the air flow 
can cause it to overheat and turn off. If this happens, you must 
wait a minute before attempting to turn it back on.
 Handle the projector as you would any product with glass 
components. Be especially careful not to drop it.
 Avoid leaving the projector in direct...

4
Introduction
If You Need Assistance
The first place to look for help is in this manual. Be sure to check 
the guidelines in “Troubleshooting” on page 33. 
If you need assistance, contact Toshiba Technical Support.
In North America, call Toshiba’s toll-free customer service 
& technical support at 
800-457-7777 (available 24 hours a 
day, 7 days a week). 
In Asia, call +81-3-3457-8429.
For web-based or other electronic technical support, please 
visit Toshiba at
 support.toshiba.com.
Warranty
This...

5
SETTING UP THE PROJECTOR
1Place the projector on a flat surface.
The projector must be within 10 feet (3 m) of your power 
source and within 6 feet (1.8 m) of your computer.
If you want to project from behind a translucent screen, set 
up the projector behind your screen. See “Rear Projection” 
on page 24 to reverse the image.
2Position the projector the desired distance from the screen.
The distance from the lens of the projector to the screen and 
the zoom setting determine the size of the...

6
Setting up the Projector
NOTE: Before you continue,
make sure the projector is
unplugged and your equipment is
turned off. If you’re connecting a
computer, make sure the distance
between it and the projector is 6
feet or less.
F
IGURE 4
Connector panel
F
IGURE 5
M1-DA analog computer cable
inin
S-videocomposite
video
Audio indata interface M1-DA
to computer video 
to projector
to computer to USB mouse