Home > Toshiba > Projector > Toshiba Projector Tdp Mt700 User Manual

Toshiba Projector Tdp Mt700 User Manual

Here you can view all the pages of manual Toshiba Projector Tdp Mt700 User Manual. The Toshiba manuals for Projector are available online for free. You can easily download all the documents as PDF.

Page 31

Additional information31 
English
About lamp
The product’s light source is a mercury lamp that lights at increased internal pressure. Be sure to fully 
understand the following characteristics of the lamp and handle it with extreme care.
•  The lamp may burst with a loud noise due to impact or deterioration, or fail to light at the expiration 
of its life.
•  How long it takes before the lamp bursts or the life expires may vary greatly by lamp. Some may 
explode shortly after first use.
• Burst is likely...

Page 32

Additional information   32 
2. Loosen the screws on the lamp cover. 
The lamp door is on the side of the projector.
3. Remove the lamp cover.
4. Loosen the screws that hold the lamp to the projector. It is strongly 
recommended that you use a magnetic-head screwdriver to prevent 
the screws from dropping inside the projector.
5. Slowly pull the lamp straight out of the projector.
Pulling it too quickly may cause the lamp to break and scatter broken glass in 
the projector. To reduce the risk of injuries...

Page 33

Additional information33 
English
Indicator lights
The front of the projector has three lights that indicate its status. Check the following for information 
about the indicator lights. If an abnormal condition is indicated, turn off the projector and contact your 
dealer. 
When the projector is in a normal state: 
When the projector is in an abnormal state: 
POWER TEMP LAMP State Remark
Orange Off Off Standby mode. ---
Flashing 
OangeOff Off The projector is powering up. Cannot turn off the projector....

Page 34

Additional information   34 
Troubleshooting
ProblemCauseRemedy
The 
projector 
does not 
turn on.
There is no power from the 
power cord.Plug the power cord into the AC inlet 
on the rear of the projector, and plug 
the power cord into to a power outlet. If 
the power outlet has a switch, make 
sure it is switched on. 
The power switch is not in the 
ON position.Put the power switch in the ON 
position. 
Attempting to turn the projector 
on again during the cooling 
process.Wait until the cooling-down...

Page 35

Additional information35 
English
Specifications
Note
•  This model complies with the above specifications.
•  Designs and specifications are subject to change without notice.
•  This model may not be compatible with features and/or specifications that may be added in the 
future.
QSeparately sold product
Replacement Lamp Model Model TLPLMT70
Dimensions
14.41 in. W x 5.28 in. H x 12.24 in. D (366 mm W x 134 mm H x 311 mm D)
Unit: in / mm
Optical characteristics
Projection systemSingle-chip DLPTM system....

Page 36

Additional information   36 
Control terminal
Pin assignment
Interface format
1 Communication method RS-232C, 9600bps, No Parity, Data Length: 8 bits;
Stop Bit Length: 1 bit
2 Communication format
Only 1 command valid per communication.
If commands are to be sent consecutively, wait for the response from the projector before sending the 
next command.
Main Commands
 Contact your dealer for control cable and other commands.
Pin No. Signal Name Description
1 RD Receiving data
2 CTS Consent to send
3 DSR...
Start reading Toshiba Projector Tdp Mt700 User Manual

Related Manuals for Toshiba Projector Tdp Mt700 User Manual

All Toshiba manuals