Toshiba Projector Tdp Ff1 User Manual

							
OWNER'S MANUAL
LED PROJECTOR
TDP-FF1A
Before Using
Preparations
Operations
Others 
						

							
2

SAFETY PRECAUTIONS
The  lightning  flash  with  arrowhead  symbol,  within  an  equilateral  triangle,  is  in-
tended to alert the user to the presence of uninsulated “dangerous voltage” within 
the product’s enclosure that may be of sufficient magnitude to constitute a risk of 
electric shock to persons.
The  exclamation  point  within  an  equilateral  triangle  is  intended  to  alert  the  user 
to  the  presence  of  important  operating  and  maintenance  (servicing)  instructions 
in the literature accompanying the appliance.
WARNING:
TO  REDUCE  THE  RISK  OF  FIRE  OR  ELECTRIC  SHOCK,  DO  NOT  EXPOSE  THIS  AP-
PLIANCE TO RAIN OR MOISTURE. DANGEROUS HIGH VOLT AGES ARE PRESENT IN-
SIDE THE ENCLOSURE. DO NOT OPEN THE CABINET. REFER SERVICING TO QUALI-FIED PERSONNEL ONLY.
WARNING:    Handling  the  cord  on  this  product  or  cords  associated  with  accessories  sold  with  this  product,  will  expose  you  to  lead,  a  chemical  known  to  the  State  of 
California to cause birth defects or other reproductive harm.  Wash hands af
-ter handling.
MODEL NAME: TDP-FF1   USA only
TRADE NAME: LED PROJECTOR  MODEL NAME: TDP-FF1
Tested To Comply
With FCC Standards
FOR HOME OR OFFICE USE
FCC NOTICE: This device complies with part 15 of the FCC Rules. Operation is subject to 
the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any 
interference received, including interference that may cause undesired operation. This 
equipment has been tested and found to comply with the limits for a Class B digital device, 
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable 
protection against harmful interference in a residential installation. This equipment gener-
ates, uses and can radiate radio frequency energy and, if not installed and used in ac-
cordance with the instructions, may cause harmful interference to radio communications. 
However, there is no guarantee that interference will not occur in a particular installation. If 
this equipment does cause harmful interference to radio or television reception, which can 
be determined by turning the equipment off and on, the user is encouraged to try to correct 
the interference by one or more of the following measures:
USA only 
						

							
3

Before Using

-  Reorient or relocate the receiving antenna.
-  Increase the separation between the equipment and receiver.
-  Connect the equipment into an outlet on a circuit different from that to which the receiver 
is connected.
-  Consult the dealer or an experienced radio/TV technician for help.
RESPONSIBLE PARTY:  TOSHIBA AMERICA INFORMATION SYSTEMS, INC.
     9740 Irvine Blvd., Irvine, CA 92618-1697 U.S.A
     Phone: (949) 583-3000
WARNING:    Changes or modifications made to this equipment, not expressly approved by 
Toshiba,  or  parties  authorized  by  Toshiba,  could  void  the  user’s  authority  to 
operate the equipment.
WARNING:    This Class B digital apparatus complies with Canadian ICES-003. Cet appareil 
numérique de la classe B est conforme à la norme NMB-003 du Canada.
USA only
CANADA only
 CAUTION
LED RADIATION DO NOT STARE INTO BEAM OR VIEW DIRECTLY WITH OPTICAL 
INSTRUMENTS. CLASS 2M LED PRODUCT.
MANUF ACTURED
SERIAL    NO. 
						

							
4

IMPORTANT SAFETY INSTRUCTIONS
CAUTION:  PLEASE  READ  AND  OBSERVE  ALL  WARNINGS  AND  INSTRUC-
TIONS GIVEN IN THIS OWNER’S MANUAL AND THOSE MARKED 
ON  THE  UNIT.  RETAIN  THIS  BOOKLET  FOR  FUTURE  REFER
-
ENCE.
This set has been designed and manufactured to assure personal safety. Improper use can 
result  in  electric  shock  or  fire  hazard.  The  safeguards  incorporated  in  this  unit  will  protect 
you  if  you  observe  the  following  procedures  for  installation,  use  and  servicing.  This  unit  is 
fully transistorized and does not contain any parts that can be repaired by the user.
DO  NOT  REMOVE  THE  CABINET  COVER,  OR  YOU  MAY  BE  EXPOSED  TO 
DANGEROUS VOLTAGE. REFER SERVICING TO QUALIFIED SERVICE PER
-
SONNEL ONLY.
1.   Read Owner’s Manual
After unpacking this product, read 
the owner’s manual carefully, and 
follow all the operating and other 
instructions.
3.   Source of Light
Do not look into the lens while the 
machine is on. The strong light 
from the len may cause damage to 
your eyes or sight.
2.   Power Sources
This product should be operated 
only from the power source indi-
cated on the marking label. 
If you are not sure of the type of 
power supply to your home, con-
sult your product dealer or local 
power company. 
For products intended to oper-
ate from battery power, or other 
sources, refer to the operating 
instructions.
4.   Ventilation
Openings in the cabinet are pro-
vided for ventilation and to ensure 
reliable operation of the product 
and to protect it from overheating, 
and these openings must not be 
blocked or covered. The openings 
should never be blocked by placing 
the product on a bed, sofa, rug or 
other similar surface. This product 
should not be placed in a built-in 
installation such as a bookcase 
or rack unless proper ventilation 
is provided or the manufacturer’s 
instructions have been adhered to. 
						

							
5

Before Using

5.   Heat
The product should be situated 
away from heat sources such as 
radiators, heat registers, stoves, 
or other products (including ampli-
fiers) that produce heat.
6.   Water and Moisture
Do not use this product near water.
For example, near a bath tub, wash 
bowl, kitchen sink, or laundry tub; 
in a wet basement; or near a swim
-
ming pool and the like.
7.   Cleaning
Unplug this product from the outlet 
before cleaning. Use a soft cloth in
-
stead of liquid cleaners or aerosol 
cleaners for cleaning.
8.   Power-Cord Protection
Power-supply cords should be 
routed so that they are not likely to 
be walked on or pinched by items 
placed upon or against them, pay-
ing particular attention to cords at 
plugs, convenience receptacles, 
and the point where they exit from 
the product.
9.   Overloading
Do not overload outlets; extension 
cords, or integral convenience 
receptacles as this can result in a 
risk of fire or electric shock. 
						

							
6

IMPORTANT SAFETY INSTRUCTIONS (continued)
10.   Lightning storms
For added protection for this prod-
uct during storm, or when it is left 
unattended and unused for long 
periods of time, unplug it from the 
outlet. This will prevent damage to 
the product due to lightning and 
power-line surges. However, while 
it is thundering or lightning, do 
not touch the apparatus and any 
connected cable and/or equip-
ment. This will prevent you from 
receiving the electric shock by an 
electric surge.
11.   Object and Liquid Entry
Never push objects of any kind 
into this product through open-
ings as they may touch dangerous 
voltage points or short-out parts 
that could result in a fire or elec
-
tric shock. Never spill liquid of any 
kind on the product. 
12.   Do not place the product 
vertically
Do not use the product in the 
upright position to project the pic-
tures at the ceiling, or any other 
vertical positions. It may fall down 
and be dangerous.
13.   Stack Inhibited
Do not stack other equipment on 
this product or do not place this 
product on the other equipment. 
Top and bottom plates of this 
product develops heat and may 
give some undesirable damage to 
other unit.
14.   Attachments
Do not use attachments not 
recommended by the product 
manufacturer as they may cause 
hazards. 
						

							
7

Before Using

15.   Accessories
Do not place this product on an 
unstable cart, stand, tripod, brack-
et, or table. The product may fall, 
causing serious injury to a child 
or adult, and serious damage to 
the product. A product and cart 
combination should be moved with 
care. Quick stops, excessive force, 
and uneven surfaces may cause 
the product and cart combination 
to overturn.
S3125A
16.   Damage Requiring Service
Unplug this product from the  out-
let and refer servicing to qualified 
service personnel under the fol-
lowing conditions:
a) When the power-supply cord or 
plug is damaged.
b) If liquid has been spilled, or ob-
jects have fallen into the product.
c) If the product has been exposed to 
rain or water.
d) If the product does not operate 
normally by following the operat-
ing instructions. Adjust only those 
controls that are covered by the 
operating instructions as an im-
proper adjustment of other con-
trols may result in damage and will 
often require extensive work by a 
qualified technician to restore the 
product to its normal operation.
e) If the product has been dropped 
or damaged in any way.
f) When the product exhibits a dis-
tinct change in performance - this 
indicates a need for service.
17.   If glass components, in-
cluding lens, should break, 
contact your dealer for 
repair service.
This product incorporates glass 
components, including a lens. If 
such parts break, please handle 
with care to avoid injury and con-
tact your dealer for repair service. 
The broken pieces of glass may 
cause to injury.
18.   Servicing
Do not attempt to service this 
product yourself as opening or 
removing covers may expose you 
to dangerous voltage or other haz
-
ards. Refer all servicing to quali-
fied service personnel. 
						

							
8

IMPORTANT SAFETY INSTRUCTIONS (continued)
19.   Replacement Parts
When replacement parts are re-
quired, be sure the service techni-
cian has used replacement parts 
specified by the manufacturer or 
have the same characteristics as 
the original part.
Unauthorized substitutions may 
result in fire, electric shock, or 
other hazards.
20.   Safety Check
Upon completion of any service 
or repairs to this product, ask 
the service technician to perform 
safety checks to determine that 
the product is in proper operating 
condition.
21.   Do not leave thermalpaper 
documents or easily de-
formed items on top of the 
unit or near the air exhaust 
for long periods of time.
The heat from the unit could erase 
the information on the thermal 
paper, or cause deformation or 
warping.
22.   Do not use the product in 
a closed installation state.
Do not place the product in a box 
or in any other closed installation 
state. Otherwise it may overheat. 
This could result in a risk of fire. 
						

							
9

Before Using

Save Original Packing Materials
The original shipping carton and packing materials will come in handy if you ever have to 
ship your projector. For maximum protection, repack the set as it was originally packed at 
the factory.
Moisture Condensation
Never operate this unit immediately after moving it from a cold location to a warm location.
When the unit is exposed to such a change in temperature, moisture may condense on the 
lens  and  the  crucial  internal  parts.  To  prevent  the  unit  from  possible  damage,  do  not  use 
the unit for at least 2 hours when there is an extreme or sudden change in temperature.
Place and Manner of Installation
•  Do  not  place  in  hot  locations,  such  as  near  heating  equipment.  Doing  so  could  cause 
malfunction, and shorten the life of the projector.
•  Avoid locations with oil or cigarette smoke. Doing so will dirty the optical parts, shortening 
their lives, and darkening the screen.
•  Using  this  instrument  near  a  TV  or  radio  may  cause  interference  to  the  images  or  audio 
sound. If this happens, move it away from the TV or radio.
•  Moving the projector from a low-temperature room to a high-temperature room may cause  condensation  on  the  lens  or  internal  parts  in  the  instrument.  If  you  continue  to  use  it  in 
that  situation,  the  malfunction  may  result.  Ensure  to  wait  until  the  condensation  naturally 
disappears.
•  Do not use the projector while holding it in your hands or lap.
•  Do not use the projector near a power source and the like, or in locations like a ship 
or vehicle that are subject to vibration or shock. Doing so may lead to a malfunction or 
shorten service life.
Avoid Volatile Liquid
Do not use volatile liquids, such as an insect spray, near the unit. Do not leave rubber or 
plastic products touching the unit for a long time. They will leave marks on the fi nish.
If cleaning with a chemically saturated cloth, be sure to follow the product’s precautions.
IMPORTANT PRECAUTIONS 
						

							
10

EXEMPTION CLAUSES
In the spaces provided below, record the Model and Serial No. located at the bottom of your
projector.
Model No.                                       Serial No.                                  
Retain this information for future reference.
• Toshiba Corporation bears no responsibility in the case of damages arising from natural disaster such as earthquakes, lightning, etc., fire not liable to Toshiba Corporation, acts 
by third parties, other accidents, or use under abnormal conditions including erroneous or 
improper operation and other problems.
• Toshiba Corporation bears no responsibility for incidental damages (lost profi t, work inter
-
ruption, corruption or loss of the memory contents, etc.) arising from the use of or the 
inability to use this unit.
• Toshiba Corporation accepts no liability whatsoever for any damages arising from not hav
-
ing followed the descriptions in this Instruction Manual.
• Toshiba Corporation accepts no liability whatsoever for any damages arising from mal-
functions arising from combination with equipment or software that is not related to 
Toshiba Corporation.