Toshiba L50db Owners Manual

							Turn off (shut down) the computer.
Disconnect the AC adaptor and all peripherals before moving the
computer.
Close the display panel.
Do not pick up the computer by its display panel.
Before carrying your computer, shut it down, disconnect the AC
adaptor and allow it to cool down - a failure to follow this instruction
may result in minor heat injury.
Be careful not to subject the computer to impact or shock - a failure to
follow this instruction could result in damage to computer, computer failure or loss of data.
Never transport your computer with any cards installed - this maycause damage to either the computer and/or the card resulting incomputer failure.
Always use a suitable carry case when transporting the computer.
When carrying your computer, be sure to hold it securely so that it
does not fall or hit anything.
Do not carry your computer by holding any of its protruding elements.
Mobile phones Please be aware that the use of mobile phones can interfere with the audiosystem. The operation of the computer will not be impaired in any way, but it is recommended that a minimum distance of 30cm is maintained between
the computer and a mobile phone that is in use.
Instruction Manual for Safety and Comfort All important information on the safe and proper use of this computer isdescribed in the enclosed Instruction Manual for Safety and Comfort. Be
sure to read it before using the computer.
Safety Icons Safety icons are used in this manual to bring important information to yourattention. Each type of message is identified as shown below.
Indicates a potentially hazardous situation, which could result in death or
serious injury, if you do not follow instructions.A caution informs you that improper use of equipment or failure to follow
instructions may cause data loss, equipment damage, or may result in minor or moderate injury.Please read. A note is a hint or advice that helps you make best use ofyour equipment.User's Manual 1-18 
						

							Chapter 2
Getting Started This chapter provides an equipment checklist, and basic information to
start using your computer.
Some of the features described in this manual may not function properly if you use an operating system that was not pre-installed by TOSHIBA.
Equipment checklist
Carefully unpack your computer, taking care to save the box andpackaging materials for future use.
Hardware Check to make sure you have all the following items:
TOSHIBA Portable Personal Computer
AC adaptor and power cord (2-pin plug or 3-pin plug)
Documentation
Quickstart
Instruction Manual for Safety and Comfort
Warranty information
If any of the items are missing or damaged, contact your dealer immediately.
Conventions This manual uses the following formats to describe, identify, and highlightterms and operating procedures.
HDD or Hard disk
driveSome models are equipped with a "Solid State
Drive (SSD)" instead of a hard disk drive. In this
manual, the word "HDD" or "Hard disk drive" also
refers to the SSD unless otherwise stated.ClickTap the Touch Pad or click the left Touch
Pad control button once.
Left click the mouse once.
Tap the touch screen once (only for touch
screen models).
User's Manual 2-1 
						

							Right-clickClick the right Touch Pad control button
once.
Right click the mouse once.
Press and hold on the touch screen (only for
touch screen models).
Double-clickTap the Touch Pad or click the left Touch
Pad control button twice.
Left click the mouse twice.
Tap the touch screen twice (only for touch
screen models).
CharmBy swiping in from the right edge (only for touch
screen models) or pointing the mouse pointer to
the lower-right (or upper-right) corner of your
screen, you will find a list of charms:  Search,
Share , Start , Devices  and Settings .DesktopClick the  Desktop tile from the Start screen to
access the desktop.Start screenYou can go back to the Start screen from an app
or the desktop by the following ways:
Click the  Start charm.
Move the mouse pointer all the way into the
lower-left corner of the screen and then click
the  Start  button ( 
 ).
Use the Windows ®
 logo key (  ) on your
keyboard.
For detailed information, please refer to the
Windows Help and Support.
Apps viewYou can find all of your apps including desktop programs in the Apps view.
To get to the Apps view:
Move the mouse pointer and then click the
 icon in the lower-left of the screen.
Slide up from the middle of the Start screen
(only for touch screen models).
Using your computer for the first time
Be sure to read the enclosed Instruction Manual for Safety and Comfort for information on the safe and proper use of this computer. It is intended to
help you be more comfortable and productive while using a notebook computer. By following the recommendations in it you may reduce yourUser's Manual 2-2    
						

							chance of developing a painful or disabling injury to your hand, arms,shoulders or neck.
This section provides basic information to start using your computer. Itcovers the following topics:
Connecting the AC adaptor
Opening the display
Turning on the power
Initial setup
Use a virus-check program and make sure it is updated regularly.
Never format storage media without checking its content - formatting
destroys all stored data.
It is a good idea to periodically back up the internal Hard Disk Drive or other main storage device to external media. General storage media isnot durable or stable over long periods of time and under certainconditions may result in data loss.
Before you install a device or application, save any data in memory to
the Hard Disk Drive or other storage media. Failure to do so may
result in the loss of data.
Connecting the AC adaptor
Attach the AC adaptor when you need to charge the battery or you want tooperate from AC power. It is also the fastest way to get started, because
the battery pack will need to be charged before you can operate from
battery power.
The AC adaptor can automatically adjust to any voltage ranging from 100
to 240 volts and to a frequency of either 50 or 60 hertz, enabling you to use this computer in almost any country/region. The adaptor converts AC
power to DC power and reduces the voltage supplied to this computer.
Always use the TOSHIBA AC adaptor that was included with your
computer, or use AC adaptors specified by TOSHIBA to avoid any risk
of fire or other damage to the computer. Use of an incompatible AC
adaptor could cause fire or damage to the computer possibly resulting in serious injury. TOSHIBA assumes no liability for any damage caused by use of an incompatible adaptor.
Never plug the AC adaptor into a power source that does notcorrespond to both the voltage and the frequency specified on the regulatory label of the unit. Failure to do so could result in a fire orelectric shock, possibly resulting in serious injury.
User's Manual 2-3 
						

							Always use or purchase power cables that comply with the legalvoltage and frequency specifications and requirements in the country of use. Failure to do so could result in a fire or electric shock, possibly
resulting in serious injury.
The supplied power cord conforms to safety rules and regulations in
the region the computer is bought and should not be used outside this
region. For use in other regions, please buy power cords that conform
to safety rules and regulations in the particular region.
Do not use a 3-pin to 2-pin conversion plug.
When you connect the AC adaptor to the computer, always follow the
steps in the exact order as described in this User’s Manual.
Connecting the power cable to a live electrical outlet should be the last
step otherwise the adaptor DC output plug could hold an electrical
charge and cause an electrical shock or minor bodily injury when
touched. As a general safety precaution, avoid touching any metal
parts.
Never place your computer or AC adaptor on a wooden surface, furniture, or any other surface that could be marred by exposure to heat since the computer base and AC adaptor's surface increase intemperature during normal use.
Always place your computer or AC adaptor on a flat and hard surface
that is resistant to heat damage.
Refer to the enclosed Instruction Manual for Safety and Comfort for
detailed precautions and handling instructions.
1. Connect the power cord to the AC adaptor. Figure 2-1 Connecting the power cord to the AC adaptor (2-pin plug)
Figure 2-2 Connecting the power cord to the AC adaptor (3-pin plug)
Either a 2-pin or 3-pin adaptor/cord will be included with the computer
depending on the model.User's Manual 2-4   
						

							2. Connect the AC adaptor’s DC output plug to the DC IN 19V jack onyour computer. Figure 2-3 Connecting the DC output plug to the computer1. DC IN 19V jack2. DC output plug
Product appearance depends on the model you purchased.
3. Plug the power cord into a live wall outlet - the  DC IN/Battery indicator
should glow.
Opening the display The display panel can be opened to a wide range of angles for optimal
viewing.
While holding down the palm rest with one hand so that the main body of
the computer is not raised, slowly lift the display panel - this will allow the
angle of the display panel to be adjusted to provide optimum clarity.
Figure 2-4 Opening the display panel
1. Display panel
Product appearance depends on the model you purchased.
Use reasonable care when opening and closing the display panel.
Opening it vigorously or slamming it shut could damage the computer.User's Manual 2-51
2 1  
						

							Do not put your fingers in the gap between the LCD panel and battery
pack when closing your LCD, otherwise your fingers might get hurt.Be careful not to open the display panel too far as this could put stress on the display panel’s hinges and cause damage.
Do not press or push on the display panel.
Do not lift the computer by the display panel.
Do not close the display panel with pens or any other objects left in
between the display panel and the keyboard.
When opening or closing the display panel, place one hand on the
palm rest to hold the computer in place and use the other hand to
slowly open or close the display panel (Do not use excessive force when opening or closing the display panel).
Turning on the power
This section describes how to turn on the power - the  Power indicator will
then indicate the status. Please refer to the  Power Condition Descriptions
section for more information.
After you turn on the power for the first time, do not turn it off until you
have set up the operating system.
Volume cannot be adjusted during Windows Setup.
1. Open the display panel.
2. Press the computer's power button.
User's Manual 2-6   
						

							Figure 2-5 Turning on the power1. Power button
Product appearance depends on the model you purchased.
Initial setup The Windows Startup Screen will be the first screen displayed when youturn on the power. Follow the on-screen instructions on each screen inorder to properly install the operating system.
When it is displayed, be sure to read the  License Terms carefully.
Getting to know Windows
For detailed information on what is new and how to operate Windows,
please refer to the Windows Help and Support.
Start screen The Start screen is the launching pad for everything you can do in the
Windows operating system, providing new and easy ways to access
everything from your favorite apps and Web sites to your contacts and
other important information.
From the Start screen, you can just start typing to search for what you
want. From there, you can easily switch between results for apps, files, and
more.
Windows Taskbar Point to the bottom edge to show the Windows Taskbar on the Startscreen. (If you’ve moved the Windows Taskbar to another edge, point
there.)
You can see all of your recently used apps on the Windows Taskbar.
User's Manual 2-71  
						

							Power Options iconThe Start screen provides you a convenient way to enter the Shut Down/
Sleep/Hibernation Mode. You can just click the power icon ( 
 ) on the
upper right of the Start screen and then select the mode you want.
Charms Use the Windows charms to start apps, find documents, set up system
components, and perform most other computing tasks.
By pointing the mouse pointer to the upper or lower right corner of yourscreen, you will find a list of charms:  Search, Share , Start , Devices  and
Settings .
SearchThis charm allows you to search your computer
(apps, settings and files), the web, or within anapp. You can also find the  Search icon on the
upper right of the Start screen.ShareThis charm allows you to share items (links, photos, and more).StartThis charm takes you to the Start screen or, if
already on the Start screen, returns you to your last app.DevicesThis charm allows you to manage your hardware.SettingsThis charm allows you to access your computer’s
settings (volume, brightness, connecting to the internet, and more).
Tiles
Tiles can be accessed and launched from the Start screen.Typical Start screen tiles are the Desktop tile and Mail tile, as well as tiles representing all other applications downloaded to your system.
Windows Store Although many applications will be pre-installed or built-in to your
computer, you will also have the ability to download many other applications at the click of your mouse.
In the Windows Store you can search for and browse thousands of apps, all grouped into easy to find categories.
User's Manual 2-8       
						

							Sign-in optionsWindows offers a number of sign-in options including  Password (
),
PIN (
)  and  Picture password () authentication to prevent from
unauthorized access. You are allowed to select an option on the Windows
login screen by clicking  sign-in options if you have multiple sign-in
methods set for a user account. Password authentication is the default
sign-in option.
Turning off the power The power can be turned off in one of the following modes, either Shut
Down Mode, Sleep Mode or Hibernation Mode.
Shut Down Mode When you turn off the power in Shut Down Mode, no data will be savedand the computer will boot to the operating system's main screen the nexttime it is turned on.
1. If you have entered data, either save it to the Hard Disk Drive or to other storage media.
2. Make sure all disk/disc activity has stopped before removing the disk/ disc.
If you turn off the power while a disk (disc) is being accessed, you may
lose data or damage the disk.
Never turn off the power while an application is running. Doing so could cause loss of data.
Never turn off the power, disconnect an external storage device or
remove storage media during data read/write. Doing so can cause
data loss.
3. Click the power icon () on the Start screen and then select  Shut 
down .
4. Turn off any peripheral devices connected to your computer.
Do not turn the computer or peripheral devices back on immediately - wait
a short period to avoid any potential damage.
Restarting the computer
Certain conditions require that you reset the computer, for example if:
You change certain computer settings.
If you need to restart the computer, there are several ways this can be achieved:
Click the power icon () on the Start screen and then select  Restart.
User's Manual
2-9