Home > Tone Commander > Telephone Accessories > Tone Commander 6030x Expansion Module Installation Instructions

Tone Commander 6030x Expansion Module Installation Instructions

    Download as PDF Print this page Share this page

    Have a look at the manual Tone Commander 6030x Expansion Module Installation Instructions online for free. It’s possible to download the document as PDF or print. UserManuals.tech offer 24 Tone Commander manuals and user’s guides for free. Share the user manual or guide on Facebook, Twitter or Google+.

    							13-102866  Rev. B
    May 2002
    The Model 6030X Expansion Module adds an additional 30 multifunction keys to a Tone Commander 6210/6220
    ISDN telephone or 7210/7220 VoIP telephone. Included with the 6030X are a wider telephone base that replaces
    the standard base, a ribbon cable for connecting the 6030X to the telephone, a key overlay, and one mounting
    screw.
    Telephone operating software must be version 01.04.xx or higher (6210/6220) or 01.02.xx or higher
    (7210/7220) to enable the Expansion Module. To view the installed software version, select VERS, then S/W
    from the Administration Options menu  (Setup → ADMIN→ VERS→ S/W). If your phones software version is lower
    than the required version, call Tone Commander at (800) 524-0024 to request an update.
    Expansion Module Installation
    1.  Disconnect the line cord.
    Power must be disconnected before installing the 6030X.
    Wait 10 seconds after disconnecting power before proceeding.
    2.  Remove the retaining screw in the center of the base.
    3.  Press the top of the tall edge of the base to disengage the snap tabs, then lift the base from the telephone
    body. Do not touch the expansion connector.
    4.  Lay the telephone and Expansion Module face down, with the Expansion Module to the left (on the
    opposite side from the speaker and handset).
    5.  Plug the supplied ribbon cable into the connectors on the telephone and Expansion Module as shown. The
    polarization tab on each plug must fit into the opening on the side of the connector.
    6030X Expansion Module
    Installation Instructions 
    						
    							Page 2Tone Commander 6030X Expansion Module
    6.  Snap the new base onto the phone and Expansion Module. The base may be rotated for wall mounting.
    Desktop
    Wall Mount
    7.  Fasten the base to the telephone and Expansion Module with the retaining screws (required for UL
    compliance).
    8.  Route the line cord under the tabs as shown.
    Retaining
    Screws
    Retaining
    Screws 
    						
    							Tone Commander 6030X Expansion ModulePage 3
    Service
    Repair of the 6030X must be done by Tone Commander. Prior to equipment removal, call Tone Commander
    Customer Technical Support for assistance in determining the source of the problem. This critical action can often
    prevent needless removal of equipment and subsequent customer inconvenience.
    Tone Commander
    Technical Support Department
    11609 49th Place West
    Mukilteo, WA  98275-4255  USA
    Phone: (425) 349-1000
    (800) 524-0024
    Fax: (425) 349-1010
    E-mail: [email protected]
    Web: www.tonecommander.com
    Tone Commander is committed to meeting the product needs of our customers. Please write or call us with any
    suggestions for improvement.
    Tone Commander Product Warranty
    For a period of one year from date of dealer purchase, but not to exceed 16 months from date of manufacture,
    Tone Commander Systems, Inc. (Tone Commander) warrants its products to be free from defects in material and
    workmanship under conditions of normal use and service. Tone Commander shall, at its option, repair or replace
    any defective product which, in its opinion, has not been misused, damaged, or improperly installed.
    Repair or replacement under this warranty will be performed at Tone Commanders factory. Authorization must be
    obtained from Tone Commander prior to returning a product for repair. Freight must be prepaid for all units
    returned to Tone Commander. Units repaired under warranty will be shipped UPS Ground (or equivalent), freight
    prepaid by Tone Commander.
    Products that are older than the warranty period, but less than 7 years old, or still manufactured by Tone
    Commander may be repaired at the factory for a flat rate charge. Repaired out-of-warranty units are warranted for
    90 days from the date of repair.
    The repair or replacement of a product under this warranty represents the entire obligation of Tone Commander;
    Tone Commander shall not be liable for any special or consequential damages resulting from or caused by any
    defect, failure, incapacity or malfunction of any of its products.
    The foregoing express warranty is in lieu of all other warranties, express or
    implied, including, but not limited to any implied warranty of merchantability,
    fitness, or adequacy for any purpose or use, quality, productiveness or capacity;
    Tone Commander, to the extent permitted by law, hereby disclaims all such other
    warranties. 
    						
    All Tone Commander manuals Comments (0)