TomTom One Xl Xxl Manual

							TomTom ONE/XL/XXL 
						

							Installation1.
2
Installation
1
4
2
3 
						

							3
5
5
+
6
6
82 SEC
312
7 
						

							4
1
180°
2
5
3
4 
						

							What’s in the box2.
5
What’s in the box
* Not included with all products.aYour 
TomTom ONE/XL/
XXLbEasyPort
TM holder
cCar chargerdRDS-TMC Traffic 
Receiver*
eDocumentation 
packfUSB cable 
						

							Before you start3.
6
Before you start
Switching on and off
Install your TomTom ONE/XL/XXL navigation device in your car following the 
instructions in the installation section at the start of this book.
To switch on your navigation device, press and hold the On/Off button until 
you see the start-up screen. The first time you switch on your device, it may 
take a short time to start.
To set up your device you need to answer a few questions by tapping the 
screen.
Device not starting
In rare cases, your TomTom ONE/XL/XXL navigation device may not start cor-
rectly or may stop responding to your taps.
First, check that the battery is properly charged. To charge the battery, con-
nect your device to the car charger. It can take up to 2 hours to fully charge the 
battery.
If this does not solve the problem, you can reset the device. To do this, press 
and hold the On/Off button for 15 seconds and release the button when your 
device begins to restart.
Charging your TomTom ONE/XL/XXL
Before you use your ONE/XL/XXL for the first time, it’s a good idea to charge 
it fully. 
The battery in your TomTom ONE/XL/XXL navigation device charges when 
you connect it to the car charger or to your computer.
There is no charging light on your ONE/XL/XXL. To check the battery status 
and see when your ONE/XL/XXL is charging, switch on your device and tap 
the bottom right-hand corner of the screen in the Driving View. The battery 
status is shown on the next page.
When you connect your device to a computer, you are asked if you want to 
connect to the computer. If you select No and then do not tap the screen 
within three minutes, the device will automatically switch off. This happens so 
that the battery can charge faster.
Note: You should plug the USB connector directly into a USB port on your 
computer and not into a USB hub or USB port on a keyboard or monitor. 
						

							7
Battery notes
The battery in your TomTom ONE/XL/XXL navigation device charges when 
you connect it to the car charger or to your computer.
When you connect your device to a computer, you are asked if you want to 
connect to the computer. If you select No and then do not tap the screen 
within three minutes, the device will automatically switch off. This happens so 
that the battery can charge faster.
Note: You should plug the USB connector directly into a USB port on your 
computer and not into a USB hub or USB port on a keyboard or monitor.
GPS reception
When you first start your TomTom ONE/XL/XXL navigation device, the device 
may need a few minutes to determine your GPS position and show your cur-
rent position on the map. In future, your position will be found much faster, 
usually within a few seconds.
To ensure good GPS reception, you should use your device outdoors. Large 
objects such as tall buildings can sometimes interfere with reception.
Take care of your device
Never leave your TomTom ONE/XL/XXL navigation device or accessories on 
view when you leave the car as they may become an easy target for thieves.
You can set a password which must be entered every time you start your 
device.
It is important to take care of your device.
• Your device is not designed for use in extreme temperatures and any such 
exposure may cause permanent damage.
• Do not open the casing of your device under any circumstances. Doing so 
may be dangerous and will invalidate the warranty.
• Wipe or dry the screen of your device using a soft cloth. Do not use any liq-
uid cleaners. 
						

							Safety4.
8
Safety
Positioning the Active Dock
Consider carefully where to attach the dock in your car. The dock should not 
block or interfere with any of the following:
• Your view of the road
• Any of the controls in your car
• Any of your mirrors
• The airbag
When your navigation device is in the dock, you should be able to reach the 
device easily without leaning or stretching. The diagrams show where you can 
safely attach the dock.
You can attach the dock to the windscreen, side window or use a Dashboard 
Mount Disk to attach the dock to your dashboard. TomTom also offers alter-
native mounting solutions for your TomTom navigation device. For more 
information about Dashboard Mount Disks and alternative mounting solu-
tions, go to tomtom.com/accessories.
Installing the dock
Make sure that both the holder and your window are clean and dry.
1. Press the suction cup firmly against the window on an area where the glass 
is flat.
2. Twist the base of the EasyPort holder in a clockwise direction to lock the 
holder in place.
For detailed instructions, check the installation section at the start of this man-
ual.
Safety preferences
We recommend using the safety preferences to make your driving as safe as 
possible. The safety preferences include, for example, the following options:
• Hide most menu options when driving
• Show safety reminders
• Warn when driving faster than allowed 
						

							Making your first journey5.
9
Making your first journeyPlanning a route with your TomTom ONE/XL/XXL navigation device is easy. 
To plan a route, follow the steps below.
Important: For safety reasons, you should always plan a route before you 
start your journey.
1. Tap the screen to bring up the Main Menu.
Note: The buttons on your navigation device are shown in full colour unless 
a button is currently unavailable. For example, the button named Find alter-
native in the Main Menu is not available until you have planned a route.
2. Tap Navigate to...
3. Tap Address.
When you enter an address, you can choose from the following options:
•City centre - tap this button to set your destination as the centre of a city 
or town.
•Street and house number - tap this button to set an exact address as your 
destination.
•Postcode - tap this button to enter a postcode as your destination. 
						

							10
Note: You can enter a postcode for any country. In some countries, postcodes 
are detailed enough to identify a house on their own. In other countries you 
can enter a postcode to identify a town or area. You will then have to enter a 
street and house number.
•Crossing or intersection - tap this button to set your destination as the 
point where two streets meet.
In this example, we will enter an address.
4. Tap Street and house number.
Note: When planning a trip for the first time your navigation device asks you 
to choose a state or country. Your choice is saved and used for all routes you 
plan.
You can change this setting at any time by tapping the flag.
5. Start to type the name of the town where you want to go.
As you type, the names of the towns that match what you have typed are 
shown. When your destination appears in the list, tap the name of the town 
to set the destination.
6. Start to type the street name. Tap the name when it is shown in the list.
As with the name of the town, the names of the streets that match what you 
have typed are shown. When your destination appears in the list, tap the 
name of the street to set the destination.
7. Enter the house number and then tap Done.