THOMSON Dpl4911 User Manual
Have a look at the manual THOMSON Dpl4911 User Manual online for free. It’s possible to download the document as PDF or print. UserManuals.tech offer 13 Thomson manuals and user’s guides for free. Share the user manual or guide on Facebook, Twitter or Google+.
EN 19 Troubleshooting If you experience any of the following difficulties while using the system, use this troubleshooting guide to help you remedy the problem. Should any problem persist, consult your nearest service center. No power •Is the power cord firmly plugged into the power outlet? •One of the safety mechanisms may be operating. In this event, unplug the player from the power outlet briefly and then plug it in again. No picture •Check that the system is connected securely. •The video connecting cord is damaged. Replace it with a new one. •Make sure you connect the system to video input connec- tor on the TV. •Make sure you turn on the TV. •Make sure you select the video input on the TV so that you can view the pictures from this system. The picture noise appears •Clear the disc. •If video from this system has to go through your VCR to get to your TV, the copy protection applied to some DVD programs could affect picture quality. If you still experi- ence problems after checking your connections, please try connecting your DVD system directly to your TV’s S- Video input, if your TV is equipped with this input. The aspect ratio of the screen cannot be changed even though you set “TV DISPLAY” in the SETUP menu when you play a wide picture. •The aspect rate is fixed on your DVD disc. •If you connect the system with the S-Video cable, connect directly to the TV. Otherwise, you may not change the aspect rate. •Depending on the TV, you may not change the aspect rate. There is no sound or only a very low-level sound is heard. •Check that the speakers and components are connected securely. •Make sure that you have selected the correct source on the system. •The protective device on the system has been activated because of a short circuit. Turn off the system, eliminate the short-circuit problem and turn on the power again. •The audio connecting cord is damaged. Replace it with a new one. •The system is in pause mode or in slow-motion play mode, or fast forward or fast reverse is performed. Press PLAY to return to normal play mode. •Check the speaker settings The left and right sounds are unbalanced or reversed •Check that the speakers and components are connected correctly and securely. •Adjust front balance parameter using SELECT and VOLUME +/-.Severe hum or noise is heard •Check that the speakers and components are connected securely. •Check that the connecting cords are away from a transformer or motor, and at least 3 meters away from a TV set or fluorescent light. •Move your TV away from the audio components. •The plugs and jacks are dirty. Wipe them with a cloth slightly moistened with alcohol. •Clear the disc. The sound loses stereo effect when you play a Video CD or a CD •Set the Audio mode to “STEREO” in the SETUP menu. •Make sure you connect the system appropriately. The surround effect is difficult to hear when you are playing a Dolby Digital sound track •Check the speaker connections. •Depending on the DVD disc, the output signal may not be the entire 5.1 channel but monaural or stereo even if the sound track is recorded in Dolby Digital format. The sound comes from the center speaker only •Depending on the disc, the sound may come from the center speaker only. No sound is heard from the center speaker •You may set the listening mode to Dolby Pro Logic Phantom. •Adjust the speaker volume. No sound or only a very low-level sound is heard from the rear speakers •Adjust the speaker volume. The language for the subtitles cannot be changed when you play a DVD •Multilingual subtitles are not recorded on the DVD. •Changing the language for the subtitles is prohibited on the DVD. The subtitles cannot be turned off when you play a DVD •Depending on the DVD, you may not be able to turn the subtitles off. The angles cannot be changed when you play a DVD •Multi-angles are not recorded on the DVD. •Change the angles when the angle mark appears on the TV screen. •Changing the angles is prohibited on the DVD. The system does not operate properly •Static electricity, etc., may affect the system’s operation. Press the STANDBY/ON button to turn off, then press again to turn on. Or you can try to unplug the power cord and plug it on again.
20 Specifications Tuner section Tuning range ................................................................................................................... FM 87.5 - 108 MHz (0.0.5MHz steps) ......................................................................................................................................... AM 522 - 1620 kHz ( 9 kHz steps) Amplifier section Output power ................................................................................................................. 5 x 50 W / each channel Total harmonic distortion ............................................................................................... 10% at rated power (1 kHz) Stereo power ................................................................................................................... 2 x 60W, 2 channel driven at 10%THD, 6 ohms, 1kHz 2 x 45W, 2 channel driven at 1%THD, 6 ohms, 1kHz Subwoofer power ........................................................................................................... 1 x 60W, at 10%THD, 6 ohms, 100Hz Frequency response ........................................................................................................ 30 Hz - 20 kHz Signal-to-Noise ratio ....................................................................................................... > 65 dB (CCIR) General Power supply ................................................................................................................... 230V / 50 Hz Power consumption ........................................................................................................ 105 W Dimension ....................................................................................................................... 6cm H x 43cm W x 35cm D Speaker System .............................................................................................................................. 1-way shielded Impendance ..................................................................................................................... 6 ohm, subwoofer 6 ohm Dimension ....................................................................................................................... 18cm H x 9.9cm W x 8.1cm D Specifications subject to change without prior notice
EN 21 Care and Maintenance Disconnect the audio system from the power source before performing any maintenance. Cleaning Clean the exterior of the system using a soft dust cloth. The player CAUTION! This system operates with a laser. It must only be opened by a qualified technician. • Never move the player during playback. • Never put more than one disc on a tray or put a disc slipping out of the guide area. Handling discs • Do not touch the signal surfaces. • Hold discs by the edges, or by one edge and the hole. • Do not affix labels or adhesive tapes to the label surfaces. • Do not scratch or damage the label. Discs rotate at high speeds inside the player. • Do not use damaged (cracked or warped) discs. Cleaning discs • Dirty discs can cause poor sound and visual quality. Always keep discs clean by wiping them gently with a soft cloth from the inner edge toward the outer perimeter. Never wipe the disc in a circular motion since circular scratches are likely to occur and could cause noise during playback. • If a disc becomes dirty, wet a soft cloth in water, wring it out well, wipe the dirt away gently, and then remove any water drops with a dry cloth. • Do not use record cleaning sprays or antistatic agents on discs. Also, never clean discs with benzene, thinner, or other volatile solvents which may cause damage to disc surface Disc lens care • When your disc lens gets dirty it can also cause the system to output poor sound and visual quality. To clean the lens you will need to purchase a disc lens cleaner which can maintain the output sound and visual quality of your system. For instructions on cleaning the disc lens, refer to the ones accompanying the lens cleaner. Important battery information • Remove the batteries to avoid leakage if you do not use your remote control for more than one month. • Discard leaky batteries immediately as leaking batteries may cause skin burns or other personal injuries. • Dispose of batteries in the proper manner, according to provincial and local regulations. • Any battery may leak electrolyte if mixed with a different battery type, if inserted incorrectly, if all batteries are not replaced at the same time, if disposed of in fire, or if an attempt is made to charge a battery not intended to be recharged. Transportation information • Unplug the unit when the STANDBY LED is on while in STANDBY mode. Safety precautions • Never open the cabinet under any circumstances. Any repairs or internal adjustments should be made only by a trained technician. • Never operate this product with the cabinet removed. • Do not touch the player with wet hands. If any liquid enters the player cabinet, take the player to a trained technician for inspection. • This player uses a laser to read the data on the disc. The laser mechanism corresponds to the cartridge and stylus of a record player. Although this product incorporates a laser pick-up lens, it is completely safe when operated according to directions. • Discs rotate at high speed inside the player. Do not use damaged, warped, or cracked discs. • Do not touch the pick-up lens which is located inside the disc compartment. Also, to keep dust from collecting on the pick-up lens, do not leave the compartment door open for an extended period of time. If the lens becomes dirty, clean it with a soft brush, or use an air blower brush designed for camera lenses. • The apparatus shall not be exposed to dripping or splash- ing and that no objects filled with liquids, such as vases, shall be placed on the apparatus. Headset safety • Do not play your headset while the sound is at high volume level. Hearing experts warn against extended high- volume play. • If you experience a ringing in your ears, reduce volume or discontinue use. • You should use with extreme caution or temporarily discontinue use in potentially hazardous situations. • Even if your headset is an open-air type designed to let you hear outside sounds, don’t turn the volume so high that you are unable to hear what is around you. Don’t infringe This product should only be used for the purposes of which it is sold, that is, entertainment, violating no copyright law. Any attempts to use this product for which it is not intended is unlawful and therefore not condoned by Thomson. The descriptions and characteristics given in this document are given as a general indication and not as a guarantee. In order to provide the highest quality product possible, we reserve the right to make any improvement or modification without prior notice. The English version serves as the final reference on all products and operational details should any discrepancies arise in other languages. VideoDiscThomsonDigital