Telex Projector Firefly P350 User Manual

P350 SETUP
This section is a detailed description of the setup for your P350.
Positioning the Firefly™ P350 On the Desktop
1. Place the P350 on a table or desktop as shown in Figure 5.
NOTE:Ensure that the P350 vents are not blocked. The P350 takes in
cool air at the side of the projector.  Hot air is exhausted at the rear of the
P350.
WARNING! To prevent heat damage, keep all materials at least one
foot (30 cm) from the rear of the P350.
2. To determine the distance between projector and screen, refer...

The following describes the steps needed to connect the P350.
1. Turn off all equipment.
2. Slide the locking mechanism (Figure 6) to release, then lift the P350
to its raised position.
3. Plug the Firefly™ P350 into an AC wall outlet (the
POWERbutton
will glow and one of the cooling fans will be turned on).
4. Audio input can be amplified by the P350 and heard over the built-in
speakers. Connect a stereo or mono audio source, such as the
auxiliary output of an amplifier, a wireless microphone system,...

6. If you are using an IBM VGA/SVGA computer, the connections
are shown in Figure 7:
a. Unplug the monitor cable from the computer.
b. Plug one end of the supplied VGA/SVGA cable into the video
port of the computer.
c. Plug the other end of the VGA/SVGA cable into the
COMPUTER
jack on the Firefly™P350.
d. To use your computer monitor along with your P350, plug the
monitor cable into the
MONITORjack on the Firefly™P350.
External
Amplified
SpeakerVCR or
Laserdisc
Video
Super VHS
VideoLine Level
Stereo...

7. If you are using a Macintosh computer, the connections are
shown in Figure 8:
a. Unplug the monitor cable from the computer.
b. Plug the adapter labeled either “550093-0 or ”550093-2 into
the monitor port of the computer.
c. Plug one end of the supplied VGA/SVGA cable into the adapter
on the computer.
d. Plug the other end of the VGA/SVGA cable into the
COMPUTER
jack on the Firefly™P350.
e. To use your computer monitor along with your Firefly
™, select
the adapter labeled either “550093-1 or...

8. A video source such as a VCR or LaserDisc player can be
connected to the
VIDEOandAUDIOjacks on the P350 as shown in
Figure 9:
a. Use the provided composite video cable to connect the VCR or
LaserDisc player to the
COMPOSITEjack on the Firefly™P350.
b. If your video system has S-Video capabilities, use the cable sup-
plied with your video system to connect to the
S-VIDEOjack on
the P350.
c. Use the provided dual RCA to 1/8” stereo cable to connect the
audio output to the
AUDIO INjack on the...

Remote Control Battery
The remote control requires one 9V alkaline battery installed as shown in
Figure 10.
A new battery should be installed in the remote control unit under the
following circumstances:
·New remote control unit is received from the factory.
·LED on the remote control no longer lights when keys are pressed,
indicating a “dead” battery
·Operating distance between the remote control and the P350
becomes too short for your purposes, indicating a “weak” battery
Continue with the Operation...

OPERATION
After you have connected the Firefly™ P350 as described in the P350
Setup section of this manual, you are ready to begin using your P350
LCD notebook projector.
Basic Operation
1. Lift the mirror as shown in Figure 6.
2. Press
POWERto turn on the P350 LCD notebook projector. The
keypanel will light up, the main cooling fans will turn on and the
projector lamp will turn on; initially the screen will be blue. After
initialization, the Telex logo will appear.
NOTE:When the P350 is turned on after...

FOCUS
CONTROL
Figure 11. P350 Screen Focus
P350 ProjectorTELEX
Alignment
Alignment
AlignmentAlignmentAlignment
Alignment
Alignment
Alignment
KEYSTONE
CONTROL
KEYSTONE EFFECT
Figure 12. P350 Keystone Control
User Manual  13 

8. PressVOLUMEto adjust the volume of the P350 built-in speakers.
NOTE:If you have an external powered speaker system plugged into
the
AUDIO OUTjack, turn it on and adjust the volume of that external
system. (The level at the
AUDIO OUTjack is controlled byVOLUME.)
9. Turn on and play the connected VCR, LaserDisc player, etc.
10. Press
SOURCEon the P350 keypanel to select one of the video
inputs.
11. To further enhance or change the image on the Firefly™ P350, refer
to the Keypanel and Menu Mode On-Screen...

CONTROLS
The P350 keypanel and Menu Mode On-Screen controls allow you to
customize the projected image and enhance the appearance of your
presentation. The function of each keypanel and on-screen control is
described below and the keypanel is shown in Figure 13.
Keypanel Controls
NOTE:All controls have on-screen graphics to indicate their relative
value or selection setting.
BRIGHTNESSPress the upper (+) button of theBRIGHTNESScontrol to increase the
overall image brightness. Press the lower (-) button...