Stihl Edt 5 Tachometer Manual

STIH)
Technical Information
TI_06_2006_30_01_01.fmenglisch / English USA
Cut-off machines STIHL TS 700, TS 800 – Series 4224
Contents
1. Ignition system (ignition module, flywheel)
2. Tank housing (tank vent, hose, routing / switch)
3. Summary
4. Service note (adjustment of air shutter linkage)
1. Ignition system (ignition module, 
flywheel)
The ignition system with higher spark energy 
that will be installed as standard in the TS 800 will 
also be used in the TS 700 in the future.
1.1 Ignition module...

Page 2 Technical Information  06.2006
TI_06_2006_30_01_01.fm
1.3 Spare parts / service notes
The new ignition system will not be introduced in all 
versions of the TS 700 at the same time. Great care 
must therefore be taken to establish which ignition 
system has been installed when carrying out 
repairs.
To ensure correct operation of the ignition system, 
the individual components (flywheel and ignition 
module) of the previous and new versions may only 
be installed in correct combination:
Flywheel...

Technical Information  06.2006 Page 3
TI_06_2006_30_01_01.fm
The new hose is available in one meter lengths for 
replacement (0000 930 2802) and must be cut to 
128 mm (5 in.) when required.
2.3 Routing / switch
The guide ribs integrally moulded onto the tank 
housing to secure the short-circuit and ground wires 
have been spaced more closely. At the same time, 
the short-circuit and ground wires (on switch 
4224 430 0500) are no longer encased in a hose, 
but now take the form of a light...

Page 4 Technical Information  06.2006
TI_06_2006_30_01_01.fm
4. Service note 
(adjustment of air shutter linkage)
To ensure optimum combustion, the air shutter must 
open with a delay in relation to the throttle shutter.
If the air shutter opens too soon, the mixture will be 
too lean and the engine will overheat and/or it will be 
inadequately lubricated. For this reason, the air 
shutter linkage (between throttle shutter and air 
shutter) must be carefully and precisely set. The 
adjustment procedure...

Technical Information  06.2006 Page 5
TI_06_2006_30_01_01.fm
.Fit nuts (arrows) and screw them tight until the 
test flange rests securely against the carburetor.
.Turn the bottom lever counterclockwise until the 
linkage (1) almost rests against the upper end of 
the oblong hole (arrow) in the lever.
The lever (1) must not be in the top dead 
center position = TDC (OT).
.Close the air shutter with a blunt tool (arrow) and 
hold it shut.
.Align lever (1) in position (A), keeping the 
linkage (2)...

Page 6 Technical Information  06.2006
TI_06_2006_30_01_01.fm
Last Technical Information on the STIHL TS 700, TS 800: 52.2004 (TS 700), 01.2006 (TS 800)
© ANDREAS STIHL AG & Co. KG, 10. May 2006 Technical Documentation
D1/MTK-sc