Stiga Snow Blower COMPACT LINE SNOW ELECTRIC Instructions Manual

STIGA 
COMPACT LINE
SNOW ELECTRIC
8218-2218-70
BRUKSANVISNING
KÄYTTÖOHJEET
BRUGSANVISNING
BRUKSANVISNING
GEBRAUCHSANWEISUNG
INSTRUCTIONS FOR USE
MODE D’EMPLOI
ISTRUZIONI PER L´USO
INSTRUKCJA OBS£UGI
»HC“P”K÷»fl œOÀ‹«Œ¬¿“EÀfl
NÁVOD K POU®ITÍ
HASZNÁLATI UTASÍTÁS
NAVODILA ZA UPORABOSV .... 4
FI ..... 8
DA ..12
NO .14
DE ...20
EN ...24
FR ....28
IT .....32
PL ....36
RU...40
CS ...45
HU ..49
SL ....54 

2
1
2
34
5
6 B
A
4
1
C
1
3
52
4
6 

3
7
98 

24
ENGLISHEN
1 SYMBOLS
The following symbols appear on the machine. They are 
there to remind you of the care and attention required in use. 
This is what the symbols mean:
Warning. If the regulations are not followed, there 
is a risk of danger to life and machine breakdown.
Read the owner’s manual before operating the 
machine.
Keep bystanders at a safe distance from the 
machine.
Warning of hard objects flying off.
The power supply must be disconnected before 
carrying out cleaning or maintenance.
The...

25
ENGLISHEN
• Always make sure the rotating parts have stopped and all 
the controls are disengaged before cleaning, repairing or 
inspection.
• Before leaving the machine unattended, disengage all the 
controls, put it into neutral gear, stop the engine and 
remove the ignition key. 
• Never run the engine indoors except when taking it in and 
out of its place of storage. In this case ensure the door to 
the storage place is open. Exhaust fumes are toxic. 
• Never drive across a slope. Move from the...

26
ENGLISHEN
4 CONTROLS
The snow thrower is fitted with the following controls and 
devices.
See fig. 9-12.
Starting handle (1) – Starts and stops the electric motor.
Ignition lock (2) – Facilitates activation of the starting han-
dle.
Connector (3) – For electrical connection.
Cable support (4) – For supporting the connection cable.
Deflector lock (5) – Locks the deflector in position.
Direction lever (6)– Changes the direction of the discharge 
chute.
Discharge chute (A) – Ejects the snow.
Deflector...

27
ENGLISHEN
6 MAINTENANCE
The electrical connection must be disconnected 
before carrying out maintenance work.
6.1 BEFORE USE
• Every time the snow thrower is to be used, check that the 
electrical equipment is intact and free of faults. The snow 
thrower must not be used if there are any faults or if any-
thing is missing.
• Check that the auger rotates easily.
• Check that all screw joints are tightened. Tighten if nec-
essary.
• Apply silicon spray to the auger. This prevents icing.
• Check that the...

www.stiga.com
GGP Sweden AB · Box 1006 · SE-573 28 TRANÅS