Stiga Cultivator 8214-2227-01 JB 55 Instructions Manual

JB 55


EN OPERATOR´S MANUAL
PL
,16758.&-½2%6¥8*,
CS1”92
8214-2227-01 

ENGLISHEN
1 SYMBOLS, SEE FIG. 1
The following symbols can be found on the tiller. Their pur-
pose it to remind you of the care and attention required when 
using it. If any symbol is missing, damaged or unreadable, it 
should be immediately replaced with a new one. The sym-
bols mean: 
1.  Warning! Read the instructions. 
2.  Warning for rotating blades. 
3.  Reverse gear. 
4.  Clutch handle. Handle out, left fig. = disengaged. Handle pressed in, right fig. = engaged. 
5.  Throttle control, a=fast,...

ENGLISHEN
• Always keep at a safe distance to the rotors when wor-king.
•  Holding the steering correctly ensures a safe distance. 
• No person must come closer than 20 m to the machine  when working on slopes. The user must hold the steering 
firmly with both hands all the time.
• Working on stony or hard ground demands extra attention  from the operator. The machine becomes more unstable. 
• Never touch the engine when operating the machine, or  just afterwards. Risk for burn injuries.
2.4 AFTER...

ENGLISHEN
5.3 SUPPORT WHEEL, SEE FIG. 5
Fit the support wheel according to the figure. Do not tighten 
the nut (5) too hard. It will not be possible to fold the wheel 
arm up.
5.4 FILLING THE OIL, SEE FIG. 2
Remove the plug (12) and fill up with 0.7 L of oil, SAE 
10W40. Screw the plug back on.
5.5 ROTORS AND SIDE ROLLERS, SEE FIG. 6
The first rotor (1) is pushed on the axle shaft (2) and locked 
with the cotter (3). After which the second rotor (4) is inser-
ted in the first and locked with the cotter...

ENGLISHEN
8 MAINTENANCE
WARNING! Repairs must be carried out by the 
dealer. Otherwise the warranty is not valid.
WARNING! The spark plug lead should be discon-
nected before carrying out repairs or maintenance.
8.1 PERIODIC MAINTENANCE
8.1.1 Before using the machine
 
• Check the oil level in the engine. Top up if necessary. 
• Check that there is no oil leakage. 
• Check that all the bolts are tightened. 
8.1.2 After using the machine
 
• Clean the tiller. 
• Check that there is no oil leakage.
8.1.3...

ENGLISHEN
8.9.4 Fault: Slips when moving forward. 
Reason: The belt is too slack.
Procedure: Adjust the belt. 
8.9.5 Fault: Slips when moving backward. 
Reason: The gear control is incorrectly adjusted. 
Procedure: Adjust the gear control.
8.9.6 Fault: Stops under operation. 
Reason: Run out of fuel. 
Procedure: Fill up with petrol.
9 TECHNICAL DATA
Weight:  46 kg 
Type of engine:  4-stroke, Briggs & Stratton 
Spark plug:  Champion QC12YC or the equivalent. 
Power:  4 kW (5.5 hp)
Engine speed:  3400 rpm...

Fig. 1
Fig. 2
10
2116
19
13
15
12
2
3
16
6
7
9
1
12
3
4
5
6
91510
11
12
13
78
14
Fig. 3.
123 4 5a
5b
5c6
Fig. 4. 

Fig. 5.
Fig. 6.
Fig. 8.
RUNCHOKE
12
3 4
Fig. 11a. Fig. 9.
Fig. 10.
RUNCHOKE 
Fig. 11b. Fig. 11c.
Fig. 7. 

A
Fig. 12.
A
Fig. 13.
+1 cm1
Fig. 15.
Fig. 16.
C
5 m m
Fig. 14. Fig. 17.
A