Stiga Cultivator 8214-2213-80 Silex 82R2-H Instructions Manual

STIGA
Silex 82R2-H
8214-2213-80
BRUKSANVISNING
KÄYTTÖOHJEET
BRUGSANVISNING
BRUKSANVISNING
GEBRAUCHSANWEISUNG
INSTRUCTIONS FOR USE
MODE D’EMPLOI
GEBRUIKSAANWIJZING
ISTRUZIONI PER L’USO
INSTRUCCIONES DE USO
INSTRUÇõES DE UTILIZAÇÃO
INSTRUKCJA OBS£UGI
»HC“P”K÷»fl œOÀ‹«Œ¬¿“EÀfl
NÁVOD K POU®ITÍ
HASZNÁLATI UTASÍTÁS
NAVODILA ZA UPORABOSV .... 5
FI ... 12
DA .. 19
NO . 26
DE ... 33
EN... 41
FR.... 48
NL... 55
IT..... 62
ES .... 69
PT ... 77
PL .... 85
RU... 92
CZ 100
HU 107
SL ..114 

2
S
VNO U
T
K
L QF
P G
R
HACDE
FH
I
J
MNO
K
L
G
BY
2
1W
XV
1
23 

3
A
B
C
DV
F
L
E
H
I
J
KKI
R
4
6
85
7
9 

4
U
N OM8 x 45 M8 x 40
12
34
J
K L
M
10
12
1411
13
15 

41
ENGLISHGB
1 SYMBOLS
The following symbols can be found on the rotary 
cultivator/in these instructions. These will provide 
a reminder of the care and attention that is required 
during operation. If any symbol is missing, has 
been damaged or is illegible, it must immediately 
be replaced with a new one.
This is what the symbols mean:
Warning! Read the owner’s manual before 
operating the machine.
Warning! Rotating blade.
Warning! This symbol highlights impor-
tant text in these instructions. Risk of...

42
ENGLISHGB
• Wear tightly fitting clothes and heavy-duty 
shoes which completely cover the feet.
• The tank should only be half full when operat-
ing on slopes. Petrol can leak out.
• The engine must be stopped in the following 
circumstances: 
• When the machine is left unattended 
• Before the machine is filled up with petrol 
• Always make sure you have a good footing, es-
pecially on slopes. 
• Check that no one is in front of you or beside 
you when starting the blades. Keep a steady 
grip on the...

43
ENGLISHGB
3.5 Throttle cable1. Install the throttle cable on the engine if not al-
ready installed. See the engine supplier’s man-
ual.
2. Pull up the cable under the support’s (5:E) up-
per section and over the screws in fig. 7.
3. Install the cable in the throttle. See fig. 11.
3.6 CablesPull up the cables under the cover under the sup-
port’s (5:E) upper section and over the screws in 
fig. 7. Then install the ends into the relevant con-
trol as follows:
1. Install the cable ends into the relevant...

44
ENGLISHGB
4.10 Oil draining (1:L)The screw is removed when used engine oil is to be 
drained.
4.11 Auxiliary wheel (1:M)The auxiliary wheel is intended to assist transport 
of the machine and has two positions.
The auxiliary wheel must be folded up 
when carrying out work.
The auxiliary wheel must be down when 
transporting.
The auxiliary wheel is folded up and down as fol-
lows:
1. Pull out the auxiliary wheel stay to the left in the 
driving direction of the machine. See fig. 2.
2. Raise the...

45
ENGLISHGB
Oil-mixed petrol designed for 2-stroke engines 
must never be used.
Filling
Read and understand all safety instruc-
tions.
If the engine has been running, wait a 
few minutes until it has cooled before 
filling up.
Fill carefully to prevent the spillage of 
fuel.
Move the rotary cultivator at least 3 me-
tres from the filling site before starting.
Fill as follows:
1. Clean around the fuel cap.
2. Unscrew the filler cap.
3. Fill using a funnel or use a filler can with spout 
to prevent...

46
ENGLISHGB
7 MAINTENANCE
WARNING!Repairs must be carried out 
by the dealer. Otherwise the guarantee 
becomes invalid.
WARNING!Before carrying out repairs 
and maintenance, the spark plug con-
nection must be disconnected.
7.1 Periodic maintenanceBefore each operation
• Check for fuel leaks.
• Check that all screws are tightened.
After each operation
• Clean the rotary cultivator.
• Check for fuel leaks.
Every 25 operating hours and every 3 months
• Check, clean or replace the air filter.
• Check that...