Home
>
Standard Horizon
>
Communications receiver
>
Standard Horizon Receiver MST70 Operating Instructions
Standard Horizon Receiver MST70 Operating Instructions
Here you can view all the pages of manual Standard Horizon Receiver MST70 Operating Instructions. The Standard Horizon manuals for Communications receiver are available online for free. You can easily download all the documents as PDF.
Page 1
MST70 Marine AM/FM Cassette Stereo System With NOAA Weather Owner's Manual Marine Division of Yaesu U.S.A.
Page 2
TABLE OF CONTENTS FEATURES............................................................................................1 REPLACEMENT PARTS.......................................................................2 LISTENING TO FM ON YOUR BOAT...................................................2 CASSETTE CARE AND MAINTENANCE.............................................2 REMOVING AND FITTING THE FRONT PANEL.................................3...
Page 3
MST70 Owner’s Manual Page 1
FEATURES
• Detachable Face Panel: Guards against theft by allowing you to remove
the face panel, rendering the player unusable. A carry case for the
detachable face panel is included.
• All Electronic Controls: The Bass, Treble, Volume, Balance and Fader
functions are...
Page 4
Page 4 Owner’s Manual MST70Page 2 Owner’s Manual MST70 REPLACEMENT PARTS PART STANDARD HORIZON PART NUMBER Dust Cover.......................................................................................053002027AFlush Mount...
Page 5
MST70 Owner’s Manual Page1 REMOVAL AND FITTING THE FACE PANEL Removal Before removing the face panel, turn the unit OFF by pressing the POWER button. 1. Press the release button to release the left-hand end of the face panel. 2. Lift the front panel out towards you. After removing the face panel, place it inside the supplied case to protect...
Page 6
Page 4 Owner’s Manual MST70 Refitting 1. Make sure the face panel is the right way up as it cannot be attached upside down. 2. Fit the right-hand end of the face panel into the tabs inside the right-hand end of the unit. 3. Gently press the left-hand end of the face panel into place until it clicks. Only light pressure is required....
Page 7
MST70 Owner’s Manual Page 5 4. Screw or bolt the bracket into position. The mounting method will depend on the material to which the bracket is being attached. 5. Slide the MST70 back into the bracket slots and adjust to the required position before tightening the gimbal knobs. 6. Connect the antenna lead and electrical wiring as described later. Flush...
Page 8
Page 6 Owner’s Manual MST70 3. Remove the escutcheon and measure the marks. They should measure approximately 7.87'' wide and 2.76'' high. If not, check the diagram above to ensure that you measured the correct edge. 4. If your measurements are correct, carefully cut the slot around the marked lines, ensuring that you maintain the curves in each...
Page 9
MST70 Owner’s Manual Page 7 ELECTRICAL WIRING DC Connections Caution: The MST70 is designed for vessels with a 12 Volt negative ground electrical system only! Referring to the wiring diagram: 1. Connect the Red wire directly to the positive terminal of the vessel’s battery, or to a point which has +12 Volts available at all times. This lead maintains the memories within...
Page 10
Page 8 Owner’s Manual MST70 your battery could vary depending on it’s Amp-hour rating and condition. If you do not run your boat’s motor regularly or your battery is not kept charged between outings (e.g. Solar or wind charger), we recommend you disconnect the Red lead each time you secure your boat. This is easily done by connecting the Red lead via a Master switch which can be...