Sony Projector VPL-CX236 User Manual

41Specifications
Others
INPUT OUTPUT 
(Computer/video)INPUT ARGB/YPBPR input connector: Mini D-sub 15 pin 
female, G with sync/Y: 1 Vp-p ± 2 dB, sync negative, 
75 ohms terminated, RGB/P
BPR: 0.7 Vp-p ± 2 dB, 
75 ohms terminated, Sync signal: TTL level high 
impedance, positive/negative
Audio input connector: Stereo mini jack, rated input 
500 mVrms, input impedance more than 47 kohms
INPUT B RGB input connector: Mini D-sub 15-pin female,  
RGB: 0.7 Vp-p ± 2 dB, 75 ohms terminated, Sync signal: 
TTL...

42Specifications
*1: For details, refer to “Acceptable Input Signals” on page 44.
*2: Information on accessories in this manual is current as of October 2014.
Design and specifications of the unit, including the optional accessories, are subject to change 
without notice.Power 
consumptionVPL-CX236:
100 V AC: 350 W
220 V AC: 330 W
VPL-CW256:
100 V AC: 346 W
220 V AC: 326 W
VPL-CX276:
100 V AC: 389 W
220 V AC: 367 W
VPL-CW276:
100 V AC: 395 W
220 V AC: 372 W
Power Consumption
(Standby mode)AC 100 V to 120...

43Specifications
Others
Pin assignment
RGB input connector (Mini D-sub 
15-pin, female)
RS-232C connector (D-Sub 9-pin, 
male)
1 Video input 
(Red) R9 Power supply 
input for DDC
2 Video input 
(Green) G10 GND
3 Video input
(Blue) B11 GND
4 GND 12 DDC/SDA
5 RESERVE 13 Horizontal sync 
signal
6 GND (R) 14 Vertical sync 
signal
7 GND (G) 15 DDC/SCL
8 GND (B)
1NC 6NC
2RXDA 7RTS
3TXDA 8CTS
4DTR 9NC
5 GND
51
9
6 

44Specifications
Acceptable Input Signals
Computer signal
Video signal
 When a signal other than the signals listed in 
table is input, the picture may not be 
displayed properly.
 An input signal meant for screen resolution 
different from that of the panel will not be 
displayed in its original resolution. Text and 
lines may be uneven.
ResolutionfH [kHz]/
fV [Hz]Input connector
RGBHDMI
640 × 350 31.5/70
z
37.9/85z
640 × 400 24.8/56z
31.5/70z
37.9/85z
640 × 480 31.5/60zz
35.0/67z
37.9/73z
37.5/75z...

45Projection Distance and Lens Shift Range
Others
Projection Distance and Lens Shift Range
The following describes the projection distance and height from lens center to bottom of screen 
by each projected screen size.
The projection distance is the distance between the front of the lens and the surface of the 
projected image.
Height H is the height from the bottom of the projected image (top for ceiling mount) to A 
(determined by drawing a perpendicular line from lens center to projected image...

46Projection Distance and Lens Shift Range
The lens shift range represents the distance in percent (%) by which the lens can be shifted from 
the initial position of the projected image, with full width or full height of the projected image 
regarded as 100%.
VS
UP: Vertical lens shift range (up) [%]
VSDN: Vertical lens shift range (down) [%]
HS
R: Horizontal lens shift range (right) [%]
HSL: Horizontal lens shift range (left) [%]
Projection distance/Projection distance formula
Projection distance...

47Projection Distance and Lens Shift Range
Others
Expression#1 Unit: m (inches)
Expression#2
Projection distance (VPL-CW256)Unit: m (inches)
Projection distance formula (VPL-CW256)
D: Projected image size (Diagonal)
H: Distance between the bottom edge of the image and the center of the lens
Expression#1 Unit: m (inches)
Expression#2
Projection Distance L (min.)Projection Distance L (max.)
L=0.033708 × D – 0.0490
(L=1.327085 × D – 1.9300)L=0.049125 × D – 0.0482
(L=1.934037 × D – 1.8982)
Height H from...

48Projection Distance and Lens Shift Range
Projection distance/Projection distance formula
Projection distance (VPL-CX276)Unit: m (inches)
Projection distance formula (VPL-CX276)
D: Projected image size (Diagonal)
H: Distance between the bottom edge of the image and the center of the lens
Expression#1 Unit: m (inches)
Expression#2
Projection distance (VPL-CW276) Unit: m (inches)
Projected image sizeProjection Distance LHeight H from lens center to bottom of screen
Diagonal DWidth × Height
80 inch (2.03...

49Projection Distance and Lens Shift Range
Others
Projection distance formula (VPL-CW276)
D: Projected image size (Diagonal)
H: Distance between the bottom edge of the image and the center of the lens
Expression#1 Unit: m (inches)
Expression#2
Lens shift range
Projection Distance L (min.)Projection Distance L (max.)
L=0.028357 × D – 0.0490
(L=1.116434 × D – 1.9300)L=0.041327 × D – 0.0482
(L=1.627044 × D – 1.8982)
Height H from lens center to bottom of screen
H=0.00000 × D+0.00000 (H=0.00000 × D+0.00000)...

50Dimensions
Dimensions
406.0 (15 31/32) Center of the lens Front
Unit: mm (inches) 104.5 (4 1/8)
63.0 (2 
15/32)
Side
Unit: mm (inches) 330.5 (13)
113.0 (4 
7/16)
122.3 (4 
13/16)