Sony Klv 22bx300 Operating Instructions

							31 GB
KLV-40BX400/KLV-40BX401/KLV-32/26/22BX300/KLV-32/26/22BX301
4-168-830-11(2)
Additional Information
The TV turns off automatically (the TV enters 
standby mode)
 Check if the “Sleep Timer” is activated, or confirm the 
“Duration” setting of “On Timer” (page 25).
 Check if the “Idle TV Standby” is activated (page 26).
The TV turns on automatically
 Check if the “On Timer” is activated (page 25).
Some input sources cannot be selected
 Select “Video Labels” and cancel “Skip” of the input 
source (page 25).
The remote does not function
 Replace the batteries.
HDMI equipment does not appear on “HDMI Device 
List”
 Check that your equipment is compatible with Control for 
HDMI.
Cannot select “Off” in “Control for HDMI”
 If you have connected any audio system that is compatible 
with Control for HDMI, you cannot select “Off” in this 
menu. To change the audio output to the TV speaker, 
select “TV Speaker” in the “Speaker” menu (page 21).
Lost password
 Select the “PIN Code” settings on the “Parental Lock” 
settings, then enter the following master password: 9999. 
This password clears your previous password and allows 
you to enter a new password (page 24).
General
 
						

							© 2010 Sony Corporation   Printed in Malaysia
(2)
Customer supportInstructions on “Installing the Wall-Mount Bracket” are 
not supplied in the form of a separate leaflet with this TV. 
These installation instructions are included within this 
TV’s instructions manual.
Printed on 70% or more recycled paper using VOC 
(Volatile Organic Compound)-free vegetable oil 
based ink.
KLV-40BX400/KLV-40BX401/KLV-32/26/22BX300/KLV-32/26/22BX301
4-168-830-11(2)
Specifications
Design and specifications are subject to change without notice.
Model nameKLV-40BX400
KLV-40BX401KLV-32BX300
KLV-32BX301KLV-26BX300
KLV-26BX301KLV-22BX300
KLV-22BX301
System
Panel system
LCD (Liquid Crystal Display) Panel
TV systemB/G, I, D/K, M
Colour/video systemPAL, PAL60 (only video input), SECAM, NTSC4.43 (only video input), NTSC3.58
Channel coverageB/G: VHF: E2 to E12/ UHF: E21 to E69/ CATV: S01 to S03, S1 to S41
         VHF: 1 to 11/UHF: 21 to 69/ CATV: S01 to S03, S1 to S41 (New Zealand only)
I:      UHF: B21 to B69/ CATV: S01 to S03, S1 to S41
D/K: VHF: C1 to C12, R1 to R12/ UHF: C13 to C57, R21 to R60/ CATV: S01 to S03, S1 to S41, Z1 to Z39
M:    VHF: A2 to A13/ UHF: A14 to A79/ CATV: A8 to A2, A to W+4, W+6 to W+84
Sound output10 W + 10 W 8 W + 8 W 5 W + 5 W
Input/Output jacks
Antenna
75 ohm external terminal for VHF/UHF
1Video input (phono jacks)/Monitor out
1Audio input (phono jacks)/Monitor out
 2Video input (phono jack)
 2Audio input (phono jacks)
 COMPONENT IN/
 3 COMPONENT IN
Supported formats: 1080p, 1080i, 720p, 576p, 576i, 480p, 480i
Y: 1 Vp-p, 75 ohms, 0.3V negative sync/P
B/CB: 0.7 Vp-p, 75 ohms/PR/CR: 0.7 Vp-p, 75 ohms
 3 Video input (phono jack)
 COMPONENT INAudio input (phono jacks)
HDMI IN 1, 2Video: 1080/24p, 1080p, 1080i, 720p, 576p, 576i, 480p, 480i
Audio: Two channel linear PCM: 32, 44.1 and 48 kHz, 16, 20 and 24 bits
 Analogue audio input (minijack) (HDMI IN 2 only)
PC Input (see page 22)
PC IN PC Input (D-sub 15-pin) (see page 22)
G: 0.7 Vp-p, 75 ohms, non Sync on Green/B: 0.7 Vp-p, 75 ohms/
R: 0.7 Vp-p, 75 ohms/HD: 1-5 Vp-p/VD: 1-5 Vp-p
PC IN PC audio input (minijack)
USB port
Power and others
Power requirements
110–240 V AC, 50/60 Hz
220-240 V AC, 50/60 Hz (New Zealand, South Africa and Tunisia only)
Screen size 
(measured 
diagonally)inches40 32 26 22
cm (Approx.)101.6 80.0 66.1 54.8
Display resolution1,920 pixels (horizontal) × 
1,080 lines (vertical)1,366 pixels (horizontal) × 768 lines (vertical)
Power consumptionIndicated on the rear of the TV.
Dimensions 
(Approx.) 
(w × h × d)with stand (mm)996 × 635 × 250 804 × 532 × 220676 × 459 × 220 575 × 398 × 215
without stand (mm)996 × 598 × 99 804 × 497 × 96 676 × 423 × 97 575 × 361 × 88
Mass 
(Approx.)with stand (kg)15.6 10.78.8 6.6
without stand (kg)13.6 9.27.3 6.0
Optional 
accessoriesWall-Mount 
BracketSU-WL500 or SU-WL50B SU-WL100