Sony Kdl 46w5500 Operating Instructions

41 GB
Using Menu Functions
Digital Manual 
TuningTunes the digital channels manually.
1Press the number buttons to enter the channel number 
you want to tune, or press F/f.
2When the available channels are found, press F/f to 
select the channel you want to store, then press  .
3Press F/f to select the channel number where you want 
to store the new channel, then press  .
Repeat the above procedure to tune other channels.
LNAImproves the picture quality of the channel (noisy picture) 
when the broadcast...

42 GB
Network Settings 
Network IP Address 
SettingsManual
Allows you to set the network settings according to your 
network environment. 
DHCP (DNS manual)
Automatically acquires the network settings except for DNS 
server settings. You can manually set the DNS settings.
DHCP (DNS automatic)
Automatically acquires the network settings through the 
Dynamic Host Configuration Protocol server function of the 
router or Internet service provider.
TestDiagnoses whether the network is correctly connected.
IP...

43 GB
Additional Information
Additional Information
Installing the Accessories (Wall-Mount Bracket)
To Customers:
For product protection and safety reasons, Sony strongly recommends that installing of your TV be 
performed by Sony dealers or licensed contractors. Do not attempt to install it yourself.
To Sony Dealers and Contractors:
Provide full attention to safety during the installation, periodic maintenance and examination of this 
product.
Your TV can be installed using the SU-WL500/SU-WL50B...

44 GB
Unit: mm
Figures in the above table may differ slightly depending on the installation.
The wall that the TV will be installed on should be capable of supporting a weight of at least four times that of 
the TV. Refer to “Specifications” (page 46) for its weight.
TV installation dimensions table
Model Name
Display 
dimensionsScreen 
centre 
dimensionLength for each mounting angle
Angle (0°)Angle (20°)
ABCDEFGH
SU-
WL500SU-
WL50BSU-
WL500SU-
WL50BSU-
WL500SU-
WL50BSU-WL500 only
KDL-46W55001,123 725 84...

45 GB
Additional Information
Screw and Hook locations diagram/table
Model NameScrew locationHook location
SU-WL500 SU-WL50B SU-WL500 SU-WL50B
KDL-46W5500/46WE5/40W5500/40WE5 d, g d, i b
KDL-32W5500 e, g e, h c
Screw location
When installing the Mounting Hook on the TV.Hook location
When installing the TV onto the Base Bracket.
b a*
c
* Hook location “a” cannot be used for 
the models.
abccba
SU-WL500: 
Screw location SU-WL50B: 
When installing the Mounting Hook on the TV.
b a*
c Hook location
When...

46 GB
Specifications
Model nameKDL-32W5500KDL-40W5500KDL-40WE5KDL-46W5500KDL-46WE5
System
Panel system
LCD (Liquid Crystal Display) Panel
TV systemAnalogue: B/G, I, D/K
Digital: DVB-T
Colour/video systemAnalogue: PAL, PAL60 (only video input), SECAM, NTSC3.58, NTSC4.43 (only video input)
Digital:  MPEG-2 MP@ML/HL (Australian model), 
MPEG-2 MP@ML/HL, H.264/MPEG-4 AVC MP/HP@L4 (New Zealand and 
Singaporean model)
Channel coverageAnalogue:B/G: VHF: E2–E12/UHF: E21–E69/CATV: S01–S03, S1–S41
VHF: 0–12, 5A,...

47 GB
Additional Information
Design and specifications are subject to change without notice.
PC input signal reference chart for  PC and HDMI IN 1, 2, 3, 4 
* 1080p timing when applied to the HDMI input will be treated as a video timing and not a PC timing. This 
affects the “Video Settings” menu and “Screen” menu settings. 
To view PC contents, set “Wide Mode” to “Full” and “Display Area” to “Full Pixel.”
~
 This TV’s PC input does not support Sync on Green or Composite Sync.
 This TV’s PC input does...

48 GB
Troubleshooting
Check whether the 1 (standby) indicator is flashing in red.
When the 1 (standby) indicator is flashing
The self-diagnosis function is activated. 
1Count how many times the 1 (standby) indicator flashes between each two second break.
For example, the indicator may flash three times, go off for two seconds, then flash again three 
times.
2Press 1 on the TV to turn it off, disconnect the mains lead/AC power cord, and inform your 
dealer or Sony service centre of how the indicator...

49 GB
Additional Information
The picture from equipment 
connected to the  1 or 2 
sockets/jacks is not displayed 
in colour, or is displayed in 
irregular colours. Check the connection of the  1 or 2 sockets/jacks and check if the 
sockets/jacks are firmly seated in their respective sockets/jacks.
No picture from the connected 
equipment appears on the 
screen. Turn the connected equipment on.
 Check the cable connection.
 Press   to display the list of inputs, then select the desired input.
 Correctly...

50 GB
The server cannot be found, a 
list cannot be retrieved, and 
playback fails. Once server settings are changed, turn the TV off and on by pressing 1 
on the TV.
 Execute “Server Diagnostics” (page 29).
When using a PC as the server
 Check if the PC is turned on. Do not turn off the PC while accessing.
 If security software is installed on the PC, be sure to allow connections 
from external devices. For details, refer to the manual supplied with your 
security software.
 The load on the PC may be...