Sony Kdl 46hx700 Operating Instructions

							4-174-286-13(1)
LCD 
Digital Colour TV
Operating Instructions
Setting Up
Watching TV
Additional Information
KDL-55HX700 / 55EX500 / 46HX700 / 46EX500 / 40HX700 / 40EX500 / 40EX400
KDL-32EX500 / 32EX400
 
						

							2GB
IntroductionThank you for choosing this Sony product. 
Before operating the TV, please read this 
manual thoroughly and retain it for future 
reference.
~
•The illustrations used in this manual are 
of the KDL-40EX500 unless otherwise 
state.
In this manual, following models are 
described as HX700 models.
KDL-55/46/40HX700
Following models are described as 
EX500 models.
KDL-55/46/40/32EX500
Following models are described as 
EX400 models.
KDL-40/32EX400
Trademark information
 is a registered trademark of the DVB 
Project
HDMI, the HDMI logo and High-
Definition Multimedia Interface are 
trademarks or registered trademarks of 
HDMI Licensing LLC.
DLNA and DLNA CERTIFIED are 
trademarks and/or service marks of Digital 
Living Network Alliance.
DivX® is a video file compression 
technology, developed by DivX, Inc.DivX, 
DivX Certified, and associated logos are 
trademarks of DivX, Inc. and are used 
under license.
ABOUT DIVX VIDEO: DivX® is a digital 
video format created by DivX,Inc. This is 
an official DivX Certified device that plays 
DivX video. Visit www.divx.com for more 
information and software tools to convert 
your files into DivX video.
ABOUT DIVX VIDEO-ON-DEMAND: 
This DivX Certified® device must be 
registered in order to play DivX Video-on-
Demand (VOD) content. To generate the 
registration code, locate the DivX VOD 
section in the device setup menu. Go to 
vod.divx.com with this code to complete 
the registration process and learn more 
about DivX VOD.
Manufactured under license from Dolby 
Laboratories. Dolby and the double-D 
symbol are trademarks of Dolby 
Laboratories.
“BRAVIA” and   are trademarks 
of Sony Corporation.
“XMB” and “xross media bar” are 
trademarks of Sony Corporation and Sony 
Computer Entertainment Inc.
Notes for Australia and 
New Zealand model
This product is ENERGY RATING 
qualified in the “Home” mode. ENERGY 
RATING is a program designed to promote 
energy efficient products and practices.
 When the TV is initially set up, it is 
designed to meet ENERGY RATING  
requirements while maintaining 
optimum picture quality.
 Changes to certain features, settings, and 
functionalities of this TV (e.g. TV Guide, 
Picture/Sound, Eco-Setting) can slightly 
change the power consumption.
Depending upon such changed settings 
(e.g. “Shop” mode), the power 
consumption may vary which possibly 
could exceed the stated energy rating.
To reset the TV to ENERGY RATING 
qualified settings, select “Home” mode 
from the initial set-up procedure in 
“Factory Settings” under the “Set-up” 
menu.
IMPORTANT 
INFORMATION
If a television is not positioned in a 
sufficiently stable location, it can be 
potentially hazardous due to falling. Many 
injuries, particularly to children, can be 
avoided by taking simple precautions such 
as: 
 Using cabinets or stands recommended 
by the manufacturer of the television.
 Only using furniture that can safely 
support the television.
 Ensuring the television is not 
overhanging the edge of the supporting 
furniture.
 Not placing the television on tall 
furniture (for example, cupboards or 
bookcases) without anchoring both the 
furniture and the television to a suitable 
support.
 Not standing the televisions on cloth or 
other materials placed between the 
television and supporting furniture.
 Educating children about the dangers of 
climbing on furniture to reach the 
television or its controls.
Notice for customers in 
the South Africa
The Euro/South Africa converter plug 
should be fitted as follows.
1Insert the power 
supply or CEE7 plug 
in to the converter 
plug.
2Use an appropriate 
screwdriver to attach 
the screw tightly 
without damaging 
the screw head.
3TEST: Grip the 
converter plug, and 
pull the VDE cord 
set/transformer to 
ensure it is fully 
secure, if not then increase the torque 
setting and further tighten. 
Re-test.
The converter plug is now ready for 
use.
 
						

							3GB
Table of Contents
Checking the accessories.............................................................................................................. 3
Inserting batteries into the remote ................................................................................................. 3
Setting Up
Attaching the Table-Top Stand ...................................................................................................... 4
Connecting an antenna (aerial)/cable/VCR ................................................................................... 5
Preventing the TV from toppling over ............................................................................................6
Bundling the cables ....................................................................................................................... 6
Performing the initial set-up ........................................................................................................... 7
Detaching the Table-Top Stand from the TV ................................................................................. 7
Watching TV
To watch programmes ................................................................................................................... 8
To utilise the TVs features ............................................................................................................ 8
To use i-Manual ............................................................................................................................. 9
Additional Information
Troubleshooting ........................................................................................................................... 10
Specifications .............................................................................................................................. 11
Installing the Accessories (Wall-Mount Bracket) ......................................................................... 13
Safety Information ....................................................................................................................... 16
Precautions.................................................................................................................................. 17
Checking the accessories
AC power cord (mains lead)
(for KDL-55/46EX500 and KDL-55/
46HX700)
Cable holder (1)
(for HX700 models only)
Remote (1)
Size AAA batteries (R3 type) (2)
Table-Top Stand (1)*
Fixing screws for stand (M5 × 16) (4)
Assembling screws for stand 
(M5 × 16) (4)
(only for KDL-40/32EX500 and KDL-
40HX700)
Assembling screws for stand 
(M4 × 10) (3)
(only for EX400 models)
* Disassembled except for 55-inch and 46-inch 
TVs. Refer to the supplied Table-Top Stand leaflet 
to assemble the stand.
Inserting batteries into the 
remote
RM-GD009/GD014 remote
1Remove the protection sheet.
2Push and slide the cover upward.
RM-GD015 remote
~
See your remote for the model number.
 Operating instructions are built into your BRAVIA TV. Refer to “To use i-Manual” for operation (page 9).
 Before operating the TV, please read “Safety Information” (page 16). Retain this manual for future reference.
Push and lift the cover to open.
 
						

							4GB
Setting Up
Attaching the Table-Top 
Stand
~
For best picture quality, do not expose the screen 
to direct illumination or sunlight.
If the TV is brought directly from a cold to a warm 
location, or is placed in a very damp room, or is 
placed in a room in which heating has just been 
turned on, moisture may condense on the surface 
or inside the TV. Should this occur, turn off the 
TV and leave the TV off until the moisture 
evaporates, and then the TV can be used. If you 
notice moisture condensation between the glass 
panel and the LCD, turn on the TV and the 
condensation will evaporate after the TV has 
warmed up.
1Refer to the supplied Table-Top Stand 
leaflet for proper attachment for some 
TV models.
2Place the TV set on the Table-Top 
Stand.
3Fix the TV to the Table-Top Stand 
according to the arrow marks   that 
guide the screw holes using the 
supplied screws.
~
If using an electric screwdriver, set the tightening 
torque at approximately 1.5 N·m {15 kgf·cm}.
Adjusting the viewing angle of 
the TV (HX700 models only)
This TV can be adjusted within the angles 
shown below.
~
To return to 0°, reverse the above procedure.
14
23
Remove screw as 
shown.6º 0º
Install screw into 
the top screw hole 
of the Table-Top 
Stand.
Slide in. Lift up and tilt.
 
						

							5GB
Connecting an antenna 
(aerial)/cable/VCR
Connecting an antenna (aerial)/cableConnecting an antenna (aerial)/cable 
and VCR
~
When connecting an antenna (aerial) cable (not 
supplied), an adaptor (not supplied) may be 
required (Australian model and New Zealand 
model only).
Antenna (aerial) cable 
(not supplied)
Antenna 
(aerial) cable 
(not supplied)
Antenna 
(aerial) cable 
(not supplied) AV cable 
(not supplied)
VCR
Setting Up
 
						

							6GB
Preventing the TV from 
toppling over
1Install a wood screw (4 mm in 
diameter, not supplied) in the TV stand.
2Install a machine screw (M4 × 16, not 
supplied) into the screw hole of the TV.
3Tie the wood screw and the machine 
screw with a strong cord (not supplied).
z
An optional Sony support belt kit is used to secure 
the TV. Contact your nearest Sony service centre 
to purchase a kit. Have your TV model name 
ready for reference.
Bundling the cables
~
A cable holder is available for HX700 models. To 
bundle the cables, follow steps 2 to 4.
~
Do not bundle the AC power cord (mains lead) 
together with other cables.
*For KDL-55/46EX500 
and KDL-55/46HX700
*
 
						

							7GB
Performing the initial set-up
1Connect the TV to your AC power 
outlet (mains socket).
2For HX700 models, check the 
ENERGY SAVING SWITCH setting 
is on (
z).
3Press 1 on the TV.
When you switch on the TV for the first 
time, the Language menu appears on the 
screen.
Follow the instructions on the screen.
Programme Sorting: Changes the order of 
analogue channels stored in the TV.
1Press F/f to select the channel you want 
to move to a new position, then press  .
2Press F/f to select the new position for 
the channel, then press  .
~
You can also tune channels manually.
Detaching the Table-Top 
Stand from the TV
~
Remove the screws guided by the arrow marks   
of the TV.
Do not remove the Table-Top Stand for any 
reason other than to install corresponding 
accessories on the TV.
4
For HX700 models 
onlySetting Up
 
						

							8GB
Watching TV
To watch programmes
To utilise the TVs features
z
The number 5, N, PROG + and AUDIO 
buttons on the remote have a tactile dot. 
Use the tactile dots as a reference when 
operating the TV.
1Turn on the TV.
1For HX700 models, switch ENERGY 
SAVING SWITCH on.
2Press 1 on the TV to turn on the TV.
2Select a mode.
3Select a TV channel.
Using Digital Electronic Programme 
Guide (only available for EPG 
supported countries/regions)
Press GUIDE in digital mode to display the 
programme guide.
HOME button
Press to display various operation and setting 
screens.OPTIONS button
Press to display convenient functions based 
on the current input or content.
GUIDE
HOME
2
3
OPTIONS
Settings
TVSystem Settings
Picture
Sound
BRAVIA ENGINE 3 PRO
Add to Favourites
Lock/Unlock
PAP
Motionflow
Sleep Timer
Headphone Volume
Speaker
System Information
 
						

							9GB
To use i-Manual
xWelcome to i-Manual
x“BRAVIA” TV Features
xWatching TV
Introduces convenient features such as EPG 
Guide, Favourites, etc.
xUsing the HOME Menu
Customise your TV settings, etc.xFun Features with Connected 
Equipment
Introduces how to connect optional equipment.
xParts Description
xTroubleshooting
Find solutions for your problem.
xIndex
~
Images and illustrations may differ from what is displayed on the screen.
Operating instructions are built into your BRAVIA 
TV and can be displayed on the screen.
You can browse your i-Manual anytime you need 
to find the varieties of convenient functions.
~
This feature is unavailable when you select Arabic or 
Persian.
1Press i-MANUAL.
2Press G/g/F/f/  to select items.
1
2
Watching TV
 
						

							10GB
Additional Information
Troubleshooting
Check whether the 1 (standby) indicator is flashing in red.
When the 1 (standby) indicator is flashing
The self-diagnosis function is activated. 
1Count how many times the 1 (standby) indicator flashes between each three second 
break.
For example, the indicator may flash three times, go off for three seconds, then flash again three 
times.
2Press 1 on the TV to turn it off, disconnect the AC power cord (mains lead), and inform 
your dealer or Sony service centre of how the indicator flashes (number of flashes).
When the 1 (standby) indicator is not flashing
1Check the items in the tables below. (Also refer to “Troubleshooting” in the i-Manual.)
2If the problem persists, have your TV serviced by qualified service personnel.
ConditionExplanation/Solution
Picture
There is no picture (screen 
is dark) and no sound.Check the antenna (aerial)/cable connection.
Connect the TV to the AC power (mains), and press 1 on the TV.
If the 1 (standby) indicator lights up in red, press "/1.
Tiny black points and/or 
bright points appear on the 
screen.The screen is composed of pixels. Tiny black points and/or bright 
points (pixels) on the screen do not indicate a malfunction.
General
The TV’s power cannot be 
turned on. (for HX700 
models only)Check if ENERGY SAVING SWITCH is on.
The TV turns off 
automatically (the TV 
enters standby mode).Check if the “Sleep Timer” is activated, or confirm the 
“Duration” setting of “On Timer”.
Check if the “Idle TV Standby” is activated.
The remote does not 
function.Replace the batteries.
Your TV may be in SYNC mode.
Press SYNC MENU, select “TV Control” and then select “Home 
(Menu)” or “Options” to control the TV.
The “Parental Lock” password 
has been forgotten.Enter 9999 for the PIN code. (PIN code 9999 is always accepted.)