Home > Sony > Home Theater System > Sony Dav Dz290 Operating Instructions

Sony Dav Dz290 Operating Instructions

Here you can view all the pages of manual Sony Dav Dz290 Operating Instructions. The Sony manuals for Home Theater System are available online for free. You can easily download all the documents as PDF.

Page 11

11GB
Getting Started
Attaching the foot pads to the subwoofer
Attach the foot pads (supplied) to the bottom of the subwoofer to stabilize the subwoofer and prevent 
it from slipping.
,
Remove the foot pads from 
the protective cover.
 

Page 12

12GB
Getting Started
Before connecting the speakers, attach the speaker stand to the speaker.
(For the front speakers)
Use the parts as follows:
 Front speakers (2)
 Speaker cords (2, red/white)
 Stand bases (2)
 Screws (2)
For details of how to connect the speaker cords to the SPEAKER jacks, see page 17.
Note Spread a cloth on the floor to avoid damaging the floor when you assemble the speakers.
Tip You can use the speaker without the speaker stand by installing it on the wall (page 15).
1Thread the...

Page 13

13GB
Getting Started
2Connect the speaker cords to the speaker.
Be sure to match the speaker cords to the appropriate terminals on the speakers: the speaker cord 
with the color tube to 3, and the speaker cord without the color tube to #.
3Attach the stand base to the speaker by engaging the protrusions on the stand base in 
the holes of the speaker securely.
You can change the angle of the speaker depending on which set of holes you use.
Color tube
Front left speaker (L): White
Front right speaker (R):...

Page 14

14GB
Getting Started
4Move the speaker cord so that it does not block the screw hole for securing the screw.
5Secure the stand base with the screw.
Fully-assembled illustration
Speaker cord
,
Screw
WhiteRed Front left speaker (L): 
White labelFront right speaker (R): 
Red label
 

Page 15

15GB
Getting Started
Caution
 Contact a screw shop or installer for information regarding the wall material or screws to be used.
 Use screws that are suitable for the wall material and strength. As a plaster board wall is especially fragile, attach 
the screws securely to a beam. Install the speakers on a vertical and flat wall where reinforcement is applied.
 Sony is not responsible for accidents or damage caused by improper installation, insufficient wall strength or 
improper screw installation,...

Page 16

16GB
Getting Started
3Hang the speakers on the screws.
5 mm 
(7/32 inch)
10 mm
(
13/32 inch)Hole on the back of 
the speaker
Rear of the speaker
 

Page 17

17GB
Getting StartedStep 2: Connecting the System
For connecting the system, read the information on the following pages.
Do not connect the AC power cord (mains lead) of the unit to a wall outlet (mains) until all the other 
connections are made.
Note When you connect another component with a volume control, turn down the volume of the other components to a 
level where sound is not distorted.
The connector of the speaker cords and the color tube are color-coded depending on the type of speaker....

Page 18

18GB
Getting Started
This connection sends a video signal to the TV.
Depending on the jacks on your TV, select the connection method.
* The HDMI cable is supplied with Singapore, Indonesian, Malaysian, Hong Kong, Filipino, Mexican, Argentine, 
and Latin American models only.
Method 1: Video cord (A) connection
This is the basic connection.
Method 2: HDMI* cable (B) and video cord (A) connection
If your TV has an HDMI jack, connect to the TV both with an HDMI cable and video cord. Picture 
quality will be...

Page 19

19GB
Getting Started
To change the color system (PAL or NTSC) (Asian, Australian, Middle 
Eastern, and South African models only)
Depending on the TV to be connected, you may be required to select either PAL or NTSC for the color 
system.
The initial setting of the system for Australian, Middle Eastern, and South African models is PAL.
The initial setting of the system for Asian models is NTSC.
1Turn off the system by pressing "/1.
2Turn on the system by pressing "/1 on the unit while turning...

Page 20

20GB
Getting Started
This connection sends an audio signal to the unit from the TV. To listen to TV sound via the system, 
perform this connection.
Audio cord (D) connection
This connection sends an analog audio signal.
Tip You can connect another component, such as a VCR, digital satellite receiver, or PlayStation, to the TV/VIDEO 
(AUDIO IN R/L) jacks instead of the TV.
Connecting the TV (Audio connection)
CENTERSUBWOOFER
FRONT R FRONT L
SUR RSUR LSPEAKER
H
D
M
I O
U
T
SPEAKER
COAXIAL 75
FM
ANTENNA...
Start reading Sony Dav Dz290 Operating Instructions

Related Manuals for Sony Dav Dz290 Operating Instructions

All Sony manuals