Smeg Sto 905 Instruction Manual

 
 
User instructions   
 
66   
 
  
 GENERAL WARNINGS AND RECOMMENDATIONS FOR CORRECT 
MAINTENANCE:  
• The filters should be cleaned under running water using a stiff 
brush. 
• It is essential to thoroughly clean the filters according to the above 
instructions: the dishwasher cannot function if the filters are clogged. 
• Carefully replace the filters in their seats, to avoid damaging the 
wash pump. 
 
PROLONGED DISUSE:  
• Run the soak program twice in succession. 
• Unplug the power cord from the...

 
 
User instructions   
 
 
67  
 
 
  
  
 If the dishes are not being cleaned properly, check that:  
• the correct amount of detergent has been added; 
• there is regenerating salt inside the special container; 
• the dishes are being loaded correctly; 
• the selected program is suitable for the dish types and their degree 
of soiling; 
• all the filters are clean and positioned correctly; 
• the spray arm nozzles are not obstructed; 
• there is no object obstructing the rotation of the spray arms....

 
 
User instructions   
 
68  
 
 
 
 
 
 
 
 
 
 
6. Troubleshooting 
 
 The dishwasher is capable of signalling a number of faults through the 
simultaneous illumination of several indicator lights, with the following 
meanings: 
 
 
FAULT DESCRIPTION 
E1 
Acquastop failure The anti-flooding system has been activated (for the relevant models only). The system is tripped in case of water leaks. Contact the after-sales service. 
E2 
Safety level The system which limits the water level inside the...

 
 
User instructions   
 
 
69    
 
FAULT DESCRIPTION 
E7 
Turbine flow-regulator malfunction  (for the relevant models only) The appliance is not able to measure the amount of water loaded accurately. Interrupt the program and switch off the dishwasher. Switch the dishwasher back on, program it again and start the washing cycle. If the problem persists, contact the after-sales service. 
E8 
Alternate washing system malfunction Interrupt the program and switch off the dishwasher. Switch the dishwasher...

 
 
User instructions   
 
70  
 
  
 
TECHNICAL DATA 
Width 858 mm 
Depth measured flush with the  outer edge of the control panel 550 mm 
Height  580 mm 
Capacity 12 Standard place settings 
Water supply pressure min. 0,05 - max. 0,9 MPa (min. 0.5 – max. 9 bar) 
Electrical characteristics See rating plate  
 

OK
2 145
7 6910 8
12 1114 15 13
17 1619 20 18
A
A
3
19 510 0372 02
2,5÷3 mm
min. 2,2 - max. 7 kg
min. 1,5 - max. 5 kg

min. 358min. 178 - max.360 mm
max 26 mm (1)1/32
min. 4,8 - pounds
max. 15,5 pounds
min. 3,3 pounds
max. 11 pounds
(7 -14 )1/64 1/64(14 )3/32
(1÷1 1/64)