Smeg St2fabne Instruction Manual

 
User instructions   
 
 
29  Depending on the models, the basket may be equipped with some or all 
of the following accessories: 
-  Supports for cups or long objects (ladles, spoons…), on the left; 
can be tipped to the vertical position when not in use. 
-  Long-stemmed glass holder, on the left; to use, simply lift and 
fix onto the hooks provided. 
-  Cutlery racks, on the right, designed for knives and teaspoons; 
for teaspoons, pull out the sliding support. The racks can be 
tipped to the...

 User instructions    
 
30 
 
 
 
 
 ADJUSTING THE UPPER BASKET 
The height of the top basket can be adjusted to allow large dishes or 
pans to be placed in the bottom basket. 
The adjustment procedure may be type A or B, depending on the 
dishwasher model purchased. 
  
 
 
 
 
 
 Version A: pull-out with adjustment intwo positions.
•  Pull out both the basket guides. 
•  Remove the stops, first releasing them as shown in the diagram. 
•  Pull out the basket. 
•  Fit the upper or lower pair of wheels...

 
User instructions   
 
 
31 
5.  Cleaning and maintenance  
 
Before carrying out any work, always unplug the appliance from the 
electrical supply or switch off the all-pole disconnection device. 
 
5.1  General warnings and recommendations   Avoid the use of acidic or abrasive detergents. Clean the outer surfaces and door-lining of the dishwasher regularly 
using a soft cloth moistened with water or with a normal detergent 
suitable for painted surfaces. Clean the door gaskets with a damp 
sponge....

 User instructions    
 
32   CLEANING THE FILTER UNIT •  It is advisable to periodically inspect the centre filter C and, if 
necessary, to clean it. To remove the filter, grip the tabs, turn them  
anticlockwise and lift upwards; 
•  push the centre filter D from the underside to remove it from the 
micro-filter: 
•  separate the two parts which make up the plastic filter by pressing 
the body of the filter in the zone shown by the arrows; 
•  remove the centre filter by lifting it upwards....

 
User instructions   
 
 
33 
  
  
 
BEFORE STARTING THE DISHWASHER AFTER PROLONGED 
DISUSE: 
 
• Check that there are no deposits of sludge or rust inside the water 
pipe: if there are, allow the water to run from the water supply tap for 
a few minutes. 
• Plug the power cord back into the socket. 
• Reconnect the water intake hose and open the tap again. 
 
 
 
TROUBLESHOOTING MINOR PROBLEMS 
 
In some cases it is possible to remedy minor problems by referring to the 
following instructions: 
 
If...

 User instructions    
 
34  
  
 
If the dishes fail to dry or remain dull, check that: 
 
• there is rinse aid inside the special container; 
• the rinse aid dispenser setting is correct; 
• the detergent used is of good quality and has not lost its 
effectiveness (for example, through incorrect storage, with the box 
left open). 
 
If the dishes show signs of streaking, staining, etc., check that: 
 
• the rinse aid dispenser setting is not too high. 
 
If there are visible traces of rust inside the...

 
User instructions   
 
 
35 
6. Troubleshooting 
 
 The dishwasher is able to indicate a series of malfunctions by 
illuminating a number of lights simultaneously (see key below); “E” or 
“Err” (depending on the model) also appears on the display in the event 
of a malfunction.
 
 
FAULTDESCRIPTION 
 
Acquastop failure 
The anti-flooding system has been activated (for the 
relevant models only). The system is tripped in case 
of water leaks. Contact the after-sales service. 
 
Safety level 
The system...

 User instructions    
 
36 
 
FAULTDESCRIPTION 
 
Turbine flow-regulator malfunction  
(for the relevant models only) 
The appliance is not able to measure the amount 
of water loaded accurately. Interrupt the program 
and switch off the dishwasher. Switch the 
dishwasher back on, program it again and start 
the washing cycle. If the problem persists, contact 
the after-sales service. 
 
Alternate washing system malfunction 
Interrupt the program and switch off the dishwasher. 
Switch the dishwasher...

 
User instructions   
 
 
37 
  
TECHNICAL DATA 
Width 597 ÷ 599 mm 
Depth measured flush with the outer edge of the control panel Free standing: 627/675 mm Semi-integrated: 584/630 mm 
Height (depending on models) Free standing: from 885 mm to 905 mm Semi-integrated: from 820 mm to 910 mm 
Capacity 13 Standard place settings 
Water supply pressuremin. 0,05 - max. 0,9 MPa (min. 0.5 – max. 9 bar) 
Electrical characteristicsSee rating plate 
  
 
 

c:QUOTE CRITICHE DI CONTROLLO :QUOTE CRITICHE DI CONTROLLO
LE AREE O QUOTE MODIFICATE SONO EVIDENZIATE
LE AREE O QUOTE MODIFICATE SONO EVIDENZIATE
DA SPLINE TRATTEGGIATE DA SPLINE TRATTEGGIATE
LE QUOTE O TOLL.MODIF.PER AGGIOR.DEL DIS.AL LE QUOTE O TOLL.MODIF.PER AGGIOR.DEL DIS.AL
PEZZO, SONO PRECEDUTE DA # PEZZO, SONO PRECEDUTE DA #
B A
A:TERMOPLAST./ACCIAIO/ALLUM. A:TERMOPLAST./ACCIAIO/ALLUM.B:GOMMA E ALTRI MATERIALI
B:GOMMA E ALTRI MATERIALI
Approvato:
Approvato:Verifica:
Verifica:
±1,80 ±1,60
±1,60...