Smeg D160121 User Manual

 INSTRUCTION MANUAL 
GUIDE FOR USING THE DISHWASHER AND THE WASHING PROGRAMS  

Contents 
  
 
1   
   
1.
 Safety and operating instructions ___________________________ 2 
2. Installation and hook-up___________________________________ 5 
3. Description of the controls _________________________________ 9 
4. Operating instructions ___________________________________ 19 
5. Cleaning and maintenance _______________________________ 31 
6. Troubleshooting ________________________________________ 35 
 
 
 
 
Thank you for choosing one of our products. 
You are advised to read this manual...

 Safety instructions 
 
 
2  
1.  Safety and operating instructions 
 
 
 THIS MANUAL FORMS AN INTEGRAL PART OF THE APPLIANCE: IT MUST 
ALWAYS BE KEPT INTACT TOGETHER WITH THE DISHWASHER. BEFORE 
USING THE APPLIANCE, CAREFULLY READ ALL THE INSTRUCTIONS 
CONTAINED IN THIS MANUAL.  
INSTALLATION MUST BE PERFORMED BY A QUALIFIED TECHNICIAN, IN 
COMPLIANCE WITH THE REGULATIONS IN FORCE. THIS APPLIANCE IS 
INTENDED FOR DOMESTIC USE, AND COMPLIES WITH THE 2006/95 EC 
AND 2004/108 EC DIRECTIVES CURRENTLY IN...

Safety instructions 
 
 
 
3  
 OBSOLETE APPLIANCES MUST BE RENDERED UNUSABLE. CUT OFF THE 
MAINS POWER CORD AFTER UNPLUGGING IT  FROM THE WALL OUTLET, 
AND MAKE SAFE ANY COMPONENTS WHICH MIGHT BE DANGEROUS FOR 
CHILDREN (LOCKS, DOORS, ETC.). 
 
 THIS APPLIANCE IS MARKED ACCORDING TO THE EUROPEAN DIRECTIVE 
2002/96/EC ON WASTE ELECTRICAL AND ELECTRONIC EQUIPMENT 
(WEEE). 
BY ENSURING THIS PRODUCT IS DISPOSED OF CORRECTLY, YOU WILL 
HELP PREVENT POTENTIAL NEGATIVE CONSEQUENCES FOR THE 
ENVIRONMENT AND...

 Safety instructions 
 
 
4  
 LEANING OR SITTING ON THE DISHWASHER DOOR WHEN OPEN MAY 
CAUSE THE APPLIANCE TO OVERTURN, PUTING PEOPLE AT RISK. 
NEVER LEAVE THE DISHWASHER DOOR OPEN; PEOPLE MIGHT TRIP 
OVER IT. 
 
 DO NOT DRINK THE WATER RESIDUES WHICH MAY BE PRESENT INSIDE 
THE DISHES OR DISHWASHER AT THE END OF THE WASHING PROGRAM 
AND BEFORE THE DRYING CYCLE. 
 
 KNIVES OR OTHER SHARP-ENDED COOKING UTENSILS MUST BE PLACED 
IN THE CUTLERY BASKET BLADE-DOWN, OR LAID HORIZONTAL IN THE 
TOP BASKET. TAKE...

 
 
Installation instructions   
 
 
5  
2.  Installation and hook-up     
Remove the polystyrene basket retainers.  
Position the appliance in the desired place of installation. The back or 
sides of the dishwasher may be placed up against walls or other 
furniture units. If the dishwasher is installed near a heat source, fit the 
special insulating panel to prevent overheating and malfunction of the 
appliance. To ensure stability, install integrated or built-under 
dishwashers only under continuous...

 
 
Installation instructions   
 
6  
    
CONNECTING TO THE WATER SUPPLY  Connect the intake hose to a cold water supply with ¾” 
gas thread, inserting the filter A supplied with the 
dishwasher. Take care to screw the hose firmly into 
place with your hands and then complete by 
tightening about ¼ of a turn with pliers.  In dishwashers equipped with the ACQUASTOP 
device, the filters is already fitted inside the threaded 
ring. 
  
  
 
   
The dishwasher can also be connected to a hot water supply...

 
 
Installation instructions   
 
 
7  2.2 Electrical connection and precautions 
 
 
CHECK THAT THE VOLTAGE AND THE FREQUENCY OF THE MAINS MATCH THE RATINGS ON THE NAME PLATE OF THE APPLIANCE POSITIONED ON THE INNER EDGE OF THE DOOR. 
 
 
THE PLUG ON THE SUPPLY CORD AND THE CORRESPONDING SOCKET OUTLET MUST BE OF THE SAME TYPE AND MEET THE REGULATIONS IN FORCE.  THE PLUG MUST BE ACCESSIBLE AFTER INSTALLATION.  NEVER DISCONNECT THE PLUG BY PULLING ON THE POWER SUPPLY LEAD.  IN THE EVENT OF DAMAGE TO THE...

 
 
Installation instructions   
 
8  
 
 
 
 
 
 
 
 
 
 
 
 
FOR GREAT BRITAIN ONLY: 
 
 THIS APPLIANCE MUST BE EARTHED. 
  Fuse replacement  If the mains lead of this appliance is fitted 
with a BS 1363A 13ampfused plug, to 
change a fuse in this type of plug use an 
A.S.T.A. approved fuse to BS 1362type 
and proceed as follows:  1. Remove the fuse cover A and fuse B. 
2. Fit replacement 13A fuse into fuse 
cover. 
3. Refit both into plug. 
   
   
 
 The fuse cover must be refitted when changing a...