Smeg Blv1ne 1 Instruction Manual

 
 
User instructions   
 
30    
 
 
 
 
 
 
 
 
 
  ADJUSTING THE UPPER BASKET 
 Version A:
 the upper basket can be adjusted in  two positions, 
according to the user’s needs and according to the height of the dishes 
in the lower basket. Proceed as follows: 
 •  pull out the right-hand basket guide; 
•  remove the stop, first releasing it as shown in the diagram; 
•  push the guide to free the wheels; 
•  fit the upper or lower pair of whee ls into the guide, depending on the 
setting required
; 
•...

 
 
 
User instructions   
 31 
 
  
 
 
 
 
 
 
 
Version C: 
the top basket can be set in  three different positions on 
both sides. The rack must be level on both sides. 
 
To raise the basket lift it, pulling on the front edge  (1), to the first or 
second catch depending on the height required. To lower it, pull the 
release lever (2) . 
 
This is also possible with the basket loaded, but in this case when 
lowering the basket it should be held steady with one hand to avoid 
knocking the dishes....

 
 
User instructions   
 
32  
5. Cleaning and maintenance  
 
Before carrying out any work, a lways unplug the appliance from the 
electrical supply or switch off the all-pole disconnection device. 
 
5.1 General warnings and recommendations    Avoid the use of acidic or abrasive detergents.  Clean the outer surfaces and door-lining of the dishwasher regularly 
using a soft cloth moistened with water or with a normal detergent 
suitable for painted surfaces. Clean the door gaskets with a damp 
sponge....

 
 
 
User instructions   
 33   
 
 CLEANING THE FILTER UNIT  •  It is advisable to periodically inspect the centre filter 
C and, if 
necessary, to clean it. To remove the filter, grip the tabs, turn them  
anticlockwise and lift upwards; 
•  push the centre filter  D from the underside to remove it from the 
micro-filter: 
•  separate the two parts which make  up the plastic filter by pressing 
the body of the filter in t he zone shown by the arrows; 
•  remove the centre filter by lifting it upwards....

 
 
User instructions   
 
34   
 
 
  
 
BEFORE STARTING THE DISHWASHER AFTER PROLONGED 
DISUSE: 
 
• Check that there are no deposits of sludge or rust inside the water 
pipe: if there are, allow the water to run from the water supply tap for 
a few minutes. 
• Plug the power cord  back into the socket. 
• Reconnect the water intake hose and open the tap again. 
 
 
 
TROUBLESHOOTING MINOR PROBLEMS 
 
In some cases it is possible to remedy minor problems by referring to the 
following instructions:...

 
 
 
User instructions   
 35 
 
 
  
 
If the dishes fail to dry or remain dull, check that: 
 
• 
there is rinse aid inside the special container; 
• the rinse aid dispenser setting is correct; 
• the detergent used is of good quality and has not lost its 
effectiveness (for example, throu gh incorrect storage, with the box 
left open). 
 
If the dishes show signs of streaking, staining, etc., check that: 
 
• the rinse aid dispenser setting is not too high. 
 
If there are visible traces of rust...

 
 
User instructions   
 
36   
6. Troubleshooting 
 
 The dishwasher is capable of signall ing a number of faults through the 
simultaneous illumination of several i ndicator lights, with the following 
meanings: 
 
FAULT DESCRIPTION 
E1 
Acquastop failure 
The anti-flooding system has been activated (for the 
relevant models only). The system is tripped in case 
of water leaks. Contact the after-sales service. 
E2 
Safety level 
The system which limits the water level inside the 
dishwasher has been...

 
 
 
User instructions   
 37 
 
 
FAULT DESCRIPTION 
E7 
Turbine flow-regulator malfunction  
(for the relevant models only) 
The appliance is not able to measure the amount 
of water loaded accurately. Interrupt the program 
and switch off the dishwasher. Switch the 
dishwasher back on, program it again and start 
the washing cycle. If the problem persists, contact 
the after-sales service. 
E8 
Alternate washing system malfunction 
Interrupt the program and switch off the dishwasher. 
Switch the...

 
 
User instructions    
38    TECHNICAL DATA  Width 600 mm Depth measured flush with the  outer edge of the control panel Free standing: 600 mm Semi-integrated: 584 mm 
Height Free standing: from 885 mm to 905 mm Semi-integrated: from 818 mm to 868 mm Capacity 14 Standard place settings Water supply pressure min. 0,05 - max. 0,9 MPa (min. 0.5 – max. 9 bar) Electrical characteristics See rating plate   
 
 

3 2
19 510 0439 00
45
1
818
868÷818
868÷