SMC Networks Router SMCWBR14T User Manual

TROUBLESHOOTING
A-3
Management Problems
Cannot connect 
using the web 
browser• Be sure to have configured the Barricade with a valid 
IP address, subnet mask, and default gateway.
• Check that you have a valid network connection to the 
Barricade and that the port you are using has not been 
disabled.
• Check the network cabling between the management 
station and the Barricade.
Forgot or lost 
the password• Press the Reset button on the rear panel (holding it 
down for at least six seconds) to restore...

TROUBLESHOOTING
A-4
Wireless Problems
A wireless PC 
cannot associate 
with the 
Barricade.• Make sure the wireless PC has the same SSID settings 
as the Barricade. See “Channel and SSID” on page 25.
• You need to have the same security settings on the 
clients and the Barricade. See “Security” on page 27.
The wireless 
network is often 
interrupted.• Move your wireless PC closer to the Barricade to find 
a better signal. If the signal is still weak, change the 
angle of the antenna.
• There may be...

B-1
APPENDIX B
CABLES
Ethernet Cable
Caution:Do not plug a phone jack connector into an RJ-45 port. For 
Ethernet connections, use only twisted-pair cables with RJ-45 
connectors that conform to FCC standards.
Specifications
Wiring Conventions
For Ethernet connections, a twisted-pair cable must have two pairs of 
wires. Each wire pair is identified by two different colors. For example, one 
wire might be red and the other, red with white stripes. Also, an RJ-45 
connector must be attached to both ends of...

CABLES
B-2
Each wire pair must be attached to the RJ-45 connectors in a specific 
orientation. The following figure illustrates how the pins on an Ethernet 
RJ-45 connector are numbered. Be sure to hold the connectors in the same 
orientation when attaching the wires to the pins. 
Figure B-1.  RJ-45 Ethernet Connector Pin Numbers
RJ-45 Port Ethernet Connection
Use the straight-through CAT -5 Ethernet cable provided in the package 
to connect the Barricade to your PC. When connecting to other network...

RJ-45 PORT ETHERNET CONNECTION
B-3
Pin Assignments
With 10BASE-T/100BASE-TX cable, pins 1 and 2 are used for 
transmitting data, and pins 3 and 6 for receiving data.
Straight-Through Wiring
If the port on the attached device has internal crossover wiring (MDI-X), 
then use straight-through cable.
RJ-45 Pin Assignments
Pin Number Assignment*
1Tx+
2Tx-
3Rx+
6Rx-
* The “+” and “-” signs represent the polarity of the 
wires that make up each wire pair.
Straight-Through Cable Pin Assignments
End 1 End 2
1...

CABLES
B-4
Crossover Wiring
If the port on the attached device has straight-through wiring (MDI), use 
crossover cable. 
Crossover Cable Pin Assignments
End 1 End 2
1 (Tx+) 3 (Rx+)
2 (Tx-) 6 (Rx-)
3 (Rx+) 1 (Tx+)
6 (Rx-) 2 (Tx-) 

C-1
APPENDIX C
SPECIFICATIONS
Standards Compliance
CE Mark
Safety
TÜV
IEEE 802.3 10 BASE-T Ethernet 
IEEE 802.3u 100 BASE-TX Fast Ethernet
LAN Interface
4 RJ-45 10 BASE-T/100 BASE-TX ports
Auto-negotiates the connection speed to 10 Mbps Ethernet or 100 Mbps 
Fast Ethernet, and the transmission mode to half-duplex or full-duplex
WAN Interface
1 ADSL RJ-45 port
Indicator Panel
LAN 1~4, WLAN, PPPoE/DSL, WAN, Power
Dimensions
145 x 95 x 36 mm (5.70 x 3.74 x 1.41 in)
We ig h t
0.175 kg (0.469 lbs)
Input...

SPECIFICATIONS
C-2
Advanced Features
Dynamic IP Address Configuration – DHCP, DNS, DDNS
Firewall – Client privileges, hacker prevention and log ging, 
Stateful Packet Inspection
Virtual Private Network – PPTP, IPSec pass-through, VPN pass-through, 
VLAN Ping
Internet Standards
RFC 826 ARP, RFC 791 IP, RFC 792 ICMP, RFC 768 UDP, RFC 793 TCP, 
RFC 783 TFTP, RFC 1483 AAL5 Encapsulation, RFC 1661 PPP, 
RFC 1866 HTML, RFC 2068 HTTP, RFC 2364 PPP over ATM
Radio Features
Wireless RF module Frequency Band...

SPECIFICATIONS
C-3
RF Output Power Modulation Rate-Output Power (dBm)
802.11b - 1Mbps 16
802.11b - 2Mbps 16
802.11b - 5.5Mbps 16
802.11b - 11Mbps 16
Modulation Rate-Output Power (dBm)
802.11g - 6Mbps 15
802.11g - 9Mbps 15
802.11g - 12Mbps 15
802.11g - 18Mbps 15
802.11g- 24Mbps 15
802.11g - 36Mbps 15
802.11g- 48Mbps 15
802.11g - 54Mbps 15
Sensitivity Modulation Rate-Receiver 2.412 ~ 2.484 HGz Sensitivity 
(dBm)
802.11b - 1Mbps -90
802.11b - 2Mbps -88
802.11b - 5.5Mbps -85
802.11b- 11Mbps -84
Modulation...

SPECIFICATIONS
C-4
Environmental
SMCWBR14T-G complies with the following standards:
Te m p e r a t u r e
Operating 0 to 40 °C (32 to 104 °F)
Storage -40 to 70 °C (-40 to 158 °F)
Humidity
5% to 95% (non-condensing)
Vibration: IEC 68-2-36, IEC 68-2-6
Shock: IEC 68-2-29
Drop: IEC 68-2-32
IEEE Standards
IEEE 802.3, 802.3u, 802.11g, 802.1D
ITU G.dmt
ITU G.Handshake
ITU T.413 issue 2 - ADSL full rate