Sim2 Multimedia Ht200 Projector User Manual

HT 200/250
23
ENGLISH
14 INFO
This function displays the current status of the projector,
input type, input frequency, etc.
Info
Input
Horz. Frequency 
Vert. Frequency  
Resolution
Orientation
Aspect
Color Temperature
Lamp Hour Meter
Software  Version
Graphics RGB
56,5 kHz
70 Hz
1024 x 768
Floor
Normal
Low
352
07.00
Info
Input
Video Standard 
Video Type
Orientation
Aspect
Color Temperature
Lamp Hour Meter
Software  VersionVideo
PAL M
Normal
Floor
Normal
Low
352
07.00
VIDEO
RGB
  15 INPUT SELECTION
The...

HT 200/250
24
 17 TROUBLESHOOTING GUIDE
Problems Solutions
No power:- Check the power switch at the rear: it must be in position I.
Green and red LED are OFF
- Check if the power cable has been connected correctly
to a working socket.
- Check the power socket fuse, at the rear of the projector.
- Replace the fuse on the mains socket with an identical
type  (T 3.15A H) 
(Fig. 8).
- Should the problem persist, seek authorised technical
assistance.
The lamp is not coming on:- Allow a few minutes pause...

HT 200/250
25
ENGLISH
Incomplete image along borders (vertical and horizontal):- Compare compatibility of video/graphic signals and tech-
nical specifications of your projector.
- Press Auto (on your remote or key-pad) to execute
automatic adjustments.
- Adjust the horizontal and vertical position of projected
image by selecting  Position on the Image
Adjustments menu.
- Adjust the width and height of image, selecting Aspect
in the Image Adjustments menu.
Image too dark, too pale or unnaturally...

HT 200/250
26
18 MESSAGES
The following messages could appear on your screen:
No Signal.- Check that the selected input is actually connected to
The projector does not recognise any signal sent a video or graphic signal.
through the selected input
- Verify compatibility of video/graphic signals with
technical specifications of your projector.
- Check the integrity of cables used to connect various
sources.
- If you are using the Remote Input Interface, do not to
confuse the menu for selection of...

HT 200/250
27
ENGLISH
 21 TECHNICAL SPECIFICATIONS
OPTICAL CHARACTERISTICS
Projection system: optical engine based on 1 DMD(TM) chip
sealed housing, dusty proof
DMD panel: HT 200 resolution SVGA (800 x 600 pixels)
HT 250 resolution XGA (1024 x 768 pixels)
Brightness: HT 200: 800 ANSI lumen
HT 250: 900 ANSI lumen
Brightness uniformity: > 95%
Contrast ratio: > 300:1 (checker board)
> 600:1 (full on / full off)
Projection lens: zoom, 12 elements AR multilayer coating, motorized focus and zoom,
manual...

HT 200/250
28
De-interlacer: SIM2 circuit with motion compensation and three different interpolation
algorhythms (9 points median filter / field repetition, line/field insertion)
Colour temperature: Adjustable from 5600 to 9300 degrees K
Video processor: DTI, CTI, comb filter, noise reduction.
Sharpness, Y/C delay and NTSC tint adjustments
Remote control: Via infrared remote control and via computer through RS232 serial
interface
Remote inputs: via Remote Inputs Interface (optional) and cable with “EVC”...