Sim2 Multimedia Domino D80 Projector User Manual

460.554.000
D80



Sets the unit to stand-by.
Activates the On Screen Display menus and allows navigation though the various pages.
▲,▼,◀,▶
Navigates between the On Screen Display menus and parameter settings.
Calls up the  Source Selection menu.
Deactivates the On Screen Display
1  REMOTE CONTROL AND KEYPAD
KEYS 0-9Select the sources directly. Switches on the panel from Standby.
STAND-BY / ONSets the panel to stand-by .
ESCAPEDeactivates the On Screen Display.
UP/DOwN/LEfT/RighT ARROw KEYSNavigates between the On...



Different input signal resolutions can be adapted to match the specified screen  resolution  without  loss  of  image  quality,  thanks  to  a  generous selection of preset aspect ratios, some of which are user definable.
All picture adjustments can be made with the remote control interac-ting  with  a  simple  menu-activated  On  Screen  Display;  alternatively, the  projector  can  be  controlled  by  a  domestic  automation  system via its serial port.
The appliance has been subjected to...

4

CAUTiONTo reduce the risk of electric shock, disconnect the power supply cable on the rear panel before removing th\
e top cover of the projector.For technical assistance refer to trained personnel authorised by the man\
ufacturer.
Read all chapters of this manual carefully before switching on the projector. This manual provides basic instructions for using the D80 system. installation, preliinary adjustments and procedures that necessitate the removal of the top cover and contact with electrical...

5

  
    
 
+ ' 0 ,$8 ' ,22 8 7= 2 2 0
& 2 1 7 5 2 /    5 6         
* 5 $ 3 + ,& 6  5 * %
5  & U*  

6

•  Changing the fuses.
 Before changing the fuse disconnect the unit from the 
mains power supply.
 The  fuse  compartment  is  next  to  the  power  supply  con-
nector (Fig.  ). Remove the fuse holder () with a flat head 
screwdriver and replace the fuse (). Fit a new spare fuse 
(4). Use only T ,15 A H fuses.
Fig.
•  Be careful with cables.
 Make certain cables are routed so that people will not be 
impeded or tripped up.
 Keep all cables away from children. 
 Install the...

7

3  UNPACKiNg
To remove the D80 system from its carton follow the diagrams (Fig. 4).
Keep the carton for use when transporting or shipping the unit.
Fig.4
CONTENTS Of PACKAgE
User and installation manual
Remote control 1,5 AA batteries
Power cables EU, UK, US
Projector
Additional deet
Fig.5
- the projector
- Remote control 
- four 1.5V AAA batteries (for remote control)
- three power cables (EU, UK, USA) for the projector
- the user manual.
- Additionals feets
If anything is missing, immediately...

8

Position the projector on a stable, suitable platform or utilise the 
optional bracket for a fixed ceiling installation.
wARNiNg:  if  using  the  ceiling  mount  bracket,  scrupulously 
observe  the  safety  instructions  included  with  the  bracket 
itself. if  using  a  bracket  other  than  that  supplied  by  SiM2 
Multimedia, make sure that the projector is at least 65 mm 
below the ceiling and that the bracket does not obstruct the 
air vents (intake and outlet).
If the projected image is not...

9

DIGITALINPUTAUDIOOUTZOOMCONTROL (RS 232)GRAPHICS RGBR/CrG/YB/CbHV12435ATTENTION: pour ne pas compromettre la protection contre les resque dincende remplacer p ar un f usible de meme type et de mems caracteristiqueCAUT ION: for conti nued protection  against risk of fire, replace only with s ame  typ e and  rating  fuse.

To  activate  an  electric  motorised  screen  a  1  Volt  output  is 
provided at the rear of the projector (Fig. 10).
The output is activated (Voltage: 1 Vdc) when the...

10

5   SwiTChiNg ThE PROJECTOR ON AND Off
wARNiNg: Connect the projector to a power supply with a 
nominal voltage within the following values: 110-240 V AC, 
50/60 hz. it must be earthed (f ig. 12).
Position I : on
Position O : off
Power switch
Fused power 
socket
Power plug 
Fig. 1
In position i the projector will initialise itself  (red and green leds 
on) and then goes into standby mode (red led on) (Fig. 1).
HDMIAUDIOOUT
ZOOM
CONTROL (RS 232)
GRAPHICS RGB
R/Cr
G/Y
B/Cb
HV
2
435...