Siemens Sx 56t590 Operating Instructions

aus11
Adding
 detergent
Pour detergent into the dispenser 29
(insert tablet flat, not on its edge).  Dosage: see manufacturer s
instructions on the packaging.
Close the cover on the detergent dispenser by sliding it up until the lock engages without dif ficulty.
The detergent dispenser opens automatically at the optimum time depending on the programme. The powder or liquid detergentis distributed in the appliance and is dissolved, the tablet falls into the tablet collecting tray where it dissolves in...

aus
12 Overview
 of programmes
The  max. possible number of programmes is illustrated in this overview . The corresponding
programmes for your appliance can be found on the fascia. The programme data are values measured in the laboratory in compliance with Standard AS/NSZ 2007.
Programme
T ype of
utensils and soilingProgramme sequencePossible additionaloptions   
    
      
  
      
  
    
Auto 65  ± 75 Pots, utensils and cutleryHighly soiledIs optimised according to the soiling with the aidof...

aus13
Programme
 selection
You  can select a suitable programme
according to the type of utensils and degree of soiling. Information  about comparability
tests The  conditions for running comparability
tests can be found on the supplementary sheet ªInformation for comparability testsº. Additional
 options
* depending  on model
Additional options 
8 can be set with the
buttons.
Saving  time (V arioSpeed) *
The  >>Save time

aus
14 Washing
 the dishes
Aqua  sensor *
* depending  on model
The Aqua sensor is an optical measuring device (light barrier) which measures the turbidity of the rinsing water .
The Aqua sensor is used according to the programme. If the Aqua sensor is active, ªcleanº rinsing water can be transferred to the next rinse bath and water consumption can be reduced by 3±6 litres. If the turbidity is greater , the water is drained
and is replaced with fresh water . In the
automatic programmes the temperatureand...

aus15
End
 of programme
The  programme has ended when the
value 
 is indicated on the numerical
display 
3.
The end of the programme is also indicated by an acoustic signal. This function can be changed as follows:
Open the door .
Switch on ON/OFF switch 1.
Hold down programme button A
and press ST ART button 9 until on
the digital display 
 is indicated.
Release both buttons.
Press programme button A  until the
factory set value 
 is indicated on
the digital display .
T o change the setting,
press...

aus
16
Changing
 the programme
When  the ST ART button 
9 has been
pressed, the programme cannot be changed. The only way a programme can be changed is by Cancel programme (reset). Intensive  drying
The  final rinse uses a higher temperature
which improves the drying result. The running time may increase slightly .
(Caution if utensils are delicate!)
Open the door .
Switch on ON/OFF switch 1.
Hold down programme button A
and press ST ART button 9 until on
the digital display 
 is indicated.
Release both...

aus17
Filters The filters 
26
 keep large foreign objects
in the rinsing water away from the pump. These foreign objects may occasionally block the filters. The filter system consists of a coarse filter ,
a flat fine filter and a microfilter .
After each washing cycle check the filters for residue.
Unscrew filter cylinder as illustrated and take out filter system.
Remove any residue and clean filters under running water.
Re-install filter system in reverse sequence and ensure that the arrow marks are...

aus
18
Waste
 water pump
Large  food remnants in the rinsing water
not retained by the filters may block the waste water pump. The rinsing water is then not pumped out and covers the filter .
In this case:
First disconnect the appliance from the power supply .
Remove the filters 26.
Scoop out water , use a sponge
if required.
Using a spoon, prise of f pump cover
(as illustrated) until it clicks, then grip the cover by the lug and first pull it upwards until it resists and then pull it out forwards.
Check...

aus19
Door cannot be closed.
Door lock has been activated. To reset, close the door with
greater force.
...  changing settings
A setting cannot be changed,
a programme starts.
W rong programme button pressed.
T erminate the programme
(see chapter entitled ªT erminating
the programme (Reset)º) and start all over again.
Y ou did not wait until programme
ended.
Cover on the detergent dispenser cannot be closed.
Detergent dispenser overfilled or mechanism blocked by sticky detergent residue.
Detergent...

aus
20
...
 on the utensils
Food  residue on the utensils.
Utensils placed too closely together , utensils basket overfilled.
Too little detergent.
Rinse programme too weak.
Spray arm rotation obstructed.
Spray arm nozzles blocked.
Filters blocked.
Filters incorrectly inserted.
W aste water pump blocked.
Top basket on right and left not set
to same height.
T ea or lipstick residue is not
completely removed.
Detergent has inadequate bleaching ef fect.
Too low rinsing temperature.
Too little/unsuitable...