Siemens Sf25m251 Instructions For Use

en21
Intensive
 drying
By  activating the ªIntensive dryingº
function, the final rinse will produce a higher temperature in all programmes resulting in an improved drying result(please note that higher temperatures might have an ef fect on delicate items).
Close the door.
Hold down button B and
switch on main switch 
1.
Release both buttons. The digital display 
8 indicates 
(on) or  (of f) and button B flashes.
To change the setting, press
button 
B .
Switch of f the main switch 1; the
chosen setting...

en
22 h.
 
T ime delay *
You  can delay the start of the programme
in 1-hour steps up to 19 hours.
Switch on the appliance.
Press the timer programming button until the digital display 
8 jumps to
.
Keep pressing the timer programming button until the required time isdisplayed.
T o delete the timer programming,
keep pressing the button until 
is displayed. Y ou can change your programme
selection at any time until the programme starts.
*  on  some models additional functions
4 can be set with the...

en23
Filters The filters 
25
 prevent large particles of
food in the water from reaching the pump. These particles may occasionally block the filters.
When the appliance has finished washing, check the filters for particlesof food and, if required, clean.
After undoing the coarse micro-filter , the
filter unit can be removed. Remove any particles of food and rinse the filters under running water .
Insert the filter unit and tighten the coarse micro-filter.
Coarse/microfilter Spray
 arms
Lime  and...

en
24
Pump
 *
*  on applicable models
Larger remnants of food that have not been trapped by the filters and have been left in the water can cause a blockage in the pump. The water is no longer pumped out of the dishwasher and it can be seencovering the filter .
Proceed as follows:
First, always disconnect the appliance from the power supply .
Ladle out as much water as possible.
Remove the filters 25.
Undo the screw in the cover (T orx T 20)
and remove the cover .
Inspect the inside and remove any...

en25
...  with the appliance itself
Lower  spray arm rotates with
difficulty
Spray arm is blocked by small items or food remains.
Lid in detergent compartment cannot be closed
Detergent compartment has been overfilled.
Mechanism is clogged with remnants of detergent. Indicator lamps do not extinguishafter washing has finished.
Indicator lights flash after the programme has started.
No programme selected.
Remnants of detergent stuck inside dispenser
Compartment was damp when it was filled up with...

en
26
Knocking sound coming from inlet valves
This is caused by the way the water pipes have been laid and it has no ef fect upon the way the
appliance functions. There is no remedy for this.
...  with the dishes, cutlery , etc.
Remnants of food are stuck to the
dishes, cutlery , etc.
Dishwasher was not loaded properly. Jets of water could not
reach all parts of the dishes, etc.
T oo many items in the rack.
Items in the rack were touching each other .
Not enough detergent was added to dispenser ....

en27
Customer
 Service
Please  call your local service agent, if you
are not able to resolve any problem yourself. The name of your nearest service agent is shown in the Customer Service address list. When you call, please provide details of the model number (1) and the production (FD) number (2) which are shown on the nameplate 
31 on the
appliance door .
FD
1 2
Attention
Please note that a visit by the customer service technician in the event of a fault or one of the problems previously discussedis not...

en
28 Installation
The dishwasher must be connected by a qualified technician to ensure correctoperation. The specifications for supply ,
drainage and connected load must fulfilthe required criteria as stated in the following paragraphs or in the installation instructions. Install the appliance in the following sequence: ± Check the delivery ± Install the appliance ± Connect the waste water ± Connect the fresh water± Connect the power supply Delivery Y our dishwasher was checked at the
factory to ensure...

en29
Removing
 the appliance
It  is essential, when removing the
appliance, to observe the following sequence: First, disconnect the appliancefrom the power supply .
Pull out the mains plug.T urn of f the water supply .
Disconnect the waste water and freshwater connections.Loosen the fastening screws under theworktop. If fitted, remove the base panel.Pull out the appliance, carefully pulling thehose behind. 
Transporting  the dishwasher
Drain  water from the dishwasher . Secure
all loose parts. The...

en
30
Disposal
 of the packaging
Please dispose of the packaging
material in an environmentally friendly manner .
Keep children away from shipping carton and packaging components. Danger of suf focation from folding
cartons and plastic film.
 Corrugated cardboard consists mainly of wastepaper .
 The moulded polystyrene parts donot contain anychlorofluorohydrocarbons.
 The polyethylene film (PE) consistspartly of secondary raw materials.
 The wooden frames (if fitted) aremade of untreated residual wood....