Siemens Se 66t372 Eu Instructions For Use

aus21
Pump
 *
*  on applicable models
Larger remnants of food that have not been trapped by the filters and have been left in the water can cause a blockage in the pump. The water is no longer pumped out of the dishwasher and it can be seencovering the filter .
Proceed as follows:
First, always disconnect the appliance from the power supply .
Ladle out as much water as possible.
Remove the filters 24.
Undo the screw in the cover (T orx T 20)
and remove the cover .
Inspect the inside and remove any...

aus
22
The filter on the water supply hose is blocked.Switch of f the appliance and pull
out the mains plug. T urn off the
tap. Then clean the filter which issituated at the connection of the supply hose. Finally , restore the
power , turn on the tap and switch
on the appliance.
...  with the appliance itself
Lower  spray arm rotates with
difficulty
Spray arm is blocked by small items or food remains.
Lid in detergent compartment cannot be closed
Detergent compartment has been overfilled.
Mechanism is...

aus23
Knocking sound coming from inlet valves
This is caused by the way the water pipes have been laid and it has no ef fect upon the way the
appliance functions. There is no remedy for this.
...  with the dishes, cutlery , etc.
Remnants of food are stuck to the
dishes, cutlery , etc.
Dishwasher was not loaded properly. Jets of water could not
reach all parts of the dishes, etc.
T oo many items in the rack.
Items in the rack were touching each other .
Not enough detergent was added to dispenser ....

aus
24 Customer
 Service
Please  call your local service agent, if you
are not able to resolve any problem yourself. The name of your nearest service agent is shown in the Customer Service address list. When you call, please provide details of the model number (1) and the production (FD) number (2) which are shown on the nameplate 
30 on the
appliance door.
FD
1 2
Attention
Please note that a visit by the customer service technician in the event of a fault or one of the problems previously discussedis...

aus25
Installation
The dishwasher must be connected by a qualified technician to ensure correctoperation. The specifications for supply ,
drainage and connected load must fulfilthe required criteria as stated in the following paragraphs or in the installation instructions. Install the appliance in the following sequence: – Check the delivery – Install the appliance – Connect the waste water – Connect the fresh water– Connect the power supply Delivery Y our dishwasher was checked at the
factory to ensure...

aus
26
Disconnecting
 the dishwasher
Here  too, it is important that tasks are
carried out in the correct sequence: always unplug the appliance from the mains electricity first of all.Pull plug out of wall socket. T urn of f water supply .
Disconnect drain and water input hoses.Remove screws in underside of work surface. Detach base board, if fitted.Pull out appliance and carefully withdraw hoses at same time. 
Transporting  the dishwasher
Drain  water from the dishwasher . Secure
all loose parts. The...

aus27
Waste
 disposal
Disposal Old  appliances are not worthless rubbish.
V aluable raw materials can be reclaimed
by recycling old appliances. Pull out the mains plug of the redundant appliance. Cut of f the power cord and
discard with mains plug.T o prevent children from locking
themselves in the appliance andsuf focating, destroy the door lock
and childproof lock (if fitted). Y ou received your new appliance in
a protective shipping carton. All packaging materials are environmentally friendly and...

aus
28
aus Subjekt to modification
 


  	 	
	
$($),!.,%$+0-$ 
  	
)   
$,.&$)  $  .),  (  )-$+)$- &--*///,$($),#$&!.,%$+!$-$
			  

  
  !.,  

  
Siemens–Electrogeräte
 GmbH
Carl–W ery–Straße 34
81739 München T o contact us directly , use the tel. no or fax no. in the
enclosed customer service list.