Siemens Se 65e332 Instructions For Use

							       
en Instructions for use
                                                                    
 
   
						

							enIndex
Safety instructions 4 
.  . . . . . . . . . . . . 
Getting to know your appliance 6 
. . 
W ater softener 7 
. . . . . . . . . . . . . . . . 
Filling the salt dispenser 8 
. . . . . . . . 
Adding rinse aid 9 
. . . . . . . . . . . . . . . 
Utensils 10 
. . . . . . . . . . . . . . . . . . . . . . 
Detergent 13 
. . . . . . . . . . . . . . . . . . . . 
Programme overview 15 
. . . . . . . . . .  W
ashing dishes 16 
. . . . . . . . . . . . . . . 
Additional functions * 17 
. . . . . . . . . . . 
Maintenance and care 18 
. . . . . . . . . . 
Fault finding 20 
. . . . . . . . . . . . . . . . . . 
Customer Service 23 
. . . . . . . . . . . . . 
Information 23 
. . . . . . . . . . . . . . . . . . . 
Installation 24 
. . . . . . . . . . . . . . . . . . . . 
W aste disposal 25 
. . . . . . . . . . . . . . . . 
 
						

							en
4 Safety
 instructions
Delivery
Immediately  check the packaging and
dishwasher for any damage which may have been caused in transit. Do not usea damaged appliance, but consult your 
supplier.
Please dispose of packaging material 
properly.
Installation
Install and connect the appliance according to the installation and assembly instructions.
The dishwasher must NOT be connected to the power supply duringinstallation.
Ensure that the protective conductor system of the domestic electricity supply has been installed correctly .
Electrical connection conditions must correspond with the specifications on the rating plate of the dishwasher.
If the dishwasher is to be installed in a high-sided unit, ensure that the unit is attached properly and also at the
rear.
Built-under and built-in appliances should always be installed under a continuous work surface which is attached to the adjacent cupboards, inorder to ensure that the appliance is entirely stable.
After the appliance has been installed, the mains plug should still be easily accessible.
Not on all models: The plastic housing on the water input contains an electrically operated valve. The connecting wires are inside the inlet hose. Do not cut through this hoseand do not immerse the plastic housing in water.
Warning
For safety reasons, if the appliance is not fitted in a recess, thereby making a side wall accessible, the door hinge areashould be covered at the side. (Risk of injury) Covers are available as optional accessories from customer services or specialist stores. In  daily use
Warning
Knives  and other sharp-pointed utensils
must be placed with the points down in the cutlery basket or horizontally in the utensils basket.
Use the dishwasher only in the household and only for its designed purpose, i.e. for washing domestic dishes.
Do not lean or sit on the open door .
The appliance could tip.
Please note that free-standing appliances may tip over if the baskets are overloaded.
The water in the appliance is not drinking water .
Do not add any solvents to the washing chamber. Danger of explosion!
Open the door carefully when the programme is still running. There is a risk of hot water spraying out ofthe appliance.
To prevent injuries, e.g. caused
by stumbling, open the dishwasher only briefly in order to load and unload the dishwasher .
Read and observe the safety nformation and instructions for use onthe packaging for cleaning and rinsing agents.
 
						

							en5
Children
 in the household
If fitted, use the childproof lock. An
exact description can be found in the back of the envelope.
Do not allow children to play with or operate the appliance.
Keep children away from detergents and rinse aid. These may cause chemical burns in the mouth, throat and eyes or asphyxiation.
Keep children away from an open dishwasher . There could still be
detergent residue inside.
If the appliance is installed at eye-level, ensure when opening and closing the door that children are not caught or crushed between the appliance doorand the cupboard door situated below .
Damage
The appliance may be repaired and opened up by a technician only . First
disconnect the appliance from thepower supply . Pull out the mains plug
(do not tug the power cord!) or switch of f the fuse. T urn off the tap. Disposal
Make redundant appliances unusable to prevent subsequent accidents.
Dispose of the appliance in an environmentally friendly manner
.
Warning
Children could get locked in the appliance (risk of suf focation) or get stuck in other
positions.Therefore: Remove the mains plug, cut themains wire and set aside. Damage the door lock so that the door can no longer be closed. Before  using for the first time
The  appliance was checked before it left
the works. In order to remove possible water test remains, use the appliance for the first time  without any dishes , using
the highest temperature. Also fill salt, rinse aid and detergent in the filling compartments.
 
						

							en
6 Getting
 to know your
appliance
Diagrams  of the control panel and the
interior of the appliance can be found in the envelope at the front.
Individual positions are referred to in
the text. Control  panel
1
Main  switch
2
Door handle
3
Additional options*
4
PROGRAMME END indicator
5
LOW SAL T indicator
6
LOW RINSE-AID indicator
7 ªCheck water supplyº indicator
8
Programme buttons
* on applicable models Appliance  interior
20Top basket
21Additional cutlery basket for the top basket *
22Top spray arm
23Additional cup rack *
24Bottom spray arm
25Float **
26Bottom basket
27Salt dispenser
28Filters
29Cutlery basket
30Dispenser for rinse aid
31Detergent dispenser
32Catch
33Rating plate
*  some models ** The float ensures that the appliance interior is not overfilled. Only customer service may maintain, remove and install the float.
You  will need to purchase the
following before using the dishwasher for the first time: ±  special salt for use in dishwashers
± detergent ± rinse-aid Only use products, which are suitable for dishwashers.
  
						

							en7
Water
 softener
In  order to rinse dishes and glasses
satisfactorily , the dishwasher requires soft
water , i.e. containing little or no lime,
otherwise water stains will be left behind on crockery and glasses, etc. If the tap water exceeds a certain level of hardness, it must be softened, i.e.decalcified, so that it can be used in the 
dishwasher. This is achieved by adding a special salt to the water softener inside the dishwasher . 
The water softener , that is the required
amount of salt, is set up according to howhard the tap water is. Setting  up the water softener
Determine  the level of hardness of your
tap water . Your local water company or
service agent can help you with this.
Identify setting from the following water hardness table.
Hold down the programme button B
and switch on the main switch 
1,
then release the buttons. The display 
5  flashes and buttons
A  and B illuminate.
(Hardness value 2 was set at the factory).
T o change the setting: Press
programme button 
B . 
Each depression of the button increases the set value by one (0±3). If buttons 
A , B  and C illuminate,
the maximum hardness value has been reached.If the hardness value is now increased again, the illuminated buttons go out and the hardness value is set to 0 (nobuttons illuminated).
Switch of f the mains switch 1.
The set value is stored in the appliance.
Approx. 4 litres of water are required for regenerating the water softening system. The overall water consumption per load can therefore be increased by between 0 and a maximum of 4 litres according to the water hardness setting.
Water  hardness table
dh Clarke mmol/
l

fHA B C
0±6
17±21 7±16
22±35 0 2
1 3
Reset
0±11
30±37
12±29 38±60 0±8
21±26 9±20
27±44 0±1,1
3,0±3,7
1,2±2,93,8±6,2
 
						

							en
8 Filling
 the salt dispenser
Salt  must always be filled before the
appliance is switched on, so that excess salt solution is immediately flushed away to prevent corrosion.
Open the screw-type cap of the compartment 
27 .
Before using the appliance for the first time, pour about 1 litre of water in the salt container .
Then refill with salt  (not cooking salt)
until the salt container is full (max. 1.5 kg). When you refill the salt,water is being displaced and drains of f.
The LOW SALT indicator 5 on the front 
panel will light up initially but will extinguish again after a short period when the salt solution has become suf ficiently
concentrated. If the set hardness value is º0º, do not add salt because no salt is used during operation; the salt refill indicator is switched of f.
Warning
Do not pour detergent into the container for special salt. This would destroy the water softener .
Salt  refill indicator
As  soon as the salt refill indicator 
5 is lit
on the control panel, refill with salt immediately before the next rinse cycle. Depending on the washing frequency and the hardness setting, the regeneration salt may not have to be topped up for severalmonths.
  
						

							en9
Adding
 rinse aid
The  rinse aid is required for stain-free
utensils and clear glasses. Use only rinse aid for domestic dishwashers.
Open the cover on the rinse-aid dispenser 
30 . To do this, press the
mark (1
) on the cover and
simultaneously lift the cover on the control plate (2
).
Carefully pour in the rinse aid to just below the edge of the filler opening.
Close the lid, ensuring that you hear it snap closed.
T o prevent excessive foam formation
during the next rinse cycle, remove anyrinse aid which has run over with a cloth. Adjusting
 the amount of
rinse-aid The  amount of rinse-aid added to the
water can be varied by adjusting the stepless control. The rinse-aid control has been set to º4º in the factory .
Do not alter the setting of the rinse-aidcontrol unless streaks (turn knob towards º±º) or water marks (turn knob towards º+º) are left on the dishes.
30
Rinse aid controller
Rinse-aid  refill indicator
As  soon as the rinse-aid refill indicator
lights up on the control panel 
6,
refill with rinse aid.
      
						

							en
10 Utensils
Not  suitable
Cutlery  and utensils made of wood.
Fragile decorative glasses, hand-crafted and antique utensils. These decorative items are not dishwasher-proof.
Plastic parts sensitive to hot water .
Copper and tin utensils.
Utensils which are soiled with ash, wax, lubricating grease or ink.
Absorbent materials such as sponges and cloths.
Aluminium and silver parts have a tendency to discolour and fade during the wash cycle. Even some types of glass (e.g. crystal glass objects) may turn cloudy after many wash cycles. Recommendation:In future buy utensils which are identified as dishwasher-proof. Damage  to glassware and other
dishes Possible  causes:
type of glass or manufacturing process
chemical composition of detergent
water temperature and duration of dishwasher programme.
Suggested remedy:
Use glassware or porcelain dishes that have been marked dishwasher±proof 
by the manufacturer .
Use a mild detergent that is described as kind to dishes. If necessary , seek
further information from detergentmanufacturers.
Select a programme with as low a temperature and as short a duration aspossible.
T o prevent damage, take glass and
cutlery out of the dishwasher as soon as possible after the programme has ended. Loading
 the dishwasher
It is not necessary to rinse them of f
under running water .
When loading the dishwasher , ensure
that
 all utensils are secure and cannot fall over .
 the openings of all receptacles are face down.
 curved or indented utensils are atan incline, allowing water to drain.
 the two spray arms can rotate freely .
V ery small items should not be washed in
the dishwasher as they could easily fall outof the baskets. Removing  the dishes
To  prevent water dripping from the top
basket onto the dishes in the lower basket, we recommend that you empty the lower basket first and then the top basket. Cups  and glasses
Upper  basket 
20
* on  applicable models