Sharp Lc 52hd1e Operation Manual

LC-46HD1E
LC-52HD1E
LCD COLOUR TELEVISION
LCD-FARBFERNSEHGERÄT
TÉLÉVISION COULEUR À ÉCRANÀ CRISTAUX LIQUIDES (LCD)
TELEVISORE A COLORI LCD
ENGLISH
DEUTSCH
FRANÇAIS

SHARP ELECTRÓNICA ESPAÑA S.A.
Polígono Industrial Can Sant Joan
Calle Sena s/n
08174 SANT CUGAT DEL VALLÉS
BARCELONA (ESPAÑA)
SHARP CORPORATION
Printed in Spain
Gedruckt in Spanien
Imprimé en Espagne
Stampato in Spagna
TINS-C940WJN108P06-SP-NG
LC-46HD1E/LC-52HD1E OPERATION MANUAL / BEDIENUNGSANLEITUNG / MODE D'EMPLOI / MANUALE DI...

SPECIAL NOTE FOR USERS IN THE U.K.
The mains lead of this product is fi tted with a non-rewireable (moulded) plug incorporating a 13A fuse. Should the 
fuse need to be replaced, a BSI or ASTA approved BS 1362 fuse marked 

 or 

ASA
 and of the same rating as above, 
which is also indicated on the pin face of the plug, must be used.
Always refi t the fuse cover after replacing the fuse. Never use the plug without the fuse cover fi tted.
In the unlikely event of the socket outlet in your home not being...

OPERATION MANUAL
ENGLISH
Contents ...............................................................\
..........................1
Dear SHARP customer ..................................................................2
Important Safety Precautions ......................................................2
Trademarks ..............................................................\
......................2
Supplied accessories ....................................................................3
Preparation...

•  “HDMI, the HDMI logo and High-Definition Multimedia Interface are trademarks or registered trademarks of HDMI Licensing LLC.”
Dear SHARP customer
•  Cleaning—Unplug the AC cord from the AC outlet before cleaning the product. Use a damp cloth to clean the product. Do not use liquid cleaners or aerosol cleaners.
•  Water and moisture—Do not use the product near water, such as bathtub, washbasin, kitchen sink, laundry tub,  swimming pool and in a wet basement.
•  Do not place vases or any other...

Supplied accessories
Preparation
Attaching the speaker unit
•  Before attaching (or detaching) the speaker unit, unplug the AC cord from the AC INPUT terminal.
•  Before performing work spread cushioning over the base area to lay the TV on. This will prevent it from being damaged.
Connect the ends of the cables to the speaker 
terminals as shown.
  Connect the leads to the speaker terminals of  the same colour.3
NOTE
•  To detach the speaker unit, perform the steps in reverse 
order.
312 4
Screwdriver...

Attaching the stand unit
•  Before attaching (or detaching) the stand, unplug the AC cord from the AC INPUT terminal.
•  Before performing work spread cushioning over the base area to lay the TV on. This will prevent it from being damaged.
CAUTION
•  Attach the stand in the correct direction.
•  Be sure to follow the instructions. Incorrect installation of the stand may result in the TV falling over.
1 Insert the stand into the openings on the  
  bottom of the TV. (Hold the stand so it will  
  not...

Setting the TV
Preparation
Antenna
Connect the antenna cable from your antenna-
/cable socket or the (room-/roof) antenna for 
antenna input terminal on the back of your TV set to 
receive digitally/terrestrially broadcast stations.
An indoor antenna can also be used under good 
reception conditions. Passive and active room 
antennas are offered commercially. In an active 
antenna its power is supplied via the antenna input 
terminal.
The supply voltage (5V) must be correspondingly 
set under “Allow...

Preparation
TV (Front view)
TV (Rear view)
51
2
3
467
161718
891011121315
1914
1
  EXT 4 terminals
*  Do not connect S-VIDEO and VIDEO at the same time.
2  USB terminal
3  Headphones
4   COMMON INTERFACE slot ( g2)
**  Remove the cover when inserting the CI 
Module. 5
  ANT IN terminals
6   AUDIO OUT terminals
7   AUDIO IN terminals
8   EXT 3 (COMPONENT) terminals
9   DIGITAL AUDIO terminals
10   EXT 7 (ANALOG RGB) terminal
11   EXT 5 (HDMI) terminal
12   EXT 6 (HDMI) terminal
13   AUDIO IN (L/R) jack...

Preparation
Inserting the batteries
Before using the TV for the first time, insert two “AAA” size batteries\
 (supplied). When the batteries become 
depleted and the remote control unit fails to operate, replace the batteries with new “AAA” size batteries.Open the battery cover.
Insert two supplied “AAA” alkaline size batteries.•  Place batteries with their terminals corresponding to the ( k) and ( l) indications in the battery 
compartment.
Close the battery cover.
CAUTION
Improper use of batteries can...

Preparation
Remote control unit
NOTE
• The symbols 8, 9  and 0  indicate that the buttons become available in respective operating mode when using as 
a universal remote control.
1
4
5
6
7
8
9
10
11
12
13
14 15
16
17
18
19
20
21
22
231 
B (TV Standby/On)  (Page 12)
2 LIGHT  D 8  9  0
  When pressed, buttons that are frequently  used ( P r /s , i  k /l , 0 - 9  numeric 
buttons,  A and  b) will light. The lighting 
will turn off if no operations are performed 
within about 5 seconds. This button is 
used...