Sangean Ats 808a Lw Am Fm Shortwave Radio Owners Manual

BAND SELECTION
   There are four band selector buttons
   located just beneath the LCD display.
BAND                            FREQUENCY RANGE                     PROGRAM TYPE
  FM                                           87.5~108 Mhz                                 Standard FM
  LW                                            150~519 Khz                                    Longwave
  MW                                        520~1710 KHz                                 Standard AM
  SW...

TUNING MODE
ADJUSTING THE ANTENNA
Locate the band you want to listen to in the
following chart and adjust the antenna as
indicated. BAND                                               ANTENNA TYPES             ILLUSTRATIONBAND                                                ANTENNA TYPES         ILLUSTRATION
                                                               INTERNAL
                                                               Rotate radio  MW           520-1710 Khz                 for best...

You may select any frequency using four different turning methods:
                              Direct turning
                              Manual Tuning
                              Scan Turning
                              Memory Tuning
DIRECT TUNINGYou may KEY IN a specific band (120m,
49m,16m) by pressing the appropriatebutton. The exact station is then selected
by pressing the buttons corresponding to 
the station frequency. Example: To tune 100.70 Mhz on the FM band, follow this procedure:1....

4.  Press  the  button  markedENTER
     within twelve seconds. The frequency
     and band will now show up in the display.
     The SIGNAL STRENGTH will also show.
NOTE: Be sure to press the decimal
point [] in100.70MHz, otherwise the
display will showSW, [10.070 MHz]
automatically.
5.  Extend the antenna all  the  way and
     rotate for best FM reception.
6. Adjust the VOLUME and TONE controls
     for the desired sound.
7. When selecting  a  stereo  FM  station
     make sure the FM mode switch is...

MANUAL TUNING
    To select a station you do not know the
    frequency of, use the MANUAL TUNING
    [] [V] buttons or the ROTARY TUNING
    control on the side of the radio.
   
    1. Press the POWER button to turn on 
        radio.
    2. Select a band.
    3. Press repeatedly the [] or [V] buttons
        to reach a desired frequency. Press and
        hold the [] or [V] buttons for at least a 
        half second  or  more to change frequencies
       rapidly.
    
   OR Rotate the TUNING knob...

When you repeatedly press the [] or [V]
buttons, the frequencies change in increments
of:
FM  : 50 KHz (or 100 KHz)
LW  :   9 KHz
MW :   9 KHz or 10 KHz
SW  :   5 Khz
4.  Adjust the VOLUME and TONE controls
     as you like.NOTETurning the ROTARY TUNING knob with
the TUNING SPEED CONTROL set on
FAST will change each band as follows:
          FM  :  100 KHz
          LW  :      9 KHz
          MW :      9 KHz/10 KHz
          SW  :      5 KHz
When  set  on  slow,  the  frequencies
change as follows:...

SCAN TUNING
Use scan tuning to quickly locate a station
or  to  monitor several stations within aspecific band.
   1. Turn  on  radio  by  pressing POWER
       button.
   2. Select a band.
   3. Adjust antenna or radio position de-
       pending on selected band.FMLWMWSWPOWER
FM/LW/MW PLL SYNTHESIED RECEIVERMETERDIRECT ACCESSFREQSTANDBYTUNIGN
MANUL/AUTO
                                         BUZZER           RADIOSTANDBY
FMLWMWSW
POWER
FM/LW/MW PLL SYNTHESIED RECEIVERMETERDIRECT...

4. Press and hold the () or (V) buttons for at least
    a half second or more and the radio will scan
    all the frequencies in that band, and will stop 
    automatically each time it lands on an active
    station. Signal strength is recorded on the
    SIGNAL STRENGTH INDICATOR.
5. Press and hold the () or (V) buttons again to
    resume scanning. When you reach the upper
    or lower limits of the band, the scanning starts
    all  over  again  as  long  as the button is
    depresseden once more....

MEMORY   TUNING
You may store up to eighteen different
frequencies on the SW/FM bands and up
to nine different frequencies on each of
the other bands for instant selection of
your favorite stations.
 
    1. Press POWER button to turn on radio
.
    2. Turn to any frequency using any of the
        previously mentioned tuning methods.
    3. Press  the  button marked Mfor
        MEMORY it will start flashing in the
        display for 15 seconds during which time
        press any of the buttons marked...

    1. Press POWER button to turn on radio.
    2. Select a band in which a station is stored
       that you want to recall.
    3. Press any of the NUMBERED buttons for
       a  desired station and the radio will
       instantly tune to it and display that
       frequency and the MEMORY position
       number. If you want to change to 
       another stored station, just press any
       other numbered button for access.RECALLING A FREQUENCY20FMLWMWSWPOWER