Home > Sangean > Radio > Sangean Ats 505 Am Fm Shortwave Radio Owners Manual

Sangean Ats 505 Am Fm Shortwave Radio Owners Manual

Here you can view all the pages of manual Sangean Ats 505 Am Fm Shortwave Radio Owners Manual. The Sangean manuals for Radio are available online for free. You can easily download all the documents as PDF.

Page 1


				            

Page 2


				            

Page 3

Control Locations
Power/SleepPower On/off/Alarm off/sleep function
DisplaySwitch between radio frequency and time while radio is power on
ModeMode set up (please see below mode button set up)
Radio alarmBuzzer alarmTuning Up/Down
Enter command button for frequency and time set 
Selection cancel 
Numbered buttons and memory scan (the 0 Button)
Memory set buttons and AM/PM selection for 24-hour format 
Real/dual time button and SW memory page
SW meter band selection
Band selectionTuning LED indicator...

Page 4

1.Position the radio face down
2.Press the catch marked         and slide in the direction shown.
3.Insert the 4 UM-2 (LR6)(AA size) batteries.
4. Replace the battery cover.  Choosing a power supply
Installing batteries
Battery replacement
Low battery warnings
Using the AC adapter
Setting the clock This radio can be operated using.
4 Alkaline UM-3(LR6)(AA size)batteries.
Household AC adapter(not supplied).
 
The battery indicator will display the battery condition for approx.7 seconds after the
radio is...

Page 5

The  real  time  can  be set.
1. When  the  radio  is  switched  off
2. If  the  radio  switched on, press DISPLAY  button  to  time  status.
3. Press ENTER button for more than 2 seconds until          real time symbol and
4. Set  the  correct  time  by  pressing  the  numbered  buttons. As  you  press  each
    button, the  corresponding  number  will  show  on  the  display.
5. If  you  press  wrong  button, after  pressing the ENTER button. The radio will beep
    and  Err flashed  in  the  display....

Page 6

5 Waveband selection
Direct tuning
Manual tuning by tuning UP/DOWN button There  are  four  waveband  selection  by   pressing  BAND  button
Waveband        Frequency coverage                Aerial Type
--------------------------------------------------------------------------------------------FM                       87.50-  108 MHz                      Telescopic
                                                                                     Full extend the aerial, angle...

Page 7

6Note:
Each  press  of  Up or Down button  will change  the  frequency  in  increment  of
FM: 100kHz or 200kHz  depending  on  the  versions.
MW:  9kHz or 10kHz  depending  on  the  versions.
SW:   5kHz
LW: 9kHz
Rotary  tuning  is  accomplished  using  the convenient Rotary Tuning Knob. Original
tuning  step  is  as  below  but can be changed by the  MODE  button as described later.
BAND                         FM                              MW                               LW                        SW...

Page 8

3.Press the button  marked  M (memory), display  M  and suggested  preset  number
    will flash, press ENTER to  store  your  station  in  that  memory  position.
4.Preset positions may be exchanged easily. Select  preset  station  that  is  to  be
    changed, press  memory  button ( M and  existing  memory  position  will  flash).
    select  new  preset  position. Preset  will  be  exchanged  automatically.
5.SW band has 18 presets (in two pages).When presets 1-9 are full, press PAGE
    button  to...

Page 9

3.Press  Tuning  UP  and  DOWN  button  at  the  same  time  for  more  than 2 seconds.
    The  radio  will  beep  and  then  scan  from  the  lowest  frequency  on  the  selected
    band.  Automatically  storing  stations  in  preset  memory  based  on  signal  strength.
4.After APS is completed, a beep will be heard. The display  will  show  M1  and  the
    strongest  station  for  your  area.
5.If  during  APS  operation,  no  stations  are  found, display  will show lowest  frequency
    of...

Page 10

Note:
1.When alarm is on, press POWER button to turn off the alarm for 24 hours.
2.Radio alarm on will last for one hour if not turned off by pushing the POWER
    button.
3.Turn the radio to the required station before setting the radio alarm. When the
    alarm is on, the radio will play last station selected.
A repeating beep tone will sound when using the HWS alarm. The alarm beep will
increase in volume every 15 seconds for one minute followed by 1 minute silence
before repeating the cycle. The HWS...
Start reading Sangean Ats 505 Am Fm Shortwave Radio Owners Manual

Related Manuals for Sangean Ats 505 Am Fm Shortwave Radio Owners Manual

All Sangean manuals