Sangean Ats 404 Am Fm Shortwave Radio Owners Manual

 Control Locations
1.     Telescopic Antenna
2.     Display (L.C.D)
3.     Display illuminated button (LIGHT)
4.     Power on/off  button
5.     Sleep (auto shut off) button
6.     Display button
7.     Standby button (ALARM)
8.     Alarm by radio or buzzer selection
9.     Manual/auto scan tuning buttons
10.   Enter command button for frequency and time.
11.   Numbered buttons for frequency and time.
12.   Memory set button
13.   Memory scan and dual time.
14.   SW meter band also 12/24 Hour select...

 Choosing a power supply
This radio can be operated using
4 Alkaline UM-3 (LR6) (AA size) batteries
Household AC adaptor (not supplied)
 Installing batteries
1.Position the radio face down.
2.Press the catch marked OPEN and side in the direction shown
3.Insert the 4 UM-3 (LR6) (AA size) batteries
4.Replace the battery cover
 Battery replacement
The battery indicator will display the battery condition for approx. 7 seconds after the radio is 
switched On. If the indicator shown“       ”,the batteries...

In addition to real time, a dual time can be programmed into the radio.
1.Press MEMO SCAN (DUAL TIME) button, display will flash “       ”
2.Press ENTER button within 7 seconds, the display “     ” will stop flashing.
3.Press ENTER button again, the “     ”dual time symbol flashes, whilst the “     ” is flashing, 
   set the dual time by pressing the numbered buttons.
4.The rest of the operation is same as setting real time.
5.Press DUAL TIME button again ENTER button to return to real time.
Note: a. To...

Manual tuning
1.Press the POWER on/off button to turn on the radio.
2.Select a waveband by pressing BAND button.
3.A single press on the either the TUNING UP “    ” or DOWN “      ”buttons  will change the 
   frequency up or down.   Note: Each press of the up or down button will change the frequency in increment of 
         FM                 100kHz         MW                9kHz/10KHz
         SW                 5kHz
Scan tuning
1.Turn on the radio by pressing the POWER on/off button.
2.Select a...

     3.Press the numbered button corresponding to the preset memory  location for the 
        required station .The radio will instantly tune to the station and the display will show  its
        frequency and memory location.
Select Short Wave Meter band
     1.Turn on the radio by pressing the POWER on/off  button.
     2.Press BAND button to select the SW waveband .
     3.Press SW SELECT button to select the required SW meter band ,display will appear 
        frequency and SW meter band it belongs...

ALARM button again to cancel the alarm, The alarm symbol will flash  for 7 seconds and
disappear.Note:      1.When the alarm is sounding, press POWER button to turn off  the alarm for 24 hours.
      2.The radio alarm will last for one hour if not turned off  by pushing the POWER button.
      3.Tune the radio to the required station before setting the alarm. When the alarm operates, 
         the radio will play the last station selected.
 Setting the HWS (Humane Wake System) alarm
A repeating beep tone...

removed  form the display.
 Light
Pressing the light button located on the top of the radio will turn on the light and illuminate
the display for approximately 7 seconds.
 MW step switch
    1.This switch located on the bottom side of the radio provides a means of changing the 
        MW step from  9kHz to 10 kHz. In Europe and most other parts of  the world, set the
        switch to the  9 kHz position. For the USA and Canada, set the switch to the 10kHz
        position. 
 Troubleshooting /RESET...

 Circuit features         
  Semiconductors               1 LSI,5ICS, 2 FET ,39 transistors ,34 diodes,1 LED
  Aerial system                   MW Built in ferrite aerial
                                             SW Telescopic aerial
                                             FM Telescopic aerial
  Output Power                   180 m W
  Sockets  Headphones socket          3.5 mm dia stereo
  DC in                                  6 volts centre pin negative
  Accessories...