Samsung Rs 21 Hklmr1 User Manual

setting up _11
01 SETTING UP
4. After connecting the water supply to the water 
fi lter, turn your main water supply back on and 
dispense about 1l to clear and prime the water 
fi lter.
Connecting the water line to the 
refrigerator
1. Remove the dust cap from the water line on the 
rear of the unit and fi t a compression nut from the 
install kit.
2. Remove the water pipe from the install kit and fi t 
a compression nut to one end.
3. Join the two pipes together using the 
compression joint from the...

12_ setting up
INSTALLING THE WATER 
DISPENSER LINE
For Exterior model
Parts for water line Installation 
Connecting to the water supply line
Connect the water pipe with coupler and tap.
1. Close the main water tap.
2. Connect coupler “A” to the tap.
Select the location where the purifi er 
is to install. (Model with the purifi er)
- If you wish to reassemble the water inlet 
and outlet sides of the purifi er during purifi er 
installation, see the reference illustration.
- Cut the water line attached to the...

setting up _13
01 SETTING UP
Remove any residual matter inside 
the purifi er. (Model with the purifi er)
- Open the main water tap to check whether water 
is running through the water tube on the water 
inlet side of the purifi er.
- If water does not come out through the line, 
check whether the tap is open.
- Leave the tap open until clean water is running 
out and any residual matter that built up during 
manufacturing has been removed.
Attach the purifi er lock-clip.
- Hold the purifi er lock-clip in the...

14_ setting up
Check the amount of water supplied 
to the ice tray.
1. Lift up the icemaker cover and gently pull out.
2. When you press the Test button for 3 seconds, 
the ice cube container is fi lled with water from the 
water supply tap.
Check to make sure the amount of water is 
correct (see the illustration below).
If the water level is too low, the ice cubes will be 
small. This is a water pressure problem from with 
in the main water pipes, not the refrigerator.
Using the anti-sweat heater switch...

operating _15
02 OPERATING
OPERATING THE 
REFRIGERATOR
Using the Control Panel /
Digital Display 
When not in use the temperature display will turn off, 
this is normal.
1
POWER 
FREEZE 
BUTTON
Speeds up the time needed to 
freeze products in the freezer. This 
can be helpful if you need to quickly 
freeze items that spoil easily or if 
the temperature in the freezer has 
warmed dramatically (For example, if 
the door was left open).
2
FREEZER 
BUTTON
Press the Freezer button to set the 
freezer to your...

16_ operating
USING THE ICE AND COLD 
WATER DISPENSER
Press the Ice Type button to select the type of ice 
you want
Ice is made in cubes. When you select 
“Crushed”, the icemaker grinds the ice cubes 
into crushed ice.
Dispensing ice 
Place your glass underneath the ice outlet and 
push gently against the ice dispenser lever with 
your glass. Make sure the glass is in line with the 
dispenser to prevent the ice from bouncing out.
Using the Water Dispenser
Place a glass underneath the water outlet and...

operating _17
02 OPERATING
USING THE COOLSELECT 
ZONE™ DRAWER (OPTIONAL)
Quick Cool 
• You can use the Quick Cool feature with the 
CoolSelect Zone™.
• “Quick Cool” allows 1~3 canned beverages to 
cool within 60 min.
• To cancel this function, press the “Quick Cool” 
button again. CoolSelect Zone™ returns to the 
previous temperature.
• When “Quick Cool” ends, it returns to the “Cool” 
temperature setting.
Thaw 
• Drips loss and quality deterioration of meats 
reduces the freshness of foods.
• After...

18_ operating
REMOVING THE FREEZER 
ACCESSORIES
Cleaning and rearranging the interior of the freezer 
is simple. 
1. Remove the Glass shelf by pulling the shelf out as 
far as it will go. Then, gently lift it up and remove 
it.
2. Remove the door bin by holding the door bin with 
both hands and then gently lift it up.
3. Remove the Plastic drawer by pulling it out and 
slightly lifting it up.
4. Remove the Icemaker bucket by lifting up and 
pulling it out.
Do not use excessive force when removing 
the...

operating _19
02 OPERATING
Before removing any accessories, make sure 
that no food is in the way.
When possible, remove the food altogether 
to reduce the risk of accidents.
To get the best energy effi ciency of this 
product, please leave all selves, drawers 
and baskets on their original position like as 
illustration in page (17).
CLEANING THE REFRIGERATOR
Do not use benzene, thinner, or Clorox, 
Chloride for cleaning.
They may damage the surface of the 
appliance and may cause a fi re.
Do not spray...

20_ operating
6. Once you have completed this process, hold the 
Ice Type button for 3 seconds to reset the fi lter 
schedule.
7. Lastly, Dispense 1L of water through water 
dispenser and throw away. Make sure that water 
fl ows clearly again before drinking.
A newly installed water fi lter cartridge may 
cause water to briefl y spurt from the water 
dispenser. This is due to air getting into the 
line. It should pose no problem to operation.
Ordering replacement fi lters
To order more water fi lter...