Samsung Rs 21 Dlmr Owners Manual

21
INSTALLATION INSTRUCTIONS
REMOVING THE REFRIGERATOR DOORS
1) With the door closed, remove the upper hinge cover (➀) using a screwdriver, and then discon-nect  
the wires (➁).
2) Remove hinge screws (➂) and ground screw (➃) counter-clockwise, and take off the upper  hinge (➄) in the    
direction of the arrow (➅). Take care when removing the door to ensure that it does not fall on you.
3) Remove the door from the lower hinge (	) by
lifting the door (
➇).4) Remove the lower hinge (➈) from the bracket...

22
REATTACHING THE REFRIGERATOR DOORS
Reattaching the Freezer Door
1) Insert the lower hinge (➀) in the bracket
lower hinge (➁).2) Reattach the freezer door by inserting the
hose (➂) in the lower side of the door into
the hole in the lower hinge (➃) and pulling
the hose down.  
3) Insert the upper hinge shaft (➄) into the hole (➅). After levelling  the upper hinge hole
(➆) with the hole of the cabinet (
➇). Fasten bolts (➈) and screw (➉) in a clockwise direction.
4) Connect the wires.  5) Put the front...

23
INSTALLATION INSTRUCTIONS
REATTACHING THE REFRIGERATOR DOORS
Reattaching the Refrigerator Door
1) Insert the lower hinge (➀) in the bracket
lower hinge (➁).2) Place the hole in the refrigerator door (➂)
over the lower hinge (➃).
3) Insert the upper hinge shaft (➄) into the hole (➅). After levelling  the upper hinge hole (➆)
with the hole of the cabinet (
➇). Fasten  hinge screws (➈) and screw (➉) in the clockwise direc-tion.
4) Connect the wires.  5) Put the front part of the upper hinge cover (    )...

24
REATTACHING THE REFRIGERATOR DOORS
FRONT LEG COVER
SCREW
1) While pressing the front face of coupler (➁), insert the water line (➀) in the coupler.
2) Tighten the screw on the clamp (   ).  a
Put on the front leg cover by turning the three screws clockwise, as shown in the figure.
Reattaching the Water Tube (Optional)
Reattaching the Front Leg Cover (Optional)
DA99-00494B  4/7/03 2:29 PM  Page 24
 

25
INSTALLATION INSTRUCTIONS
ADJUSTING THE CLEARANCE BETWEEN THE DOORS
The doors will be uneven if the refrigerator is not level.
Case 1) Freezer door is lower than
that of the refrigeratorInsert a straight screwdriver (-) () into a
slot of the control lever (➁), turn it clockwise
and level the refrigerator.
Case 2) Freezer door is higher than
that of the refrigeratorInsert a straight screwdriver (-) () into a
slot of the control lever (➁), turn it clockwise 
and level the refrigerator.
Do not make...

26
ADJUST THE CLEARANCE BETWEEN THE DOORS
Making small adjustments between doors.
If the door of the freezer is lower than that of
the refrigerator.If the door of freezer is higher than that of the
refrigerator.
3) After adjusting the doors, turn the nut () turn clockwise(                ) until the lower end of the bolt, then tighten
the bolt again with the wrench (➂) to fix the nut().
If you do not fix the nut () firmly, the bolt (➁) may be released.
2) Please adjust the height difference between...

27
INSTALLATION INSTRUCTIONS
CHECKING THE WATER DISPENSER LINE (OPTIONAL)
Checking the Parts
NOTE
A universal water supply kit is available at extra cost from your dealer. The refrigerator manufacturer
recommends using a water supply kit containing copper tubing. 1) In order to operate the ice maker properly, water pressure of 1.4 ~ 10 kgf/cm
2 is required.
In this range a 100 cc paper cup can be filled in 10 seconds.
2) The water filter removes particles. It does not sterilize or destroy any...

28
INSTALLING OF THE WATER DISPENSER LINE
WARRANTY INFORMATION
This water line installation is not covered by the refriger-ator
or ice maker manufacturers warranty.
Follow these instructions carefully to minimise the risk of
expensive water damage.
Note:
If the coupler does not fit on the current tap, go
the nearest authorised service dealer and purchase
the right couplers fittings.
Connecting to water supply line
- Shut off the main water supply line and turn the Ice 
maker to the off position.
- Locate...

29
INSTALLATION INSTRUCTIONS
INSTALLING THE WATER DISPENSER LINE
- Remove the compressor cover of the refrigerator.
- Connect the water line to the valve, as shown in the figure.
- When connected, check if there is any leakage.
If any, repeat the connection.
- Reattach the compressor cover of the refrigerator.
- Using clip ”A”, fix the water line to the wall (the back of refrigerator).
- When the water line is secure, make sure whether the
water line is not excessively bent, pinched or squashed.
Complete...

30
INSTALLING THE WATER DISPENSER LINE
Remove any residual matter inside the purifier. (Model with the purifier)
- Open the main water tap to check whether water
is running through the water tube on the water
inlet side of the purifier.
- If water does not come out through the line,
check whether the tap is open.
- Leave the tap open until clean water is running
out and any residual matter that built up during
manufacturing has been removed. - If you wish to reassemble the water inlet
and outlet sides of...