Samsung Le 32t51b Owners Instructions

							English-19
Setting the PC
Coarse and Fine Tuning of the Image (Image Lock):
The purpose of picture quality adjustment is to remove or reduce picture\
noise. If the noise is not removed by Fine-tuning alone, then adjust the\
 
frequency as best as possible (coarse) and Fine-tune again. After the noise
has been reduced, re-adjust the picture so that it is aligned on the cen\
ter of
screen.
1.Preset: Press the PC button to select PC mode.
2.Press the MENU button to display the menu. 
Press the or button to select “Setup”, 
then press the ENTERbutton.
3.Press the or button to select “PC”, then 
press the ENTERbutton.
4.Press the ENTERbutton to select “Image Lock”.
5.Press the or button to select “Coarse” or “Fine”, 
then press the ENTERbutton. 
6.Press the 
or button to adjust the screen quality. 
Press the ENTERbutton.
7.Press the EXITbutton to exit.
Changing the Image Position (Position):
Adjust the PC’s screen positioning if it does not fit the TV screen.
1.Follow the “Coarse and Fine Tuning of the Image (Image Lock)”  
instructions number 1 to 3.
2.Press the or button to select “Position”, 
then press theENTERbutton.
3.Press the or button to adjusting the Vertical-Position. 
Press the 
or button to adjust the Horizontal-Position. 
Press theENTERbutton.
4.Press the EXIT button to exit.
Initializing the Image Settings (Image Reset):
Y ou can replace all image settings with the factory default values.
1.Follow the “Coarse and Fine Tuning of the Image (Image Lock)”  
instructions number 1 to 3.
2.Press the or button to select “Image Reset”, 
then press theENTERbutton.
3.Press the EXIT button to exit.
Adjusting the PC Screen Automatically (Auto Adjustment):
Auto adjustment allows the PC screen of set to self-adjust to the 
incoming PC video signal. The values of fine, coarse and position are
adjusted automatically.
1.Follow the “Coarse and Fine Tuning of the Image (Image Lock)”  
instructions number 1 to 3.
2.Press the or button to select “Auto Adjustment”, 
then press theENTERbutton.
3.Press the EXIT button to exit.
Press the PC button on the
remote control to select the
PC mode.
 
						

							English-20
Technical and Environmental Specifications 
RECOMMENDATIONS FOR USE
No sound or picture
Normal picture but no sound
No picture or black and white picture
Sound and picture interference
Blurred or snowy picture, 
distorted sound
Remote control malfunctions
“Check signal cable.” 
message is displayed.
On PC mode, “Not Supported Mode.”
message is displayed.
The TFT LCD panel uses a panel consisting of sub pixels (3,133,440) which requ\
ire sophisticated technology to produce. 
However, there may be few bright or dark pixels on the screen. These pixels will have no impact on the performance of the produ ct.

Check that the mains lead has been connected to a wall socket.
Check that you have pressed the POWERbuttons on the front of the set.
Check the picture contrast and brightness settings.
Check the volume.

Check the volume.
Check whether the MUTEbutton has been pressed on the remote control.

Adjust the colour settings.
Check that the broadcast system selected is correct.

Try to identify the electrical appliance that is affecting the set and move it further away.
Plug your set into a different mains socket.

Check the direction, location and connections of your aerial.  
This interference is often due to the use of an indoor aerial.

Replace the remote control batteries.  
Clean the upper edge of the remote control (transmission window).
Check the battery terminals.

Check that the signal cable is firmly connected to the PC or video sourc\
es.       
Check that the PC or video sources are turned on.

Check the maximum resolution and the frequency of the video adaptor.
Compare these values with the data in the Display Modes. 
T roubleshooting: Before Contacting Service Personnel
Model Name
Panel
Size
Display Size
Pixel Pitch
FrequencyHorizontal / Vertical
PC Resolution(Optimum)
Power Supply (Input)
Power ConsumptionNormal / Power Saving
Dimension (WxDxH)Body
With stand
Wei ghtWith stand
Environmental ConsiderationsOperating Temperature
Operating Humidity
Storage Temperature
Storage Humidity
SoundOutput
LE23T5
23” Diagonal (16:9)508.125 (H) x 285.696 (V) mm
0.372 (H) x 0.372 (V) mm
30~61 kHz / 60~75 Hz
1360 x 768 @ 60 Hz
AC 100 ~ 240 V, 60/50 Hz ±3 Hz
100 W / < 2.0 W
675.9 x 85.0 x 393.40 mm
675.9 x 203.8 x 439.5 mm 8.0 kg (17.64 lbs)
10 °C to 40 °C (50 °F to 104 °F)10 % to 80 %, non-condensing
-20 °C to 45 °C (-4 °F to 113 °F) 5 % to 95 %, non-condensing
3 W X 2
LE27T5
27” Diagonal (16:9)603.22 (H) x 341.98 (V) mm
0.1460 (H) x 0.4365 (V) mm
30~61 kHz / 60~75 Hz
1360 x 768 @ 60 Hz
AC 100 ~ 240 V, 60/50 Hz ±3 Hz
140 W / < 2.0 W
766.5 x 96.0 x 459.0 mm
766.5 x 203.8 x 505.5 mm
12.0 kg (26.46 lbs)
10 °C to 40 °C (50 °F to 104 °F)10 % to 80 %, non-condensing
-20 °C to 45 °C (-4 °F to 113 °F) 5 % to 95 %, non-condensing
5 W X 2
LE32T5
32” Diagonal (16:9)697.68 (H) x 392.26 (V) mm
0.51075 (H) x 0.51075 (V) mm
30~61 kHz / 60~75 Hz
1360 x 768 @ 60 Hz
AC 100 ~ 240 V, 60/50 Hz ±3 Hz
170 W / < 2.0 W
914.5 x 104.0 x 528.8 mm
914.5 x 247.5 x 591.5 mm 15.0 kg (33.07 lbs)
10 °C to 40 °C (50 °F to 104 °F)10 % to 80 %, non-condensing
-20 °C to 45 °C (-4 °F to 113 °F) 5 % to 95 %, non-condensing
7.5 W X 2
 
						

							• The slots and openings in the cabinet and in the back or bottom are prov\
ided for necessary ventilation. To  ensure reliable operation of this apparatus, and to protect it from over\
heating, these slots and openings must never be
blocked or covered.
- Do not cover the slots and openings with a cloth or other materials.
- Do not block the slots and openings by placing this apparatus on a bed, \
sofa, rug or other similar surface.
- Do not place this apparatus in a confined space, such as a bookcase, or \
built-in cabinet, unless proper ventilation 
is provided.
• Do not place this apparatus near or over a radiator or heat registe\
r, or where it is exposed to direct sunlight.
• Do not place sources of heat on this apparatus, such as a candles, \
ash trays, incense or other similar items.
• Do not place a water containing vessel on this apparatus, as this c\
an result in a risk of fire  or electric shock.
• Do not expose this apparatus to rain or place it near water(near a bath\
tub, washbowl, kitchen sink, or laundry tub,  in a wet basement, or near a swimming pool etc.).
If this appratus accidentally gets wet, unplug it and contact an authori\
zed dealer immediately.
Y ou can clean this apparatus with damp cloth when necessary, but be sure to unplug the apparatus first.
• Do not expose this apparatus to extreme temperature conditions or t\
o extreme humidity conditions.
• This appratus use batteries. In your community there might be regulation\
s that require you to dispose of these batteries properly under environmental considerations. Please contact your local a\
uthorities for disposal or recycling information.
• To cut off the power source, unplug this apparatus from the wall outlet.
• Do not overload wall outlets, extension cords or adaptors beyond their c\
apacity, since this can result in fire or electric shock.
• Power-supply cords should be routed so that they are not likely to be walked \
on or pinched by items placed upon or against them, paying particular attention to cords at plug end, adaptors\
 and the point where they exit from the appliance.
• To protect this apparatus from a lightning storm, or when it is left unat\
tended and unused for long periods of time, unplug it from the wall outlet and disconnect the antenna or cable system.
This will prevent damage to the set due to lightning and power line surges.
• Before connecting the AC power cord to the DC adaptor outlet, make sure the voltage designatio\
n of the DC adaptor corrsponds to the local electrical supply.
• Never insert anything metallic into the open parts of this apparatu\
s. Doing so many create a danger of electric shock.
• To avoid electric shock, never touch the inside of this apparatus. Only a\
 qualified technician should open this apparatus.
• Be sure to hold the plug, not the cord, when disconnecting this app\
aratus from an electric socket.
• Locate this apparatus near an easily acessible AC outlet.
• If this appratus does not operate normally - in particular, if there are any unusual sounds or smells coming from it - unplug it immediately and contact an authorized dealer or service center\
.
• Unplug this apparatus from the AC outlet before any service.
• Be sure to pull the power plug out of the outlet if the TV is to remain unused or if you are to leave the house for an extended period of time (especially when children, elderly or disabled \
people will be left alone in the house).  
-A ccumulated dust can cause an electric shock, an electric leakage or a fi\
re by causing the power cord to generate 
sparks and heat or the insulation to deteriorate.
• Be sure to contact an authorized service center, when installing your set in a location with heavy dust, high or low  temperatures, high humidity, chemical substances and where it operates for 24 hours such as the air\
port, the train station
etc. Failure to do so may cause serious damage to your set.
Please read the appropriate section that corresponds to the marking on y\
our Samsung product before
attempting to install the product.
W
arning! Important Safety Instructions
CAUTION
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, 
DO NOT REMOVE COVER (OR BACK). THERE ARE NO
USER SERVICEABLE PARTS INSIDE. REFER ALL SERVICING
TO  QUALIFIED PERSONNEL.
This symbol indicates that high voltage is 
present inside.
It is dangerous to make any kind of contact 
with any internal part of this product.
This symbol alerts you that important 
literature concerning operation and maintenance
has been included with this product.
RISK OF ELECTRIC SHOCK DO NOT OPEN
 
						

							IMPORTANT NOTICE
The mains lead on this equipment is supplied with a moulded plug incorpo\
rating a fuse. The value of the fuse is
indicated on the pin face of the plug and, if it requires replacing, a f\
use approved to BSI1362 of the same rating
must be used. Never use the plug with the fuse cover omitted if the cove\
r is detachable. If a replacement fuse
cover is required, it must be of the same colour as the pin face of the \
plug. Replacement covers are available
from your dealer. If the fitted plug is not suitable for the power points in your house \
or the cable is not long
enough to reach a power point, you should obtain a suitable safety appro\
ved extension lead or consult your
dealer for assistance. However, if there is no alternative but to cut off the plug, remove the fuse and then safely
dispose of the plug. Do NOT connect the plug to a mains socket as there is a risk of shock hazard fr\
om the
bared flexible cord.
IMPORTANT
The wires in the mains lead are coloured in accordance with the followin\
g code:
BLUE - NEUTRAL BROWN - LIVE
As these colours may not correspond to the coloured markings identifying\
 the terminals in your plug, proceed as
follows: The wire coloured BLUE must be connected to the terminal marked with the\
 letter N or coloured BLUE
or BLACK. The wire coloured BROWN must be connected to the terminal marked with th\
e letter L or coloured
BROWN or RED.
WARNING:
DO NOT CONNECT EITHER WIRE TO THE EARTH TERMINAL, WHICH IS MARKED WITH THE
LETTER E OR BY THE EARTH SYMBOL , OR COLOURED GREEN OR GREEN AND YELLOW.
W iring the Mains Power Supply Plug(UK Only)
UNITED KINGDOM
This Samsung product is warranted for a period of twelve (12) months f\
rom the original date of purchase,
against defective materials and workmanship. In the event that warranty \
service is required, you should return
the product to the retailer from whom it was purchased. However, Samsung Authorised Dealers and Authorised
Service Centres in other EC Countries will comply with the warranty on t\
he terms issued to purchasers in the
country concerned. In case of difficulty, details of our Authorised Service Centres are available from:
Samsung Electronics (U.K.) Ltd.,
Unit C, Customer Care Centre, Stafford Park 12, TELFORD, Shropshire TF3 3BJ,
T el: 0870) 242 0303, Fax: 01952) 297617
W ARRANTY CONDITIONS
1. The warranty is only valid if, when warranty service is required, the wa\
rranty card is fully and properly completed and is presented with the original invoice or sales slip or co\
nfirmation, and the serial number on 
the product has not been defaced.
2. Samsung’s obligations are limited to the repair or, at its discretion, replacement of the product or the  defective part.
3. Warranty repairs must be carried out by Authorised Samsung Dealers or Authorised Service Centres.  No re-imbursement will be made for repairs carried out by non Samsung De\
alers and, any such repair work 
and damage to the products caused by such repair work will not be covere\
d by this warranty.
4. This product is not considered to be defective in materials nor workmans\
hip by reason that it requires  adaptation in order to conform to national or local technical or safety \
standards in force in any Country other 
than the one for which the product was originally designed and manufactu\
red.
Warranty Card
 
						

							MEMO
 
						

							MEMO