Samsung Ht X715t User Manual

1
E N G

●  CONNECTIONS

Place the wireless receiver module at the rear of the listening 
position. If the wireless receiver module is too close to the main unit, 
some sound interruption may be heard due to interference.
If you use a device such as a microwave oven, wireless LAN Card, 
Bluetooth equipment, or any other device that uses the same frequency 
(5.8GHz) near the system, some sound interruption may be heard due to 
interference.
The transmission distance of a radio wave is about 10m, but...



connections

CONNECTING THE VIDEO OUT TO YOUr TV
Choose one of the three methods for connecting to a TV.
METHOD3(supplied)METHOD2METHOD1(supplied)s
METHOD 1 : HDMI
Connect a HDMI cable (not supplied) from the HDMI OUT jack on the back of the DVD Player to the 
HDMI IN jack on your TV.
METHOD 2 : Component Video
If your television is equipped with Component Video inputs, connect a Component video cable(not 
supplied) from the Component Video Output (PR, PB and Y) jacks on the back of the DVD...


EN G

●  CONNECTIONS

HDMI Auto Detection Function
The player's video output will automatically change to HDMI mode when connecting an HDMI cable 
while power is on.
HDMI (High Definition Multimedia Interface)
HDMI is an interface that enables the digital transmission of video and audio data with just a single 
connector. 
Using HDMI, the DVD Home Cinema transmits a digital video and audio signals and displays a vivid 
picture.
HDMI connection description
HDMI connector - Supports video...

4

connections

HDMI FUNCTION
resolution Selection
This function allows the user to select the screen resolution for 
HDMI output.
In Stop mode, press and hold the SD/HD (Standard Defi nition/High 
Defi nition) button on the remote control for longer than 5 seconds.
Resolutions available for the HDMI output are 576p(480p), 
720p, 1080i/1080p.
SD(Standard Defi nition) resolution is 576P(480p) and HD
(High Defi nition) resolution is 720p, 1080i/1080p.
The default value of HDMI output is 576P(480P)....


EN G

●  CONNECTIONS

CONNECTING  A UDIO   F r OM  E XTE r NAL  C OMPONENTS
AUX1 : Connecting an External Component/MP3 player
Components such as an MP3 Player
Audio Cable(not supplied)
Audio OUT
Connect AUX IN 1 (Audio) on the Home Cinema to the Audio Out of the external component/MP3 
player.
Press the AUX button on the remote control to select AUX1 input.
You can also use the FUNCTION button on the main unit. 
The mode switches as follows :  
DVD/CD  DIGITAL IN  AUX 1  AUX 2  USB  BT...



connections

AUX2 : Connecting an External Analog Component
Analog signal components such as a VCR.
Connect AUX IN 2 (Audio) on the Home Cinema to the Audio Out of the external analog component.
Be sure to match connector colors.
Press the AUX button on the remote control to select AUX 2 input. 
You can also use the FUNCTION button on the main unit.
The mode switches as follows : 
DVD/CD  DIGITAL IN  AUX 1  AUX 2  USB  BT AUDIO  TUNEr.
  You can connect the Video Output jack of your...


ENG

●  CONNECTIONS

CONNECTING THE FM ANTENNA
Connect the FM antenna supplied to the FM 75Ω COAXIAL Jack.
Slowly move the antenna wire around until you fi nd a location where reception is good, then fasten it 
to a wall or other rigid surface.
  This unit does not receive AM broadcasts.
Cooling Fan
The cooling fan supplies cool air to the unit to  prevent overheating.
Please observe the following cautions for your safety.
Make sure the unit is well-ventilated. If the unit has poor...



before using your home cinema
The DVD Home Cinema's remote can be used to control Samsung TVs.
Plug the main unit's power cord into the AC power supply.
Press the DVD rECEIVEr button to switch to DVD 
RECEIVER mode to operate the DVD Home Cinema.
Press the FUNCTION button on the main unit or DVD 
button on the remote to enable DVD/CD playback.
Press the TV button to set the remote to TV mode.
Press the POWEr button to turn on your Samsung TV with 
this remote. 
Press the TV/VIDEO...


ENG

●  PLAYBACK
playback
DISC PLAYBACK
 B
Load a disc vertically into the Disc Insert Hole.
Place a disc gently into the tray with the disc’s label facing 
up.
Close the compartment by pressing the PLAY () button.
Playback starts automatically.
To stop playback, press the STOP (@) button during playback.
If pressed once, PrESS PLAY is displayed and the stop position will be stored in memory. 
If the PLAY () button or ENTEr button is pressed, playback resumes from the stop position. 
(This...

0

playback

MP3/WMA-CD PLAYBACK
Data CDs (CD-R, CD-RW) encoded in MP3/WMA format can be played.
A
Load the MP3/WMA disc.
The MP3/WMA menu screen will appear and 
playback will start.
The appearance of the menu depends on the 
MP3/WMA disc.
WMA-DRM fi les cannot be played.
In Stop mode, use the Cursor $, %, _, + button 
to select the album, and then press the ENTEr button.
Use the Cursor $, % button to select the track.
To change the album, use the Cursor $, %, _, + button to 
select another album...