Samsung Ht Db390 Instruction Manual

Audio Cable
(AH39-40001U) Video Cable
(AH39-40001V) Remote Control 
(AH59-01269C)
FM Antenna 
(AH42-00004A)
Auto Sound Calibration Microphone
(AH59-01183D)AM Antenna
(AH42-20001P)
Users Manual 
(AH68-01445R)
Accessories 
PREPARATION
—Rear Panel—
FM Antenna
Connector Speaker Output
Terminals 
* The wireless receiving antenna is built into the wireless rear amplifier.
Video Output Connector
Connect the TVs video input jacks 
(VIDEO IN) to the VIDEO OUT connector.
AM Antenna
Connector  COMPONENT VIDEO...

11
Description
PL II MODE button
TUNING/CH button
MENU button TV, DVD POWER button
OPEN/CLOSE button
SUPER 5.1 button
Live Surround Mode button/
Virtual Headphone button Auto Sound Calibration button
RETURN button
Number(0~9) buttons 
SLEEP button
EZ VIEW button LOGO COPY buttonTV indicator 
DVD RECEIVER indicator 
TV/VIDEO, DIMMER buttonMODE button
Direction/Enter button 
REPEAT button WIRELESS button CANCEL button ZOOM button TUNER MEMORY, P.SCAN button SOUND EDIT button TEST TONE button MUTE button...

To open the remote control cover, push the
top of the cover, then slide downward.
12
Insert Remote Batteries
The remote control can be used up to approximately 23
feet/7 meters in a straight line. It can also be operated at
a horizontal angle of up to 30°from the remote control
sensor.
Range of Operation of the Remote Control 
Remove the battery
cover on the back of
the remote by
pressing down and
sliding the cover in
the direction of the
arrow.1Insert two 1.5V AAA
batteries, paying
attention to the...

Rear Speakers
•Place these speakers behind your listening position.
•If there isnt enough room, place these speakers to face each other.
•Place them about 60 to 90cm (2 to 3 feet) above your ear, facing
slightly downward.
*Unlike the front and center speakers, the rear speakers are used
to handle mainly sound effects and sound will not come from
them all the time.
Subwoofer
•The position of the subwoofer is not so critical. 
Place it anywhere you like.
•Usually, it is placed by a corner near the front...

•Make sure the colors of the speaker terminals
match the colors of the connecting plugs.•Insert the black wire into the black
(–) terminal and the gray wire into
the gray (+) terminal.
•Make sure the polarities (+ and –)
are correct.
Black
Press down the terminal
tab on the back of the
speaker. 1Insert the wire into the
terminal and release the
terminal tab. 2Connect the connecting plugs to
the back of the DVD player.3
Gray
14
Back of the SpeakersBack of the Main Unit
CONNECTIONS
Wireless Rear
Speaker...

Connect your pair of
wireless rear speakers,
(L) and (R), to the
wireless rear amplifier.1Insert the power plug into an outlet,
and then press the POWERbutton 
on the front panel.
•The Power Standby indicator will light up.
•To turn off the wireless rear amplifier, 
press the POWERbutton in Standby mode.
2•Do not connect the wireless rear speakers
to the speaker outputs on the back of the
main unit. Malfunction may result.
•The wireless receiving antenna is built into
the wireless rear amplifier. 
Keep...

•Sound will be heard from the wireless rear speakers in
DVD 5.1-CH or Dolby Pro Logic II mode only.
•In 2-CH mode, no sound will be heard from the wireless
rear speakers.
Reset the system if a communication failure occurs, or if the synchronizing signal indicator does not light up and the
REAR CHK message blinks on the main units display.  
Reset the system while the main unit and the wireless rear amplifier (SWA-1000) are in Power Standby mode.
Resetting Wireless Communication
With the main unit turned...

17
Connecting the Video Out to TV
Composite Video (Good Quality)
Connect the supplied video cable from the VIDEO OUT jack on the back panel of the
system to the VIDEO IN jack on your television.
S-Video (Better Quality)
If you television is equipped with an S-Video input, connect an S-Video cable (not supplied)
from the S-VIDEO OUT jack on the back panel of the system to the S-VIDEO IN jack on
your television.
Component Video (Best Quality)
If your television is equipped with Component Video inputs,...

18
CONNECTIONS
P.SCAN(Progressive Scan) Function
Unlike regular Interlace Scan, in which two fields of picture information alternate to create the
entire picture (odd scan lines, then even scan lines), Progressive Scan uses one field of
information (all lines displayed in one pass) to create a clear and detailed picture without visible
scan lines. 
While the player is in the Stop mode, hold the P.SCAN button down for longer
than 5 seconds.
•The selection switches back and forth between P.SCAN and I.SCAN...

19
Press AUXon the remote control to select ‘DIGITAL IN’.
•Each time the button is pressed, the selection changes as follows: DIGITAL IN ➝ AUX 1 ➝ AUX 2.
•You can also use the FUNCTIONbutton on the main unit.
The mode switches as follows: DVD/CD ➝ DIGITAL IN ➝ AUX1 ➝ AUX2 ➝ FM ➝ AM.
Connecting External Components
Connect Video Out on the DVD player to Video In on the TV.1
Connect the Digital Input (OPTICAL) to the Digital Output on the external
digital component.2
3
Example: Digital signal components...